RESUMO
BACKGROUND: Reorientating pelvic osteotomies are performed to prevent femoral-acetabular impingement or degenerative arthritis. A Toennis-Kalchschmidt triple pelvis innominate osteotomy is used in symptomatic patients. This study aimed to investigate the biomechanical behaviour of two different acetabular screw configurations for triple pelvis innominate osteotomy osteosynthesis. METHODS: Two screw-orientation techniques in rectangular os ilium osteotomy were compared by osteotomising 12 artificial hemipelvises with triple pelvis innominate osteotomy protocol (fragment reorientation: 10.5° inclination and 10.0° anteversion) and randomising them in 2 groups (n = 6) for implantation with three 4.5 mm screws. Bidirectional group had a bidirectional screw orientation and Monoaxial group had a monoaxial direction of all three screws through iliac crest. All specimens were tested under progressively increasing cyclic loading until failure. Group-wise comparisons of acetabular cup medialisation, anteversion and inclination were evaluated via motion tracking at cycles 250, 500, 750, 1000, 1250, 1500, 1750, 2000, 2250, and 2500. Failure was defined as reaching 5° inclination or 5° anteversion. FINDINGS: Acetabular cup medialisation (p ≤ 0.026), anteversion (p ≤ 0.021) and inclination (p ≤ 0.039) all increased significantly during testing in both groups. There were no significant differences for the group-wise comparisons at the cycle points defined in the methods (p ≥ 0.182). No significant differences were detected between groups for cycles to failure and failure load (p = 0.873). INTERPRETATION: Bidirectional screw alignment does not lead to significant advantages compared to pure monoaxial if all three axial screws are evenly distributed over the osteotomy geometry. The triple pelvis innominate osteotomy is susceptible to changes in anteversion, inclination and medialisation under partial weight-bearing. Cautious rehabilitation protocols are recommended.
