RESUMO
This article presents the effect of the addition of condensed tannins, used as a reticulation agent, on the polymerization of furfuryl alcohol during wood furfurylation, as well as the effect of these condensed tannins on the thermal stability of modified wood. Three kinds of dicarboxylic acids (adipic acid, succinic acid, and tartaric acid), as well as glyoxal, used as model of a wood reticulation agent, were used to catalyze the polymerization of furfuryl alcohol or tannin-furfuryl alcohol solutions. Impregnation of furfuryl alcohol or tannin-furfuryl alcohol solution into the wood, followed by curing at 103 °C for a specific duration, was performed for the wood modification. The thermal stability of the obtained tannin-furfuryl alcohol polymers and their corresponding modified woods was investigated. The leaching resistance and dimensional stability of the modified woods were also evaluated. Results indicated that the partial substitution of furfuryl alcohol by the tannins improved the polymerization reactivity in conditions where furfuryl alcohol alone did not lead to the formation of a solid polymeric material. The thermal stability and leaching resistance of the furfurylated wood in the presence of tannins were improved. Dimensional stability was also improved for furfurylated samples, but the effect of tannin addition was not so obvious, depending on the acidic catalyst used.
RESUMO
Tannin-furanic foams were prepared with a good yield using the addition of relatively small proportions of a polyflavonoid tannin extract esterified with either palmitic acid, oleic acid, or lauric acid by its reaction with palmitoyl chloride, oleyl chloride, or lauryl chloride. FTIR analysis allowed us to ascertain the esterification of the tannin, and MALDI-TOF analysis allowed us to identify a number of multi-esterified flavonoid oligomers as well as some linked to residual carbohydrates related to the equally esterified tannin. These foams presented a markedly decreased surface friability or no friability at all, and at densities lower than the standard foam they were compared to. Equally, these experimental foams presented a much-improved water repellence, as indicated by their initial wetting angle, its small variation over time, and its stabilization at a high wetting angle value, while the wetting angle of the standard foam control went to zero very rapidly. This conclusion was supported by the calculation of the total surface energy of their surfaces as well as of their dispersive and polar components.
RESUMO
This study utilizes canola stalks (CS), an agro-residue, as a biosorbent to remove two different dyes, namely Acid Orange 7 (AO7) and Remozol Black 5 (RB5) from aqueous solutions. The effects of operational parameters on the efficiency of dye removal including pH, adsorbent mass, initial dye concentration and contact time have been investigated. For both tested dyes, the maximum absorption capacity was reached at initial pH 2.5 and 120 min contact time. The results showed that the absorption of both dyes depended on the pH of milieu, temperature, dye and CS concentrations. Freundlich and Langmuir models were used to analyze the obtained experimental data. The isotherms are found to be linear over the entire concentration range for both dyes. The highest value of linear correlation coefficients for AO7 (0.9926) and RB5 (0.9882) showed that the Langmuir is the best model to fit the experimental data. Kinetic study of absorption was done applying the pseudo first-order and the pseudo second-order equations. Absorption of both dyes could be well predicted by the pseudo second-order equation. The obtained results are very promising since: (i) high levels of dye removal (>90%) were achieved with low contact times biosorbent/dye (less than 20 min contact); and (ii) the whole CS can be successfully used as biosorbent of AO7 and RB5 dyes in aqueous solution without needing any chemical modifications.
