Ultra-widely tunable long-period holey-fiber grating by the use of mechanical pressure.

We report an ultra-widely tunable long-period holey-fiber grating, which combines the wide-range single-mode behavior and transverse strain sensitivity of the holey fibers with the advantages of mechanically induced long-period fiber gratings. We obtain a versatile widely tunable long-period holey-fiber grating with attractive transmission spectral characteristics for optical communications, fiber-based amplifiers, and lasers. The mechanically induced long-period holey-fiber grating shows a continuous tuning range over 500 nm, more than 12 dB depth notches with less than 0.75 dB out-of-band losses, and bandwidth control from 10 to 40 nm.

Single-mode plane-polarized ytterbium-doped large-core fiber laser with 633-W continuous-wave output power.

We demonstrate a cladding-pumped single-mode plane-polarized ytterbium-doped fiber laser generating 633 W of continuous-wave output power at 1.1 microm with 67% slope efficiency and a polarization extinction ratio better than 16 dB. The laser is end pumped through both fiber ends and shows no evidence of roll-over, even at the highest output power, which is limited only by the available pump power.

Single-frequency, single-mode, plane-polarized ytterbium-doped fiber master oscillator power amplifier source with 264 W of output power.

We present a single-frequency, single-mode, plane-polarized ytterbium-doped all-fiber master oscillator power amplifier source at 1060 nm generating 264 W of continuous-wave output power. The final-stage amplifier operated with a high gain of 19 dB and a high conversion efficiency of 68%. There was no evidence of rollover from stimulated Brillouin scattering even at the highest output power, and the maximum output was limited only by the available pump power.

Wavelength tuning of fiber lasers using multimode interference effects.

We report on a novel scheme to fabricate a simple, cheap, and compact tunable fiber laser. The tuning is realized by splicing a piece of single-mode fiber to one end of an active double-clad fiber, while the other end of the single-mode fiber is spliced to a 15 mm long section of 105/125 multimode fiber. The fluorescence signal entering into the multimode fiber will be reproduced as single images at periodic intervals along the propagation direction of the fiber. The length of the multimode fiber is chosen to be slightly shorter than the first re-imaging point, such that the signal coming out from the single mode fiber is obtained in free space, where a broadband mirror retroreflects the fluorescence signal. Since the position of the re-imaging point is wavelength dependent, different wavelengths will be imaged at different positions. Therefore, wavelength tuning is easily obtained by adjusting the distance between the broadband mirror and the multimode fiber facet end. Using this principle, the tunable fiber laser revealed a tunability of 8 nm, ranging from 1088-1097 nm, and an output power of 500 mW. The simplicity of the setup makes this a very cost-effective tunable fiber laser.

High-energy, high-power ytterbium-doped Q-switched fiber laser.

We report on a Q -switched, cladding-pumped, ytterbium-doped large-mode-area fiber laser operating at 1090 nm that is capable of generating 2.3 mJ of output pulse energy at a 500-Hz repetition rate and more than 5 W of average output power at higher repetition rates in a high-brightness beam (M(2) = 3) . Using a similar fiber with a smaller core, we generated >0.5-mJ pulses in a diffraction-limited beam. Our results represent a threefold increase in pulse energy over previously published values for Q-switched fiber lasers and firmly establish fiber lasers as compact, multiwatt, multimillijoule pulse sources with large scope for both industrial and scientific applications.