Amino Acids as Potential Precursors to Odorous Compounds in Tap Water during Spring Runoff Events.

The onset of spring runoff in northern climates and tap water odor events are difficult to predict because common water quality parameters cannot fully explain the intermittent odor events that occurred over past decades. Studies have shown that small polar water-soluble compounds, such as amino acids (AAs), leach first from ice/snowmelt. AAs are known to produce odorous compounds, such as aldehydes and chloroaldimines, upon chlorination. Therefore, we proposed that AAs may serve as markers for small and soluble organics that contribute to the odor of chlorinated tap water. Here, we studied the occurrence of AAs in source water collected at two water treatment plants and the odor profiles of tap water at >300 homes during the 2021 and 2022 spring runoff events. AA concentrations were at baseline levels (<100 ng/L) during the 2021 runoff but much higher (up to 5500 ng/L) in 2022 and associated with an escalation in odor complaints. AA concentrations peaked at the onset of the 2022 spring runoff and corresponded with the strongest reported odor intensities in tap water. We obtained high resolution MS and MS/MS spectra of chloroaldimines and confirmed the formation of chloroaldimines under chlorination of the six AAs detected in source water. The results indicate that AAs signal the onset of spring runoff and represent small polar water-soluble compounds that may contribute to tap water odor problems.

Aspartame-Sweetened Tap Water: Transformation Products and 2,6-Dichloro-1,4-Benzoquinone Formation.

Aspartame (APM), a dipeptide of aspartic acid (ASP) and phenylalanine (PHE), is a widely used artificial sweetener in beverages. It is unclear whether residual chlorine in tap water can react with APM to form disinfection byproducts (DBPs). Therefore, we investigated the formation of DBPs from the reaction of APM with residual chlorine in authentic tap water. APM and a commercial sweetener (CS) packet containing APM were studied under authentic and simulated tap water conditions. Eight chlorinated products of APM were detected using solid-phase extraction (SPE) and high performance liquid chromatography quadrupole time-of-flight mass spectrometry (HPLC-QTOF-MS). These new chloro-products were tentatively identified based on accurate masses, isotopic patterns of 35,37Cl, and MS/MS spectra. Furthermore, we identified APM as a precursor to 2,6-dichloro-1,4-benzoquinone (DCBQ). DCBQ significantly increased to 2.3-12 ng/L with the addition of APM or CS in tap waters collected from different locations compared to 1.4-1.8 ng/L in the same tap water samples without sweetener. DCBQ and two of the chlorinated transformation products were identified in cold prepared tea containing APM. DCBQ formation was eliminated when the residual chlorine in tap water was reduced by ascorbic acid or boiling prior to the addition of APM or CS. This study found that eight new DBPs and DCBQ were produced by the reactions of residual chlorine with APM and CS. These findings show an unintended exposure source of emerging DBPs via APM sweetened beverages.

Integration of solid phase extraction with HILIC-MS/MS for analysis of free amino acids in source water.

Amino acids (AAs) are prevalent in source water, particularly during spring run-off. Monitoring of amino acids in source water is desirable for water treatment plants (WTP) to indicate changes in source water quality. The objective of this study was to establish analytical procedures for reliable monitoring of amino acids in source water. Therefore, we examined two different methods, large volume inject (LVI) and solid phase extraction (SPE), for sample preparation prior to HILIC-MS/MS. The LVI-HILIC-MS/MS method can provide fast and sensitive detection for clean samples, but suffers from matrix effects, resulting in irreproducible separation and shortening column lifetime. We have demonstrated that SPE was necessary prior to HILIC-MS/MS to achieve reproducible and reliable quantification of AAs in source water. A natural heterocyclic amine 1-methyl-1,2,3,4-tetrahydro-ß-carboline-3-carboxylic acid (MTCCA) was also included in the method to indicate changes in other natural nitrogenous compounds in source water. The SPE-HILIC-MS/MS method was able to achieve limits of detection from 2.6-3400 ng/L for the amino acids and MTCCA with RSDs (n=3) of 1.1%-4.8%. As well, retention times (RT) of the analytes were reproducible with variation less than 0.01 min (n=3) through the entire project. We further applied the SPE-HILIC-MS/MS method to determine AAs in authentic source water samples collected from two drinking water treatment plants (WTPs) during the 2021 spring run-off season. The results support that the SPE-HILIC-MS/MS method does not require derivatization and can provide reliable, accurate, and robust analysis of AAs and MTCCA in source water, supporting future monitoring of source water quality.

