Uranium removal from seawater by means of polymeric fabrics grafted with diallyl oxalate through a single-step, solvent-free process.

In order to test the effectiveness of oxalate-based polymeric adsorbents in the recovery of uranium from seawater, diallyl oxalate (DAOx) was grafted onto nylon 6 fabrics by exposing the fabric, immersed in pure liquid DAOx or in a surfactant-stabilized dispersion of DAOx in water, to electron beam or gamma radiation. Following drying and weighing to determine the degree of grafting (DoG), the presence of oxalate in the fabrics was verified using XPS. Zeta potential measurements showed the fabric surfaces to be negatively charged. The fabrics were tested by rotating them for 7 days in a rotary agitator with actual seawater spiked with 0.2 or 1.0 mg∙L-1 uranium. The fraction of uranium in the solution which was removed due to uptake on the fabrics was found to rise with increasing DoG at both uranium concentrations. EDS measurements were used to map the distribution of adsorbed uranium on the polymeric fibers.

Acid generation upon thermal concentration of natural water: the critical water content and the effects of ionic composition.

Thermal evaporation of a variety of simulated pore waters from the region of Yucca Mountain, Nevada, produced acidic liquids and gases during the final stages of evaporation. Several simulated pore waters were prepared and then thermally distilled in order to collect and analyze fractions of the evolved vapor. In some cases, distillates collected towards the end of the distillation were highly acidic; in other cases the pH of the distillate remained comparatively unchanged during the course of the distillation. The results suggest that the pH values of the later fractions are determined by the initial composition of the water. Acid production stems from the hydrolysis of magnesium ions, especially at near dryness. Near the end of the distillation, magnesium nitrate and magnesium chloride begin to lose water of hydration, greatly accelerating their thermal decomposition to form acid. Acid formation is promoted further when precipitated calcium carbonate is removed. Specifically, calcium chloride-rich pore waters containing moderate (10-20 ppm) levels of magnesium and nitrate and low levels of bicarbonate produced mixtures of nitric and hydrochloric acid, resulting in a precipitous drop in pH to values of 1 or lower after about 95% of the original volume was distilled. Waters with either low or moderate magnesium content coupled with high levels of bicarbonate produced slightly basic fractions (pH 7-9). If calcium was present in excess of bicarbonate, waters containing moderate levels of magnesium produced acid even in the presence of bicarbonate, due to the precipitation of calcium carbonate. Other salts such as halite and anhydrite promote the segregation of acidic vapors from residual basic solids. The concomitant release of wet acid gas has implications for the integrity of the alloys under consideration for containers at the Yucca Mountain nuclear waste repository. Condensed acid gases at very low pH, especially mixtures of nitric and hydrochloric acid, are capable of corroding even alloys, such as nickel-based Alloy 22, which are considered to be corrosion-resistant under milder conditions.

Composition and particle size of superparamagnetic corrosion products in tap water.

Chemical analyses, magnetization, Mössbauer spectrum, and x-ray diffraction measurements were made on solids removed from tap water by means of membrane filters. The taps from which this water was obtained had previously been unused for prolonged periods of time. When these taps were reactivated and water was first drawn, it was observed that the quantity of coarse solids in the water gradually decreased with flow, while at the same time the quantity of fine solids gradually increased. The magnetization, Mössbauer spectra, and x-ray diffraction patterns of the solids showed the presence of a significant number of superparamagnetic particles of magnetite. In the temperature range of our measurements (77 K

Superparamagnetic nanoparticles in tap water.

Magnetization measurements are a useful tool in the characterization of corrosion products formed in municipal water pipes made of iron or steel. Fine particles formed in corrosion processes exhibit superparamagnetic behavior. The size of such particles, which determines their capacity to adsorb hazardous species, can therefore be found from magnetic measurements. Application of this methodology to samples extracted from flowing and stagnant tap water, respectively, has shown that the flowing water samples contained multidomain (>100 nm) ferromagnetic particles as well as aggregates of very fine superparamagnetic subdomain particles. The sizes of the fine particles are of the order of 3.2-5.6 nm. In addition to small subdomain superparamagnetic particles stagnant water samples also contained larger subdomain particles with average dimensions of 59-67 nm. Both large and small subdomain particles were trapped by the fine charcoal in household filters.