Automated method for volatile fatty acids determination in anaerobic processes using in-syringe magnetic stirring assisted dispersive liquid-liquid microextraction and gas chromatography with flame ionization detector.

Volatile fatty acids (VFAs) are key parameters to monitor anaerobic digestion processes. Thus, a fast, simple and precise determination of these analytes is necessary for a timely characterization of the biological processes present in municipal solid waste and wastewater treatment plants. In this work, an automated method for the extraction and preconcentration of VFAs, based on dispersive liquid-liquid microextraction with magnetic stirring in syringe, and gas chromatography with flame ionization detector for the separation and detection, is described. The effect of parameters such as the type and volume of extraction solvent, pH, salting out effect and stirring time, was studied using a multivariate and univariate experimental design. Extraction and preconcentration were performed simultaneously using tert-butyl methyl ether (TBME) as the extraction solvent, after stirring 100 s at a constant rate. The detection limits were in the range of 0.1 - 1.3 mg L-1 and a good linearity was observed up to 1000 mg L-1 of the studied VFAs, with a range of R2 between 0.9997 and 0.9999. The intra and interday precision expressed as relative standard deviation (n= 5) varied between 0.7 and 2.4% and between 1.7 and 7.0%, respectively. Subsequently, the developed method was successfully applied to evaluate the presence of VFAs in wastewater samples from anaerobic treatments and an average relative recovery of 102% was obtained.

Recovering biomethane and nutrients from anaerobic digestion of water hyacinth (Eichhornia crassipes) and its co-digestion with fruit and vegetable waste.

The potential to recover bioenergy from anaerobic digestion of water hyacinth (WH) and from its co-digestion with fruit and vegetable waste (FVW) was investigated. Initially, biogas and methane production were studied using the biochemical methane potential (BMP) test at 2 g volatile solids (VS) L(-1) of substrate concentration, both in the digestion of WH alone and in its co-digestion with FVW (WH-FVW ratio of 70:30). Subsequently, the biogas production was optimized in terms of total solids (TS) concentration, testing 4 and 6% of TS. The BMP test showed a biogas yield of 0.114 m(3) biogas kg(-1) VSadded for WH alone. On the other hand, the biogas potential from the WH-FVW co-digestion was 0.141 m(3) biogas kg(-1) VSadded, showing an increase of 23% compared to that of WH alone. Maximum biogas production of 0.230 m(3) biogas kg(-1) VSadded was obtained at 4% of TS in the co-digestion of WH-FVW. Using semi-continuously stirred tank reactors, 1.3 m(3) biogas yield kg(-1) VSadded was produced using an organic loading rate of 2 kg VS m(-3) d(-1) and hydraulic retention time of 15 days. It was also found that a WH-FVW ratio of 80:20 improved the process in terms of pH stability. Additionally, it was found that nitrogen can be recovered in the liquid effluent with a potential for use as a liquid fertilizer.

Methane production and hydrolysis kinetics in the anaerobic degradation of wastewater screenings.

Anaerobic biodegradability and hydrolysis rates of wastewater screenings were determined using the biochemical methane potential test at 37 °C. The extent and rate of screenings conversion to methane of this complex and particulate substrate were investigated and since two stages of hydrolysis were identified, corresponding to the different types of materials in screenings, a linear and non-linear model was used. No accumulation of intermediary products was observed and so it was possible to use the methane production rate and a linear model to estimate the hydrolysis rate in the first phase of hydrolysis. The measured values of 0.061-0.127 d(-1) are in the range reported for other comparable organic wastes. It was also observed that the inoculum-to-substrate ratio has a large impact on methane production rate of screenings. The difference in biodegradation rates from the materials in screenings and the overall hydrolysis could be represented by the modified Gompertz non-linear model which was able to describe the methane production rate of screenings with a high confidence. Screenings were found to have 52% biodegradability on average and this shows the potential for volatile solids destruction. A two-stage process with an improved hydrolysis rate is proposed to ensure that the full potential of the material is exploited.