Non-Ionizing Radiation Measurements for Trajectography Radars.

This work presents a Non-Ionizing Radiation (NIR) measurement campaign and proposes a specific measurement method for trajectography radars. This kind of radar has a high gain narrow beam antenna and emits a high power signal. Power density measurements from a C-band trajectography radar are carried out using bench equipment and a directional receiving antenna, instead of the commonly used isotropic probe. The measured power density levels are assessed for compliance test via comparison with the occupational and general public exposure limit levels of both the International Commission on Non-Ionizing Radiation Protection (ICNIRP) and the Brazilian National Telecommunication Agency (Anatel). The limit for the occupational public is respected everywhere, evidencing the safe operation of the studied radar. However, the limit for the general public is exceeded at a point next to the radar's antenna, showing that preventive measures are needed.

A New Planar Microwave Sensor for Building Materials Complex Permittivity Characterization.

A new microwave sensor is proposed to characterize the complex relative permittivity of building non-magnetic materials and used in the characterization of three concrete samples. The proposed sensor structure consists of a log-periodic planar antenna with microstrip elements tilted forward by an angle ß and printed, alternately, on the top and bottom sides of a dielectric layer. The operation principle is based on the measurement of the scattering parameters S11 and S21 in a free space propagation transmitter-receiver setup, for both cases with the material under test (MUT) sample (non-line-of-sight, NLOS) and without it (line-of-sight, LOS). A prototype is fabricated and measured to determine the scattering parameters of concrete samples. After measurements, the obtained results are used in the efficient and accurate Nicolson-Ross-Weir (NRW) method, making it possible to estimate the values of the complex relative permittivity of the concrete blocks. The sensor design is demonstrated from initial simulations to measurements for validation of the developed prototype. The obtained results for the complex relative permittivity of concrete are in agreement with those available in the literature and the difference between the simulated and measurement results for the sensor antenna resonant frequency is 4.71%. The used measurement setup can be applied to characterize different types of solid or liquid dielectric materials.

CSRR-Based Microwave Sensor for Dielectric Materials Characterization Applied to Soil Water Content Determination.

A new and compact sensor based on the complementary split-ring resonator (CSRR) structure is proposed to characterize the relative permittivity of various dielectric materials, enabling the determination of soil water content (SWC). The proposed sensor consists of a circular microstrip patch antenna supporting a 3D-printed small cylindrical container made out of Acrylonitrile-Butadiene-Styrene (ABS) filament. The principle of operation is based on the shifting of two of the antenna resonant frequencies caused by changing the relative permittivity of the material under test (MUT). Simulations are performed enabling the development of an empirical model of analysis. The sensitivity of the sensor is investigated and its effectiveness is analyzed by characterizing typical dielectric materials. The proposed sensor, which can be applied to characterize different types of dielectric materials, is used to determine the percentage of water contained in different soil types. Prototypes are fabricated and measured and the obtained results are compared with results from other research works, to validate the proposed sensor effectiveness. Moreover, the sensor was used to determine the percentage of water concentration in quartz sand and red clay samples.