RESUMO
The remediation of perfluoroalkyl substances (PFAS) is an urgent challenge due to their prevalence and persistence in the environment. Electrosorption is a promising approach for wastewater treatment and water purification, especially through the use of redox polymers to control the binding and release of target contaminants without additional external chemical inputs. However, the design of efficient redox electrosorbents for PFAS faces the significant challenge of balancing a high adsorption capacity while maintaining significant electrochemical regeneration. To overcome this challenge, we investigate redox-active metallopolymers as a versatile synthetic platform to enhance both electrochemical reversibility and electrosorption uptake capacity for PFAS removal. We selected and synthesized a series of metallopolymers bearing ferrocene and cobaltocenium units spanning a range of redox potentials to evaluate their performance for the capture and release of perfluorooctanoic acid (PFOA). Our results demonstrate that PFOA uptake and regeneration efficiency increased with more negative formal potential of the redox polymers, indicating possible structural correlations with the electron density of the metallocenes. Poly(2-(methacryloyloxy)ethyl cobaltoceniumcarboxylate hexafluorophosphate) (PMAECoPF6) showed the highest affinity toward PFOA, with an uptake capacity of more than 90 mg PFOA/g adsorbent at 0.0 V vs Ag/AgCl and a regeneration efficiency of more than 85% at -0.4 V vs Ag/AgCl. Kinetics of PFOA release showed that electrochemical bias greatly enhanced the regeneration efficiency when compared to open-circuit desorption. In addition, electrosorption of PFAS from different wastewater matrices and a range of salt concentrations demonstrated the capability of PFAS remediation in complex water sources, even at ppb levels of contaminants. Our work showcases the synthetic tunability of redox metallopolymers for enhanced electrosorption capacity and regeneration of PFAS.
RESUMO
The removal of per- or polyfluorinated alkyl substances (PFAS) has received increasing attention because of their extreme stability, our increasing awareness of their toxicity at even low levels, and scientific challenges for traditional treatment methods such as separation by activated carbon or destruction by advanced oxidation processes. Here, we performed a direct and systematic comparison of two electrified approaches that have recently shown promise for effective degradation of PFAS: plasma and conventional electrochemical degradation. We tailored a reactor configuration where one of the electrodes could be a plasma or a boron-doped diamond (BDD) electrode and operated both electrodes galvanostatically by continuous direct current. We show that while both methods achieved near-complete degradation of PFAS, the plasma was only effective as the cathode, whereas the BDD was only effective as the anode. Compared to the BDD, plasma required more than an order of magnitude higher voltage but lower current to achieve similar degradation efficiency with more rapid degradation kinetics. All these factors considered, it was noted that plasma or BDD degradation resulted in similar energy efficiencies. The BDD electrode exhibited zero-order kinetics, and thus, PFAS degradation using the conventional electrochemical method was kinetically controlled. On the contrary, analysis using a film model indicated that the plasma degradation kinetics of PFAS using plasma were mass-transfer-controlled because of the fast reaction kinetics. With the help of a simple quantitative model that incorporates mass transport, interfacial reaction, and surface accumulation, we propose that the degradation reaction kinetically follows an Eley-Rideal-type mechanism for the plasma electrode, and an intrinsic rate constant of 2.89 × 108 m4 mol-1 s-1 was obtained accordingly. The investigation shows that to realize the true kinetic potential of plasma degradation for water treatment, mass transfer to the interface must be enhanced.
