Tablets Made from Paper-An Industrially Feasible Approach.

Many orally administrated drugs exhibit poor bioavailability due to their limited solubility. The smartFilm technology is an innovative approach to improve the drug aqueous solubility, where the drug is embedded within the matrix of cellulose-based paper in an amorphous state, hence increasing its solubility. Despite its proven effectiveness, smartFilms, i.e., pieces of paper, exhibit limited flowability and are not easy to swallow, and thus oral administration is not convenient. In addition, there is a lack of knowledge of their mechanical behavior under compression. This study aimed to transform unloaded smartFilms, i.e., paper, into a flowable physical form and investigated its mechanical behavior when compressed. Granules made of paper were prepared via wet granulation and were compressed into tablets. The influence of using different amounts and forms of sucrose, as a binder, on the pharmaceutical properties of the produced granules and tablets was studied and the most suitable composition was identified by using instrumented die experiments. For this, the Poisson's ratio and Young's modulus were determined for different compaction force levels and the deformation behavior was estimated with the Heckel mathematical model. All granule batches showed good flowability with angle of repose values between 25-35°. Granule batches with ≤30% dry sucrose content produced tablets that fulfilled the European Pharmacopeia requirements, and the compaction behavior of the granules was found to be comparable to the behavior of classical binders and compression enhancers. Paper can be transferred into granules. These granules can be used as suitable intermediate products for the production of tablets made of paper in large, industrial scale.

Renewable Beta-Elemene Based Cyclic Carbonates for the Preparation of Oligo(hydroxyurethane)s.

Conversion of ß-elemene into new ß-elemene dicarbonates through epoxidation and halide salt-catalyzed CO2 cycloaddition reactions is reported. Step-growth polyaddition of this dicarbonate to five different, commercial diamines was investigated under neat conditions at 150 °C yielding non-isocyanate-based low molecular weight oligo(hydroxyurethane)s with 1.3≤Mn ≤6.3 kDa and 1.3≤Ð≤2.1, and with glass transition temperatures ranging from -59 to 84 °C. The preparation of one selected polyhydroxyurethane material, obtained in the presence of Jeffamine® D-2010 was scaled-up to 43 g. The latter, when combined in a formulation using Irgacure® 2100 and Laromer® LR 9000 allowed the preparation of coatings that were analyzed with several techniques showing the potential of these biobased oligourethanes towards the preparation of commercially relevant materials.