Ultrasensitive determination of polycyclic aromatic compounds with atmospheric-pressure laser ionization as an interface for GC/MS.

Recently we introduced atmospheric pressure laser ionization (APLI) as a complementary ionization method for coupling LC-MS systems (HPLC and CEC), allowing ionization of nonpolar aromatic compounds via near-resonant two-photon excitation. In this paper, we demonstrate that APLI with the same source enclosure as for LC coupling is also suited for hyphenation of GC with atmospheric-pressure ionization mass spectrometry. This technique permits the qualitative and quantitative determination of aromatic compounds in an ultralow concentration range, as we show here with polycyclic aromatic hydrocarbons (PAHs), alkylated PAHs, and hetero-PAHs as examples. The outstanding sensitivity is demonstrated for chrysene, with a detection limit of 22 amol. Polar functional groups reduce the sensitivity, but after methylation or silylation, the analytes can also be determined very sensitively in complex matrixes, as is shown with 1-hydroxypyrene in urine.

Atmospheric-pressure laser ionization: a novel ionization method for liquid chromatography/mass spectrometry.

We report on the development of a new laser-ionization (LI) source operating at atmospheric pressure (AP) for liquid chromatography/mass spectrometry (LC/MS) applications. APLI is introduced as a powerful addition to existing AP ionization techniques, in particular atmospheric-pressure chemical ionization (APCI), electrospray ionization (ESI), and atmospheric pressure photoionization (APPI). Replacing the one-step VUV approach in APPI with step-wise two-photon ionization strongly enhances the selectivity of the ionization process. Furthermore, the photon flux during an ionization event is drastically increased over that of APPI, leading to very low detection limits. In addition, the APLI mechanism generally operates primarily directly on the analyte. This allows for very efficient ionization even of non-polar compounds such as polycyclic aromatic hydrocarbons (PAHs). The APLI source was characterized with a MicroMass Q-Tof Ultima II analyzer. Both the effluent of an HPLC column containing a number of PAHs (benzo[a]pyrene, fluoranthene, anthracene, fluorene) and samples from direct syringe injection were analyzed with respect to selectivity and sensitivity of the overall system. The liquid phase was vaporized by a conventional APCI inlet (AP probe) with the corona needle removed. Ionization was performed through selective resonance-enhanced multi-photon ionization schemes using a high-repetition-rate fixed-frequency excimer laser operating at 248 nm. Detection limits well within the low-fmol regime are readily obtained for various aromatic hydrocarbons that exhibit long-lived electronic states at the energy level of the first photon. Only molecular ions are generated at the low laser fluxes employed ( approximately 1 MW/cm(2)). The design and performance of the laser-ionization source are presented along with results of the analysis of aromatic hydrocarbons.

Direct measurement of OH radicals from ozonolysis of selected alkenes: a EUPHORE simulation chamber study.

Reactions of ozone with alkenes can be a significant source of hydroxyl radicals in the atmosphere. In the present paper, the formation of OH radicals in the ozonolysis of selected alkenes under atmospheric conditions was directly observed. The experiments were carried out in the European photoreactor EUPHORE (Valencia, Spain). OH radicals were quantitatively detected by means of laser-induced fluorescence (LIF) using a new analytical instrument, which has been constructed on the basis of an existing setup already established in field studies. The OH radicals observed resulted directly from the reaction of ozone with the corresponding alkene. There was no indication that OH radicals were produced in the system by secondary processes. The experimentally observed concentration-time profiles of OH and ozone were excellently described by chemical modeling using explicit reaction mechanisms. The following OH yields were derived: 2,3-dimethyl-2-butene: (1.00 +/- 0.25); 2-methyl-2-butene: (0.89 +/- 0.22); trans-2-butene: (0.75 +/- 0.19); alpha-pinene: (0.91 +/- 0.23). In addition, the experiments carried out were modeled using the Regional Atmospheric Chemistry Mechanism (RACM), an established condensed chemical model applied in tropospheric chemistry. For 2,3-dimethyl-2-butene, 2-methyl-2-butene, and trans-2-butene the calculated concentration-time profiles of OH and ozone are in quite good agreement with the experimental data. However, in the case of alpha-pinene, the model fails for the simulation of OH due to the high grade of mechanism condensation, which results in a poor characterization of the primary reaction products.

Nonintrusive optical measurements of aircraft engine exhaust emissions and comparison with standard intrusive techniques.

Nonintrusive systems for the measurement on test rigs of aeroengine exhaust emissions required for engine certification (CO, NO(x), total unburned hydrocarbon, and smoke), together with CO(2) and temperature have been developed. These results have been compared with current certified intrusive measurements on an engine test. A spectroscopic database and data-analysis software has been developed to enable Fourier-transform Infrared measurement of concentrations of molecular species. CO(2), CO, and NO data showed agreement with intrusive techniques of approximately ?30%. A narrow-band spectroscopic device was used to measure CO(2) (with deviations of less than ?10% from the intrusive measurement), whereas laser-induced incandescence was used to measure particles. Future improvements to allow for the commercial use of the nonintrusive systems have been identified and the methods are applicable to any measurement of combustion emissions.