Unique On-Site Spinning Sampling of Highly Water-Soluble Organics Using Functionalized Monolithic Sorbents.

Water utilities encounter unpredictable odor issues that cannot be explained by routine water parameters during spring runoff, even in the summer and fall. Highly water-soluble organics (e.g., amino acids and saccharides) have been reported to form odorous disinfection byproducts during disinfection, but the lack of simple and practical on-site sampling techniques hampers their routine monitoring at trace levels in source water. Therefore, we have created two functionalized nested-in-sponge silica monoliths (NiS-SMs) using a one-pot synthesis method and demonstrated their application for extracting highly soluble organics in water. The NiS-SMs functionalized with the sulfonic group and phenylboronic moiety selectively extracted amino acids and monosaccharides, respectively. We further developed a spinning sampling technique using the composites and evaluated its robust performance under varying water conditions. The spinning sampling coupled to high-performance liquid chromatography tandem mass spectrometry analysis provided limits of detection for amino acids at 0.038-0.092 ng L-1 and monosaccharides at 0.036-0.14 ng L-1. Using the pre-equilibrium sampling-rate calibration, we demonstrated the applicability of the spinning sampling technique for on-site sampling and monitoring of amino acids and monosaccharides in river water. The new composite materials and rapid on-site sampling technique are unique and efficient tools for monitoring highly soluble organics in water sources.

Determination of eighty-two pesticides and application to screening pesticides in cannabis growing facilities.

Determination of pesticides in cannabis facilities is increasingly important as medicinal and recreational uses of cannabis products expand rapidly. We report a method involving wipe sampling, liquid chromatography separation, and tandem mass spectrometry, which enables determination of 82 pesticides out of the 96 regulated by Health Canada. To demonstrate an application of the method, we sampled and measured pesticides in two cannabis growing facilities, representing a non-certified and a certified site. We detected 41 pesticides in surface wipe samples at the non-certified site and 6 at the certified site. This study provides the first evidence showing pesticide occurrence on common surfaces in cannabis growing facilities and points to a need for routine monitoring and strict control of pesticide use in cannabis facilities.

Nontargeted Identification of an N-Heterocyclic Compound in Source Water and Wastewater as a Precursor of Multiple Nitrosamines.

N-Nitrosamine disinfection byproducts (DBPs) are a health concern because they are probable human carcinogens. Complex organic nitrogenous compounds, nitrosamine precursors, are largely unidentified in source water. Using stable isotopic labeling-enhanced nontargeted analysis, we identified a natural product N-heterocyclic amine 1-methyl-1,2,3,4-tetrahydro-ß-carboline-3-carboxylic acid (MTCCA) in source water. Interestingly, we discovered that chloramination of MTCCA-containing water could produce four nitrosamines: methylethylnitrosamine, N-nitrosopyrrolidine, N-nitrosoanatabine, and N-nitrosoanabasine. Computational modeling and experimental results helped explain potential pathways of nitrosamines generated from chloramination of MTCCA. Further investigations confirmed widespread occurrence of MTCCA in source water and wastewater. Its concentration ranged from high in upstream creeks (23.2-332.2 ng L-1) to low in the river (5.7-37.6 ng L-1) during the 2020 spring runoffs, indicating that sources of MTCCA came from creeks around farms. Analysis of wastewater before and after ultraviolet, as well as microfiltration with subsequent ozonation treatments, showed increased MTCCA after treatments, demonstrating a difficulty to degrade and remove MTCCA in water. This study discovered the extensive presence of MTCCA in source water and wastewater, suggesting that natural N-heterocyclic compounds may serve as a new source of nitrosamine precursors.

New methods for identification of disinfection byproducts of toxicological relevance: Progress and future directions.

