RESUMO
PURPOSE: To evaluate the effect of different printing orientations and post-polymerization time with thermal cycling on the translucency of 3D-printed denture base resins. METHODS: Heat-polymerized (HP) acrylic resin specimens were fabricated and 3D-printed denture base materials (NextDent, ASIGA, FormLabs) were printed with different printing orientations (0, 45, 90 degrees) and subjected to different post-polymerization times (15-, 30-, 60-, and 90-min). All specimens were polished and immersed in distilled water for 1 day at 37°C. CIEDE2000 was used to measure the translucency parameters (TP00) before and after thermal cycling (5000 cycles) recording the color parameters (L*, a*, b*) against a black and white background using a spectrophotometer. k-factors ANOVA followed by post hoc Tukey's test (α = .05) was performed for statistical analysis. RESULTS: The k-factors ANOVA test showed a significant effect of resin material, post-polymerization time, and printing orientation on translucency (p < 0.001). In comparison to HP, all 3D-printed resins showed lower translucency with all post-polymerization times and printing orientation (p < 0.001) except FormLabs resin (p > 0.05). For all 3D-printed resins, the translucency increased, with increasing the post-polymerization time (p < 0.001) and 60- and 90-min showed the highest translucency. For printing orientation, 90 and 45 degrees significantly showed high translucency in comparison to 0 degrees (p < 0.001). FormLabs showed significantly higher translucency when compared with NextDent and ASIGA per respective printing orientation and post-polymerization time. The translucency significantly decreased after thermal cycling for all tested resins (p < 0.001). CONCLUSION: The findings of this study demonstrated that the translucency of 3D-printed resins is influenced by the printing orientation, post-polymerization time, and resin type. As a result, choosing a resin type, and printing orientation, with a longer post-polymerization time should be considered since it may improve the esthetic appearance of the 3D-printed resins.
RESUMO
Background: Dental post and core is one of the common procedures performed after endodontic treatment. The aim of this study was to radiographically assess the quality of post and core procedures performed by dental students at different education levels in addition to determining the most critical errors encountered during their clinical practice. Methods: A retrospective cross-sectional study design was conducted in the College of Dentistry, Imam Abdulrahman Bin Faisal University. A total of 550 periapical radiographs (PAs) of cemented posts were retrieved from the records of patients treated by dental students. Parameters and guidelines for assessing the quality of post treatment have been determined and statistically analyzed. A P value <0.05 was considered statistically significant. Results: The study included 502 students and most of them were females (66.5%). Data were obtained from 502 patients (62% females) with fiber posts used in 98.2% of the cases. About 50% of the posts were inserted in premolars, 62.9% in the upper arch, and 66.7% were restored with crowns as a final restoration. Regarding the quality of posts, 98.4% showed good preparation quality and 98% showed good radiographic quality. The post diameter was equal to 1/3 of the root diameter in 31.9% of the cases; post length was equal to 2/3 of root length in 5% of the cases and equal to or more than crown height in all cases (100%). Length of the remaining gutta percha (GP) was between 3-5 mm in 38.8%, and there was no gap between the post and remaining GP in 95.6% of the cases. There were no statistically significant differences between dental students at different clinical educational levels regarding the quality of post placement. Conclusions: The quality of post and core procedures performed by students showed acceptable radiographic quality and were within the recommended standards.
