Colorimetric determination of selenium in mineral premixes .

A method is described for determination of sodium selenite or sodium selenate in mineral-based premixes. It is based on the formation of intense-yellow piazselenol by Se(IV) and 3,3'-diaminobenzidine. Mineral premixes typically contain calcium carbonate as a base material and magnesium carbonate, silicon dioxide, and iron(III) oxide as minor components or additives. In this method, the premix is digested briefly in nitric acid, diluted with water, and filtered to remove any Iron(III) oxide. Ethylenediaminetetraacetic acid and HCl are added to the filtrate, which is heated to near boiling for 1 h to convert any selenate to selenite. After heating, the solution is buffered between pH 2 and 3 with NaOH and formic acid and treated with NH2OH and EDTA; any Se present forms a complex with 3,3'-diaminobenzidine at 60 degrees C. The solution is made basic with NH4OH, and the piazselenol is extracted into toluene. The absorbance of the complex in dried toluene is measured at 420 nm. The method was validated independently by 2 laboratories. Samples analyzed included calcium carbonate fortified with 100, 200, and 300 micrograms Se in the form of sodium selenite or sodium selenate, a calcium carbonate premix containing sodium selenite, a calcium carbonate premix containing sodium selenate, and a commercial premix; 5 replicates of each sample type were analyzed by each laboratory. Average recoveries ranged from 89 to 109% with coefficients of variation from 1.2 to 13.6%.

Liquid chromatographic determination of nicarbazin in feed.

A liquid chromatographic method was developed for the determination of nicarbazin (4,4'-dinitrocarbanilide.2-hydroxy-4,6-dimethylpyrimidine) in chicken feed. Ground feed was extracted with hot dimethylformamide, filtered, and then cleaned up on an alumina column. The nicarbazin was eluted from the column with ethanol and quantitated using a reverse phase C-18 column, with a methanol-water mobile phase and ultraviolet detection at 344 nm. Recoveries at a typical use level of 100 micrograms/g feed averaged 98% with a standard deviation of 3%. Samples fortified at levels as low as 0.1 micrograms/g were analyzed with 92% recovery. The detection limit is 1 ng, and the response is linear between 4 and 1000 ng. Feed additives in combination with nicarbazin do not interfere with recovery.

Citrus artifact interference in aflatoxin M1 determination in milk.

Dried citrus waste was fed to dairy cows, their milk was extracted, and aflatoxin M1 was quantitated by using both high pressure liquid chromatography (HPLC) and thin layer chromatography (TLC). Results indicate that a compound from the citrus waste, which is excreted into the milk, interferes with the HPLC determination of aflatoxin M1 in milk and causes a false positive test. This interference can be overcome by using TLC with proper selection of developing solvents.