Influence of chitosan properties and operating parameters on the flocculation efficiency and harvesting of microalgae (Scenedesmus sp.).

Physicochemical and structural characteristics of chitosan prepared from Deep-sea shrimp (DCs), including degree of deacetylation (DD), molecular weight (Mw), viscosity, crystallinity index (CrI) and surface morphology were compared with a commercial chitosan (CCs). The DCs had a higher DD of 81.33 ± 0.40 %, whereas the CCs had a lower DD of 74.62 ± 0.64 %. Additionally, the DCs exhibited a lower Mw of 192.47 ± 2.5 kDa and viscosity of 646.00 ± 4.00 cP compared to the CCs, which had a Mw of 202.44 ± 0.28 kDa and viscosity of 689.67 ± 5.91 cP. This study investigated the influence of chitosan properties, particularly DD and Mw on the harvesting of Scenedesmus sp. along with the chitosan dosage, pH of the culture medium, mixing speed and time. Under optimal operating conditions, the microalgae removal efficiency of the DCs reached a significantly higher level (94.71 ± 0.20 %) compared to that of CCs (88.25 ± 0.41 %). Chitosan with a higher DD and low Mw demonstrated superior flocculation efficiency. The results highlight the significance of DD and Mw of chitosan and its influence on the flocculation of microalgae, providing valuable insights for optimizing the harvesting process with the non-toxic and natural flocculent, chitosan.

A numerical procedure for understanding the self-absorption effects in laser induced breakdown spectroscopy.

Optical emission spectroscopic techniques, such as laser-induced breakdown spectroscopy (LIBS), require an optimal state of plasma for accurate quantitative elemental analysis. Three fundamental assumptions must be satisfied in order for analytical results to be accurate: local thermodynamic equilibrium (LTE), optically thin plasma, and stoichiometric ablation. But real-life plasma often fails to satisfy these conditions, especially the optical thinness of plasma, resulting in the reabsorption of emitted radiation called self-absorption. To study the self-absorption effect, we simulated optically thick emission spectrum at typical laser-produced plasma conditions. The simulation of the spectrum involves four stages, including the estimation of the ratio of the number density of various ionisation states in the plasma using the Saha-Boltzmann equation, the peak intensity of a spectral line using the Boltzmann equation, the full-width half maxima of each spectral line using the Stark broadening method, and the generation of full spectra by providing a Lorentzian profile for each spectral line. Then self-absorption is applied to the simulated spectrum. We investigated the dependence of the self-absorption coefficient on the plasma temperature, optical path length, and element concentration in the sample. Self-absorption decreases with increased plasma temperature, whereas it increases with increasing optical path length and analyte concentration. We also investigated the role of self-absorption in quantitative analysis by calibration-free LIBS with and without resonance lines of the binary alloy (Mg 50% & Ca 50%). We observed a drastic reduction in error from 27% to 2% in the composition estimation when excluding resonance lines.

Laser ablation of silicon induced by a femtosecond optical vortex beam.

We investigate laser ablation of crystalline silicon induced by a femtosecond optical vortex beam, addressing how beam properties can be obtained by analyzing the ablation crater. The morphology of the surface structures formed in the annular crater surface allows direct visualization of the beam polarization, while analysis of the crater size provides beam spot parameters. We also determine the diverse threshold fluences for the formation of various complex microstructures generated within the annular laser spot on the silicon sample. Our analysis indicates an incubation behavior of the threshold fluence as a function of the number of laser pulses, independent of the optical vortex polarization, in weak focusing conditions.