RESUMO
The alveolar ridge reconstruction of vertical and combined bone defects is a non-predictable procedure with varying percentages of success. The greatest challenge for vertical and combined bone augmentation is to maintain mechanical stability of the bone graft; therefore, it is mandatory to provide and preserve space for bone regeneration. The development of biomaterials and 3D printing has enabled the use of polymer scaffolds in the reconstruction of alveolar ridge defects. The aim of this pilot study was to evaluate the mechanical characteristics of an innovative individualized biodegradable polylactic acid (PLA) scaffold, under dynamic conditions, simulating biodegradation and the influence of masticatory forces. After the design and 3D printing of PLA scaffolds, two groups of 27 scaffolds were formed according to the compression testing procedure. The compression tests were performed in occlusal and lateral directions. In each of the two groups, nine subgroups of three scaffolds were formed for different testing periods during in vitro degradation with a total period of 16 weeks. Results showed that biodegradation and load application had no significant influence on mechanical characteristics of tested scaffolds. It can be concluded that simulated masticatory forces and biodegradation do not significantly influence the mechanical characteristics of an individualized biodegradable augmentation scaffold.
RESUMO
PURPOSE: The aim of the present study was to determine whether plates with only 1 screw pair can be used for Le Fort I fracture management. Good postoperative results motivated the direct application of mandible fixation principles to the fractured midface region without additional experimental research. However, the amount and distribution of the forces in the midface region is different from those on the mandible. MATERIALS AND METHODS: Testing was conducted on plastic anatomic models. The validity of the experimental model was tested before the fixation techniques were compared. Standard miniplates and miniscrews were used for fixation of the maxilla. The model surface strain analysis was conducted using the noncontact object grating method, which enabled the surface strain measurement without direct influence on the measured model. RESULTS: In 2 screw pair fixation, the outer screw pair has little effect on the local strain distribution, but it lowers the contact forces along the crack. One screw pair fixation is stable enough for fixation, but it has a greater strain peak at the crack edges. CONCLUSION: Our results showed that 1 screw pair per plate was enough for stable fixation, and 2 or more screw pairs should only be used when the bone fragment at the fracture site cannot sufficiently transmit forces along the crack.