Comparative study of luminescence and chemiluminescence in hydrodynamic cavitating flows and quantitative determination of hydroxyl radicals production.

Luminescence and chemiluminescence have been experimentally investigated in hydrodynamic cavitating flows. By using dedicated microdevices inserted inside a light tight box, photons counting has been made possible. Luminescence has been investigated with deionized water as the working fluid; chemiluminescence has resulted from cavitating alkaline luminol solutions, and has been correlated to hydroxyl radicals formation. For the first time, luminescent and chemiluminescent phenomena have been considered together on the same devices submitted to similar cavitating flow regimes. Degassed solutions enhance the luminescence and also the hydroxyl radical yield. Due to the small sizes of the channels, the lifetimes of the collapsing bubbles correspond to pseudo frequencies matching the range of optimal frequencies used in sonochemistry. New perspectives for the study of hydrodynamic cavitation as an advanced oxidation process are suggested.

Observation of chemiluminescence induced by hydrodynamic cavitation in microchannels.

We have performed hydrodynamic cavitation experiments with an aqueous luminol solution as the working fluid. Light emission, together with the high frequency noise which characterizes cavitation, was emitted by the two-phase flow, whereas no light emission from luminol was recorded in the single phase liquid flow. Light emission occurs downstream transparent microdiaphragms. The maximum level of the recorded signal was around 180 photons per second with flow rates of 380 µl/s, that corresponds to a real order of magnitude of the chemiluminescence of 75,000 photons per second. The yield of emitted photons increases linearly with the pressure drop, which is proportional to the square of the total flow rate. Chemiluminescence of luminol is a direct and a quantitative demonstration of the presence of OH hydroxyl radicals created by hydrodynamic cavitation. The presented method could be a key to optimize channel geometry for processes where radical production is essential.

Structure and rheology of SiO2 nanoparticle suspensions under very high shear rates.

High shear rate experiments have been performed with capillary microviscometers onto SiO2 nanoparticles dispersed in alcohol (so-called nanofluids). The aim of these experiments was to investigate the processes of aggregation and dislocation of the nanoparticles in a shear flow under perikinetic and orthokinetic conditions. Shear rates as high as 2x10(5) s-1 were obtained in pressure-driven microchannels laminar flows. All the nanofluids under test have displayed a Newtonian behavior but with a strong enhanced viscosity, that is, the consequence of an effective volume concentration higher than the real one. It was possible to determine the average size of the aggregates and to find a correlation between their structure and the range of the hydrodynamic Peclet number at which experiments were performed. These results display a strong evidence of the role of aggregates and support the recent conclusions about the controversy of the thermal properties of nanofluids.

Microfluidic on chip viscometers.

We present the design and the process of fabrication of micromachined capillary on chip rheometers which have performed wall shear stress and shear rate measurements on silicon oil and ethanol-based nanofluids. The originality of these devices comes from the fact that local pressure drop measurements are performed inside the microchannels. Thus, the advantage over existing microviscometers is that they can be used with the fluid under test alone; no reference fluid nor posttreatment of the data are needed. Each on chip viscometer consists of anodically bonded silicon-Pyrex derivative microchannels equipped with local probes. The anodic bonding allows to reach relatively high pressure levels (up to approximately 10 bars) in the channels, and a broad range of shear stress and shear rate values is attainable. Dielectrophoretic and electrorheological effects can be highlighted by employing alternate microstripe electrodes patterned onto the inner side of the Pyrex wall.