Structural and morphological tuning of iron oxide polymorphs by ECR plasma-assisted thermal oxidation.

The work presented involves the generation of oxygen plasma species at low pressure utilizing an Electron Cyclotron Resonance (ECR) plasma reactor, and their interactions with micron- and nano-sized iron films (M-Fe and N-Fe film respectively) prepared using ethyl cellulose processed at high temperature. A specially designed radiation heater (RH) was used to raise the surface temperature of the film rapidly, exactly at the film interface, where the plasma species interact with the surface. As a result of the interaction of oxygen plasma species and temperature, iron is oxidized to different polymorphs depending on the operating pressure and hence oxygen gas flow rate. The phase, as well as the morphology of the film was controlled by monitoring the oxygen flow rate using the unique Plasma-Assisted Thermal Oxidation (PATO) process. Different polymorphs, viz., Fe3O4, γ-Fe2O3, α-Fe2O3 and different morphologies, such as polygonal, compact facets, wire-like (1D) nanostructures at the surface were obtained for the films processed using PATO. The selected PATO-processed films were investigated for Field Electron Emission (FEE) properties. The 1D-grown surface of iron oxide obtained from the M-Fe film showed a turn-on field of 3 MV m-1 and emission current of 337 µA cm-2, whereas the pyramidal surface morphology obtained using N-Fe film gives a turn-on field of 3.3 MV m-1 with an emission current of 578 µA cm-2.

Effective degradation of organic water pollutants by atmospheric non-thermal plasma torch and analysis of degradation process.

The paper reports the use of atmospheric non-thermal plasma torch as a catalyst for degradation of various organic pollutants dissolved in water. A flow of He mixed with air was used to produce the dielectric barrier discharge (DBD), at the tip of the torch, using pulsed electric excitation at 12 kV. The torch, operated at a power of 750 mW/mm2, was seen to completely degrade the aqueous solutions of the pollutants namely methylene blue (MB), methyl orange (MO) and rhodamine-B (RB), at around 10-4 M concentrations, the concentration of polluants is one order higher than of routinely used heterogeneous photocatalytic reactions, within 10 min of irradiation time at room temperature. UV Visible spectra of the organic dye molecules, monitored after different intervals of plasma-irradiation, ranging between 1 and 10 min, have been used as tools to quantify their sequential degradation. Further, instead of using He, only air was used to form plasma plume and used for degradation of organic dye which follow similar trend as that of He plasma. Further, Liquid Chromatography Mass Spectroscopy (LCMS) technique has been used to understand degradation pathway of methylene blue (MB) as a representative case. Total organic carbon (TOC) measurements indicates significant decrease in its content as a function of duration of plasma exposure onto methylene blue as a representative case. Toxicity studies were carried out onto Gram negative Escherichia coli. This indicated that methylene blue, without plasma treatment, shows growth inhibition, whereas with plasma treatment no inhibition was observed.

Micro-structural analysis of NiFe2O4 nanoparticles synthesized by thermal plasma route and its suitability for BSA adsorption.

The paper presents the experimental studies pertaining to the adsorption of bovine serum albumin (BSA) on the nanoparticles of nickel ferrite (NiFe2O4) with a view of correlating the adsorption properties to their microstructure and zeta potentials. Physical properties of two kinds of nickel ferrites, one synthesized by thermal plasma route and the other by chemical co-precipitation method, are compared. Maximum adsorption (231.57 µg/mg) of BSA onto nickel ferrite nanoparticles, at body temperature (37 °C) was observed at pH-value of 5.58 for the thermal plasma synthesized particles showing its higher adsorption capacity than those synthesized by wet chemical means (178.71 µg/mg). Under the same physical conditions the value of zeta potential, obtained for the former, was higher than that of the latter over a wide range of pH values (3.64-9.66). This is attributed to the differences in the specific surface energies of the two kinds of nanoparticles arising from the degree of crystallinity. The paper presents the experimental evidence for the single crystalline nature of the individual nanoparticles, with mean size of 32 nm, for the thermal plasma synthesized particles as evidenced from the high resolution transmission electron microscopy and electron diffraction analysis. The measurements also reveal the poor crystalline morphology in the chemically prepared particles (mean size of 28 nm) although the X-ray diffraction patterns are not much different. The atomic force microscopy images confirm that the surfaces of plasma synthesized nanoparticles possesses higher surface roughness than that of chemically synthesized one. Presence of adsorbed protein was confirmed by vibrational spectroscopy. The Langmuir adsorption model is found to fit into the experimental data better than the Freundlich adsorption model.

Si nanotubes and nanospheres with two-dimensional polycrystalline walls.

We report on the characteristics of a new class of Si-based nanotubes and spherical nanoparticles synthesized by the dc-arc plasma method in a mixture of argon and hydrogen. These two nanostructures share common properties: they are hollow and possess very thin, highly polycrystalline and mainly oxidized walls. In particular, we get several hints indicating that their walls could constitute only one single Si oxidized layer. Moreover, we find that only the less oxidized nanotubes exhibit locally atomic ordered, snakeskin-like areas which possess a hexagonal arrangement which can be interpreted either as an sp(2) or sp(3) hybridized Si or Si-H layer. Their ability to not react with oxygen seems to suggest the presence of sp(2) configuration or the formation of silicon-hydrogen bonding.

Antimicrobial properties of uncapped silver nanoparticles synthesized by DC arc thermal plasma technique.

We, herein, report the antimicrobial properties of uncapped silver nanoparticles for a Gram positive model organism, Bacillus subtilis. Uncapped silver nanoparticles have been prepared using less-explored DC arc thermal plasma technique by considering its large scale generation capability. It is observed that the resultant nanoparticles show size as well as optical property dependent antimicrobial effect.