Comparative Analysis of Growth and Physiological Responses of Sugarcane Elite Genotypes to Water Stress and Sandy Loam Soils.

Stumpy irrigation water availability is extremely important for sugarcane production in Pakistan today. This issue is rising inversely to river flow due to inadequate water distribution and an uneven rainfall pattern. Sugarcane growth faces a shortage of available water for plant uptake due to the low water-holding capacity of sandy loam soil, particularly under conventional flood irrigation methods. To address this problem, sugarcane clones were evaluated for their agronomic and physiological traits under conditions of low water availability in sandy loam soil. Ten cane genotypes, HSF-240, SPF-213, CPF-249, CP 77-400, S2008-FD-19, S2006-US-469, S2007-AUS-384, S2003-US-633, S2003-US-127, and S2006-US-658, were exposed to four levels of water deficit created through skip irrigations. These deficit levels occurred during the 9th, 11th, 13th, and 16th irrigations at alternate deficit levels between 2020 and 2022. Physiological data were collected during the tillering and grand growth stages (elongation) in response to the water deficit. The sugarcane clones S2006-US-658, S2007-AUS-384, and HSF-240 exhibited resistance to low water availability at both the tillering and grand growth stages. Following them, genotypes S2006-US-658, S2007-AUS-384, and HSF-240 performed better and were also found to be statistically significant. Clones susceptible to water deficit in terms of growth and development were identified as CP 77-400, S2008-FD-19, S2006-US-469, and S2003-US-633. These genotypes showed reduced photosynthetic rate, transpiration rate, stomatal conductance, relative water content, cane yield, and proline content under stressed conditions. Therefore, genotypes S2006-US-658, S2007-AUS-384, and HSF-240 were better performers concerning physiological traits under water deficit and sandy loam soil in both years. Moreover, a significant positive correlation was assessed between agronomic traits and photosynthetic rats. This study highlights that sugarcane can sustain its growth and development even with less irrigation frequency or moisture availability, albeit with certain specific variations.

Foliar application of silicon-based nanoparticles improve the adaptability of maize (Zea mays L.) in cadmium contaminated soils.

Heavy metals (HMs) especially cadmium (Cd) absorbed by the roots of crop plants like maize have emerged as one of the most serious threats by causing stunted plant growth along with disturbing the photosynthetic machinery and nutrient homeostasis process. A trial was conducted for inducing Cd stress tolerance in maize by exogenous application of silicon nanoparticles (SiNPs) using five doses of SiNPs (0, 100, 200, 300, and 400 ppm) and three levels of Cd (0, 15, and 30 ppm) for maize hybrid (SF-9515). The response variables included morphological traits and biochemical parameters of maize. The results indicated that Cd level of 30 ppm remained the most drastic for maize plants by recording the minimum traits such as shoot length (39.35 cm), shoot fresh weight (9.52 g) and shoot dry weight (3.20 g), leaf pigments such as chlorophyll a (0.55 mg/g FW), chlorophyll b (0.27 mg/g FW), total contents (0.84 mg/g FW), and carotenoid contents (0.19 µg/g FW). Additionally, the same Cd level disrupted biochemical traits such as TSP (4.85 mg/g FW), TP (252.94 nmol/g FW), TSAA (18.92 µmol g-1 FW), TSS (0.85 mg/g FW), and antioxidant activities such as POD (99.39 min-1 g-1 FW), CAT (81.58 min-1 g-1 FW), APX (2.04 min-1 g-1 FW), and SOD (172.79 min-1 g-1 FW). However, a higher level of Cd resulted in greater root length (87.63 cm), root fresh weight (16.43 g), and root dry weight (6.14 g) along with higher Cd concentration in the root (2.52 µg/g-1) and shoot (0.48 µg/g-1). The silicon nanoparticles (Si NPs) treatment significantly increased all measured attributes of maize. The highest value was noted of all the parameters such as chlorophyll a (0.91 mg/g FW), chlorophyll b (0.57 mg/g FW), total chlorophyll contents (1.48 mg/g FW), total carotenoid contents (0.40 µg/g FW), TSP (6.12 mg/g FW), TP (384.56 nmol/g FW), TSAA (24.64 µmol g-1 FW), TSS (1.87 mg/g FW), POD (166.10 min-1 g-1 FW), CAT (149.54 min-1 g-1 FW), APX (3.49 min-1 g-1 FW), and SOD (225.57 min-1 g-1 FW). Based on recorded findings, it might be inferred that higher levels of Cd tend to drastically reduce morpho-physiological traits of maize and foliage-applied silver nanoparticles hold the potential to ameliorate the adverse effect of Cd stress on maize.

Effect of the Application Date of Fertilizer Containing Silicon and Potassium on the Yield and Technological Quality of Sugar Beet Roots.

Water shortage and drought are a growing problem in Europe. Therefore, effective methods for limiting its effects are necessary. At the same time, the "field to fork" strategy adopted by the European Commission aims to achieve a significant reduction in the use of plant protection products and fertilizers in the European Union. In an experiment conducted in 2018-2020, the effect of the method of foliar fertilization containing silicon and potassium on the yield and technological quality of sugar beet roots was assessed. The fertilizer was used in seven combinations, differing in the number and time of application. The best results were obtained by treating plants during drought stress. The better soil moisture for the plants, the smaller the pure sugar yield increase was observed. It is difficult to clearly state which combination of silicon and potassium foliar application is optimal, as their effects do not differ greatly.

Impact of Foliar Fertilization on the Content of Silicon and Macronutrients in Sugar Beet.

The present study was conducted to assess the effect of various multinutrient foliar fertilization treatments on nutrient accumulation in the roots and leaves of sugar beet. The field experiment was performed in two growing seasons (2013 and 2014) in the southeastern region of Poland. The experiment was conducted as a randomized block design with four replications. To determine the content of the selected nutrients (Si, N, P, K, Mg, and Ca), samples of leaves and roots were collected during harvest. Fertilization treatments applied on the plants' leaves affected the silicon (Si) content in the roots of sugar beet and the total Si uptake. Moreover, foliar fertilization had a significant effect on the P content in the leaves and the N and K contents in the roots. The Si content in the sugar beet leaves and roots ranged from 0.55 to 1.97 g kg-1 dry matter (d. m.) and from 0.49 to 1.59 g kg-1 d. m., respectively. The total Si uptake ranged from 20.3 to 46.7 kg ha-1. Most of the Si content taken up with each fertilization variant was accumulated in the roots. The yield of pure sugar was not correlated with the Si content in the leaves and roots.

Effect of Silicon Fertilization on Crop Yield Quantity and Quality-A Literature Review in Europe.

This paper presents a research review of the effect of silicon fertilization on the yield quantity and quality in the last 15 years. The study focuses on plant species grown in Europe: cereals, soybean, rapeseed, sugar beet, potato, meadows, berries and vegetables, and orchard and ornamental plants. The use of silicon is most common in the production of vegetables in greenhouses. However, the use of this element for the fertilization of agricultural plants is rare. Positive prospects of silicon fertilization are associated with foliar application, which is much cheaper and more convenient to use than soil fertilization. Foliar application of silicon has a biostimulative effect, and the best results are observed in stressful conditions for plants such as salinity, deficiency or excess of water, high and low temperature, and the strong pressure of diseases and pests, etc. Based on the results of previous studies, it can be concluded that foliar nutrition should be introduced into production as a standard treatment in the crop management of many species of agricultural plants. It can help farmers to increase the yield of crops. It is also important that it is safe for the environment, which is particularly important in Europe.