Disinfection byproducts (DBPs) represent a ubiquitous source of chemical exposure in disinfected water. While over 700 DBPs have been identified, the drivers of toxicity remain poorly understood. Additionally, ever evolving water treatment practices have led to a continually growing list of DBPs. Advancement of analytical technologies have enabled the identification of new classes of DBPs and the quantification of these chemically diverse sets of DBPs. Here we summarize advances in new workflows for DBP analysis, including sample preparation, chromatographic separation with mass spectrometry (MS) detection, and data processing. To aid in the selection of techniques for future studies, we discuss necessary considerations for each step in the strategy. This review focuses on how each step of a workflow can be optimized to capture diverse classes of DBPs within a single method. Additionally, we highlight new MS-based approaches that can be powerful for identifying novel DBPs of toxicological relevance. We discuss current challenges and provide perspectives on future research directions with respect to studying new DBPs of toxicological relevance. As analytical technologies continue to advance, new strategies will be increasingly used to analyze complex DBPs produced in different treatment processes with the aim to identify potential drivers of toxicity.

Pesticides and trace elements in cannabis: Analytical and environmental challenges and opportunities.

Cannabis is increasingly used for both medicinal and recreational purposes with an estimate of over 180 million users annually. Canada has recently legalized cannabis use in October 2018, joining several states in the United States of America (e.g., Colorado, California, and Oregon) and a few other countries. A variety of cannabis products including dry flowers, edibles, and oil products are widely consumed. With high demand for cannabis products worldwide, the quality of cannabis and its related products has become a major concern for consumer safety. Various guidelines have been set by different countries to ensure the quality, safety, and efficacy of cannabis products. In general, these guidelines require control of contaminants including pesticides, toxic elements, mycotoxins, and pathogens, as well as residual solvents in regard to cannabis oil. Accordingly, appropriate analytical methods are required to determine these contaminants in cannabis products for quality control. In this review, we focus on the current analytical challenges and method development for detection of pesticides and toxic elements in cannabis to meet various guidelines.

Stable Isotopic Labeling and Nontarget Identification of Nanogram/Liter Amino Contaminants in Water.

We report a new combinatorial approach of stable isotopic labeling (SIL)-solid phase extraction (SPE)-liquid chromatography-tandem high-resolution mass spectrometry (LC-HRMS/MS) for identification of amino-containing contaminants at trace levels in source water. The new SIL method requires small amounts of formaldehyde (CH2O) and deuterated formaldehyde (CD2O) to efficiently label ng/L amino compounds in 1 L of water and improves SPE recovery, enabling environmental analysis of trace amino-compounds. Isotopically methylated components were confirmed using LC-MS/MS based on their retention times, and characteristic isotope patterns of the molecular and product ions. Using the characteristic isotope patterns, we established a data prioritization process to identify the amino compounds in thousands of mass peaks in raw data. Analysis of a labeled authentic source water detected 8952 m/z peaks and tentatively identified 154 amino compounds. Our SIL-methylation prioritization approach effectively reduced the complexity of data. Manual spectrum interpretation identified 77 of the 154 components as amino acids and peptides. We confirmed 8 of the 77 compounds using commercially available standards to demonstrate the feasibility and reliability of our SIL-SPE-LC-HRMS/MS method for environmental analysis of trace amino-containing contaminants. The method can efficiently identify amino-precursors in source water, enabling other studies of nitrogenous disinfection byproduct formation.

Effect of nature of electrolytes on retention and selectivity in hydrophilic interaction liquid chromatography.

This work investigates the selectivity and retention changes on four classes of HILIC columns upon addition of 1-20 mM electrolyte. The effect of four electrolytes (Na+Cl-, Na+ClO4-, Na+PF6-, and Na+CF3CO2-) were tested on neutral, cationic, anionic, and zwitterionic analytes under HILIC conditions (70-90% ACN). These electrolytes alter the retention and selectivity on silica, zwitterionic and diol columns through ion exchange and ionic screening mechanisms. Neutral analytes were unaffected by addition of 1-20 mM electrolyte, indicating minimal change to the retentivity of the water layer. Cationic and anionic analytes increase and decrease in retention, respectively (Na+PF6- ≈ Na+ClO4- > Na+CF3CO2- > Na+Cl-). Chaotropic electrolytes accumulate at the mobile phase/water layer interface, enhancing the ion exchange and ionic screening effects of the mobile phase electrolyte. Altering the buffer cation (Li+, Na+, K+) caused small but statistically significant changes in retention.