Electrically pumped quantum-dot lasers grown on 300 mm patterned Si photonic wafers.

Monolithic integration of quantum dot (QD) gain materials onto Si photonic platforms via direct epitaxial growth is a promising solution for on-chip light sources. Recent developments have demonstrated superior device reliability in blanket hetero-epitaxy of III-V devices on Si at elevated temperatures. Yet, thick, defect management epi designs prevent vertical light coupling from the gain region to the Si-on-Insulator waveguides. Here, we demonstrate the first electrically pumped QD lasers grown by molecular beam epitaxy on a 300 mm patterned (001) Si wafer with a butt-coupled configuration. Unique growth and fabrication challenges imposed by the template architecture have been resolved, contributing to continuous wave lasing to 60 °C and a maximum double-side output power of 126.6 mW at 20 °C with a double-side wall-plug efficiency of 8.6%. The potential for robust on-chip laser operation and efficient low-loss light coupling to Si photonic circuits makes this heteroepitaxial integration platform on Si promising for scalable and low-cost mass production.

Demonstration of large ionization coefficient ratio in AlAs0.56Sb0.44 lattice matched to InP.

The electron and hole avalanche multiplication characteristics have been measured in bulk AlAs0.56Sb0.44 p-i-n and n-i-p homojunction diodes, lattice matched to InP, with nominal avalanche region thicknesses of ~0.6 µm, 1.0 µm and 1.5 µm. From these and data from two much thinner devices, the bulk electron and hole impact ionization coefficients (α and ß respectively), have been determined over an electric-field range from 220-1250 kV/cm for α and from 360-1250 kV/cm for ß for the first time. The α/ß ratio is found to vary from 1000 to 2 over this field range, making it the first report of a wide band-gap III-V semiconductor with ionization coefficient ratios similar to or larger than that observed in silicon.

Comparative study of photoluminescence from In0.3Ga0.7As/GaAs surface and buried quantum dots.

The optical properties of In0.3Ga0.7As/GaAs surface quantum dots (SQDs) and buried QDs (BQDs) are investigated by photoluminescence (PL) measurements. The integrated PL intensity, linewidth, and lifetime of SQDs are significantly different from the BQDs both at room temperature and at low temperature. The differences in PL response, measured at both steady state and in transient, are attributed to carrier transfer between the surface states and the SQDs.