RESUMO
Small, highly absorbing points are randomly present on the surfaces of the main interferometer optics in Advanced LIGO. The resulting nanometer scale thermo-elastic deformations and substrate lenses from these micron-scale absorbers significantly reduce the sensitivity of the interferometer directly though a reduction in the power-recycling gain and indirect interactions with the feedback control system. We review the expected surface deformation from point absorbers and provide a pedagogical description of the impact on power buildup in second generation gravitational wave detectors (dual-recycled Fabry-Perot Michelson interferometers). This analysis predicts that the power-dependent reduction in interferometer performance will significantly degrade maximum stored power by up to 50% and, hence, limit GW sensitivity, but it suggests system wide corrections that can be implemented in current and future GW detectors. This is particularly pressing given that future GW detectors call for an order of magnitude more stored power than currently used in Advanced LIGO in Observing Run 3. We briefly review strategies to mitigate the effects of point absorbers in current and future GW wave detectors to maximize the success of these enterprises.
RESUMO
We report on the design and noise performance of a narrow-linewidth Yb-doped fiber amplifier emitting up to 178 W at 1064 nm for possible use in gravitational-wave (GW) interferometric detectors. The novel design utilizes a specialty large-mode-area gain fiber with confined-core doping and depressed cladding, followed by a smaller-core passive fiber to improve output beam quality. We show that the free-running noise of the system is equal to or better than current Advanced LIGO noise requirements. Finally, we discuss potential improvements for long-term use in GW detectors.
RESUMO
We report on a simple method of locking a laser to a birefringent cavity using polarization spectroscopy. The birefringence of the resonator permits the simple extraction of an error signal by using one polarization state as a phase reference for another state. No modulation of the light or the resonator is required, reducing the complexity of the laser locking setup. This method of producing an error signal can be used on most birefringent optical resonators, even if the details of birefringence and eigenpolarizations are not known. This technique is particularly well suited for fiber ring resonators due to the inherent birefringence of the fiber and the unknown nature of that birefringence. We present an experimental demonstration of this technique using a fiber ring.
