A compact-rigid multi-analyser for energy and angle filtering of high-resolution X-ray experiments. Part 2. Efficiency of a single-crystal-comb.

Diffraction instruments using filtering by one or several analyser crystals exist since the 1980s and 1990s at synchrotron radiation sources, but, due to its low efficiency, this filtering is little used on laboratory sources. In order to overcome this limitation, the efficiency of a small diffraction filtering multi-analyzer block (MAD block) realized with a `single-crystal-comb' curved on a rigid support is demonstrated here. The geometry of this curved surface is logarithmic spiral and is optimized to allow multi-filtering over a relatively important diffraction angular range and to be also applicable over an X-ray spectral range. The efficiency of such a small rigid-compact MAD block consisting of this single-crystal-comb generating 20-50 Si(111) single-crystal blades, associated with a block of Soller collimators, is demonstrated. The angle between each crystal is 0.1°, so the measurement range of the comb is 2-5°. The geometry of this system has been optimized for operation with a synchrotron X-ray source over an energy range of 22 keV to 46 keV and could be used with laboratory X-ray sources (Ag Kα1, 22.1 keV). This MAD block complements and exploits the qualities of the `photon-counting' detectors which have very low intrinsic noise. Their joint efficacy is supported by powder pattern measurements of a LaB6 reference sample and of several heterogeneous samples of cultural heritage materials, carried out at 22 keV on the D2AM beamline at the ESRF. Their signal-to-noise ratio is excellent (1000/1) and allows the detection thresholds of the measurements (from 3-1% to 0.1%) to detect minor phases in the studies of `real' heterogeneous materials to be drastically improved.

Implication of the SH3TC2 gene in Charcot-Marie-Tooth disease associated with deafness and/or scoliosis: Illustration with four new pathogenic variants.

The autosomal recessive demyelinating form of Charcot-Marie-Tooth can be due to SH3TC2 gene pathogenic variants (CMT4C, AR-CMTde-SH3TC2). We report on a series of 13 patients with AR-CMTde-SH3TC2 among a French cohort of 350 patients suffering from all type of inheritance peripheral neuropathy. The SH3TC2 gene appeared to be the most frequently mutated gene for demyelinating neuropathy in this series by NGS. Four new pathogenic variants have been identified: two nonsense variants (p.(Tyr970*), p.(Trp1199*)) and two missense variants (p.(Leu1126Pro), p.(Ala1206Asp)). The recurrent variant p.Arg954* was present in 62%, and seems to be a founder mutation. The phenotype is fairly homogeneous, as all these patients, except the youngest ones, presented scoliosis and/or hearing loss.

Bunch mode specific rate corrections for PILATUS3 detectors.

PILATUS X-ray detectors are in operation at many synchrotron beamlines around the world. This article reports on the characterization of the new PILATUS3 detector generation at high count rates. As for all counting detectors, the measured intensities have to be corrected for the dead-time of the counting mechanism at high photon fluxes. The large number of different bunch modes at these synchrotrons as well as the wide range of detector settings presents a challenge for providing accurate corrections. To avoid the intricate measurement of the count rate behaviour for every bunch mode, a Monte Carlo simulation of the counting mechanism has been implemented, which is able to predict the corrections for arbitrary bunch modes and a wide range of detector settings. This article compares the simulated results with experimental data acquired at different synchrotrons. It is found that the usage of bunch mode specific corrections based on this simulation improves the accuracy of the measured intensities by up to 40% for high photon rates and highly structured bunch modes. For less structured bunch modes, the instant retrigger technology of PILATUS3 detectors substantially reduces the dependency of the rate correction on the bunch mode. The acquired data also demonstrate that the instant retrigger technology allows for data acquisition up to 15 million photons per second per pixel.

Laparoscopic cholecystectomy and choledocholithiasis.

Between November 1990 and March 1991, five patients with cholelithiasis and associated choledocholithiasis were treated by laparoscopic cholecystectomy and common-bile-duct exploration (CBDE). Three patients had a successful CBDE, but in two common-bile-duct stones had to be extracted surgically. Two patients had formal laparoscopic CBDE, and three patients had CBDE performed through the cystic duct. All patients recovered from surgery without complication. Laparoscopic CBDE is difficult to perform because of lack of adequate instrumentation and limited experience. Although the authors do not recommend that this procedure be performed widely at present, they believe it will eventually replace many open CBDEs. The authors review the pertinent literature and evaluate diagnostic means for preoperative and peroperative detection of choledocholithiasis. They discuss the alternatives to laparoscopic CBDE, their advantages and disadvantages. Finally, they summarize their own policy with respect to laparoscopic CBDE.