RESUMO
Agro-industrial byproducts and food waste necessitate an environmentally friendly way of reducing issues related to their disposal; it is also necessary to recover as much new raw material from these resources as possible, especially when we consider their potential usage as a precursor for preparing depolluting materials, such as activated carbon. In this work, coffee grounds and olive stones were chosen as precursors and the adsorption capacity of the obtained porous carbons for volatile organic compounds (VOCs) was studied. Microporous activated carbons (ACs) were prepared using chemical (K2CO3) and physical (CO2) activation. The influence of the activation process, type, and time of activation was also investigated. Measurements of VOCs adsorption were performed, and methyl-ethyl-ketone (MEK) and toluene were chosen as the model pollutants. The surface areas and total pore volumes of 1487 m2/g and 0.53 cm3/g and 870 m2/g and 0.22 cm3/g for coffee ground carbons and olive stone carbons, respectively, were obtained via chemical activation, whereas physical activation yielded values of 716 m2/g and 0.184 cm3/g and 778 cm2 g-1 and 0.205 cm3/g, respectively. As expected, carbons without activation (biochars) showed the smallest surface area, equal to 331 m2/g and 251 m2/g, and, hence, the lowest adsorption capacity. The highest adsorption capacity of MEK (3210 mg/g) and toluene (2618 mg/g) was recorded for chemically activated coffee grounds. Additionally, from the CO2 isotherms recorded at a low pressure (0.03 bar) and 0 °C, the maximum CO2 adsorption capacity was equal to 253 mg/g.
RESUMO
The enormous world demand for personal protective equipment to face the current SARS-CoV-2 epidemic has revealed two main weaknesses. On one hand, centralized production led to an initial shortage of respirators; on the other hand, the world demand for single-use equipment has had a direct and inevitable effect on the environment. Polylactide (PLA) is a biodegradable, biocompatible, and renewable thermoplastic polyester, mainly derived from corn starch. Electrospinning is an established and reproducible method to obtain nano- and microfibrous materials with a simple apparatus, characterized by high air filtration efficiencies. In the present work, we designed and optimized an open-source electrospinning setup, easily realizable with a 3D printer and using components widely available, for the delocalized production of an efficient and sustainable particulate matter filter. Filters were realized on 3D-printed PLA support, on which PLA fibers were subsequently electrospun. NaCl aerosol filtration tests exhibited an efficiency greater than 95% for aerosol having an equivalent diameter greater than 0.3 µm and a fiber diameter comparable to the commercially available FFP2 melt-blown face mask. The particulate entrapped by the filters when operating in real environments (indoors, outdoors, and working scenario) was also investigated, as well as the amount of heavy metals potentially released into the environment after filtration activity.
