Determination of traces of As, B, Bi, Ga, Ge, P, Pb, Sb, Se, Si and Te in high-purity nickel using inductively coupled plasma-optical emission spectrometry (ICP-OES).

A method has been developed for the determination of traces of arsenic, boron, bismuth, gallium, germanium, phosphorus, lead, antimony, selenium, silicon and tellurium in nickel matrix. The sample was dissolved in HClO4 (~ 150°C) and nickel was settled as crystalline nickelperchlorate [Ni(ClO4)2] on cooling. The mixture was ultrasonicated and after the separation of Ni(ClO4)2, analytes of interest were determined in the supernatant using ICP-OES. Similarly, it was also found that, after the dissolution of nickel in perchloric acid, when the solution temperature was maintained at ~ 100°C, long needle like crystals of nickel perchlorate were formed. The crystals were separated from the mixture and trace elements in the supernatant were determined using ICP-OES. In both methods the matrix removal was >99% and the recoveries of analytes were in the range 92-97%. The limits of detection for As, B, Bi, Ga, Ge, P, Pb, Sb, Se, Si and Te were found to be 0.18, 0.21, 0.07, 0.06, 0.25, 0.11, 0.09, 0.10, 0.17, 0.20 and 0.07 µg g(-1) respectively. The procedure was applied for the analysis of a standard reference material nickel oxide (SRM 761, Nickel Oxide No.1, NBS, USA) and the values obtained are in close agreement with the certified values.

Determination of trace phosphorus in zirconium-niobium alloy and Zircaloy by UV-vis spectrophotometry.

A spectrophotometric method has been developed for the determination of traces of phosphorus in zirconium based alloys (Zr-2.5Nb and Zircaloy). It is achieved by selective fluoride complexation controlled by boric acid. The samples were dissolved in HF and fluoro-complexes of the matrices were formed by maintaining the concentration of HF while the excess HF was controlled by boric acid. After the formation of phosphomolybdate, extracted into n-butyl acetate, ion-associated with crystal violet and the absorbance was measured at 582 nm. The results obtained by this procedure were in close agreement with the certified reference material (CRM) values and further these values were compared with the values determined by Glow Discharge-Quadrupole Mass Spectrometry (GD-QMS). The potential interferences like fluoride, silicon, arsenic(V), niobium, titanium, tantalum, etc., were tolerable to large level. LOD (3 s) was found to be 0.055 mg kg(-1) with a precision (R.S.D.) of 2-3% and molar absorptivity was 2.7x10(5) L mol(-1) cm(-1).

Determination of traces of chloride and fluoride in H2SO4, H3PO4 and H3BO3 by in situ analyte distillation-ion chromatography.

A simple dual vessel in situ analyte distillation (IAD) system has been developed for suppressed ion chromatographic determination of chloride and fluoride ions in complex matrices. In IAD system, water vapours generated from the outer vessel reacts with sulfuric acid generating heat, thus favouring the quantitative distillation of chloride and fluoride within 30 min on water bath temperature (approximately 80 degrees C). The distilled analytes, as their respective acids in water, were directly injected into an ion-chromatograph. This newly developed method has been applied for analysis of trace impurities in H2SO4, H3PO4 and H3BO3. The detection limits for chloride is 8, 80 and 70ppb (w/w) for H2SO4, H3PO4 and H3BO3, respectively. For fluoride the detection limits are 6 and 60 ppb (w/w) for H2SO4 and H3PO4, respectively. The recovery of spikes for both the analytes ranged between 87 and 100%.

In situ matrix evaporation by isothermal distillation of high-purity reagents for the determination of trace impurities by ion chromatography.

In situ matrix evaporation of high-purity acids based on isothermal distillation was achieved in a high-density polyethylene (HDPE) container on a water bath, to avoid contamination from the laboratory environment. The solubility of water and acid vapours in glycerol due to co-association was utilized to achieve complete evaporation. All major sources which contribute to the process blank were taken care of in a simple and effective way. A 50-fold preconcentration with >99.9% matrix removal was achieved for the analysis of low-boiling acids, HCl, HF, HNO3 and H2O2. The non-volatile ions NH4+, Li+, Na+, K+, Mg2+, Ca2+, SO4(2-) and PO4(3-) were determined by ion chromatograph with conductivity detection. The detection limits were 6-130 ng/l with recoveries of 85-110% for all ions studied.