[Effects of moderate dose rosuvastatin on carotid plaque in patients with diabetes mellitus evaluated by magnetic resonance imaging].

Objective: To observe the effect of lipid regulating therapy on carotid atherosclerotic plaque in diabetic patients. Methods: The REACH study, conducted between March 2009 and February 2012, enrolled asymptomatic patients with magnetic resonance imaging (MRI) confirmed carotid atherosclerotic plaque, who had never taken lipid-lowering drugs. Patients were treated with a moderate dose of rosuvastatin for 24 months. Blood lipid levels were measured and carotid MRI was performed at baseline, 3 and 24 months after treatment. The volume of carotid wall and lipid-rich necrotic core (LRNC) were measured by image analysis software. This study retrospectively analyzed patients in the REACH study. Patients were divided into diabetes group and non-diabetic group. The changes of blood lipid level and MRI parameters of carotid atherosclerotic plaque were compared between the two groups and their correlation was analyzed. Results: A total of 38 patients with carotid atherosclerotic plaque were included in this study, including 13 patients (34.2%) in the diabetic group and 25 patients (65.8%) in the non-diabetic group. Baseline parameters were comparable between the two groups, except higher HbA1c level in diabetes group (P<0.05). Compared with baseline, the total cholesterol (TC), low density lipoprotein cholesterol (LDL-C) and triglyceride (TG) levels were significantly decreased at 3 and 24 months in both two groups (P<0.05). The change of high-density lipoprotein cholesterol (HDL-C) in diabetes group was not obvious, while it was significantly increased in non-diabetic group at 24 months ((1.38±0.33) mmol/l vs. (1.26±0.26) mmol/l, P<0.05). MRI results showed that the volume and percentage of LRNC remained unchanged at 3 months, slightly decreased at 24 months (64.86 (45.37, 134.56) mm3 vs. 75.76 (48.20, 115.64) mm3, P>0.05) and (15.84% (11.47%, 24.85%) vs. 16.95% (11.64%, 22.91%), P>0.05) in diabetic group. In non-diabetic group, the volume and percentage of LRNC were significantly decreased at 3 months (63.01 (44.25, 188.64) mm3 vs. 72.49 (51.91, 199.59) mm3, P<0.05) and (13.76% (8.81%, 27.64%) vs. 16.04% (11.18%, 27.05%), P<0.05) respectively. Both parameters further decreased to (55.63 (27.18, 179.40) mm3) and (12.71% (8.39%, 24.41%)) at 24 months (both P<0.05). Wall volume, lumen volume and percent wall volume (PWV) were not affected post therapy in both two groups(P>0.05). There were no correlations between the changes of plaque parameters including volume and percentage of LRNC, wall volume, lumen volume, PWV and the changes of blood lipid parameters (TC, LDL-C, HDL-C and TG) in 3 and 24 months (P>0.05). Conclusion: Lipid-lowering therapy possesses different effects on carotid atherosclerotic plaque in diabetic and non-diabetic patients, and the LRNC improvement is more significant in non-diabetic patients as compared to diabetic patients.

Simple co-electrodeposition of functionalized multi-walled carbon nanotubes/chitosan composite coating on mainspring for enhanced modulus of elasticity.

Co-electrodeposition of functionalized multi-walled carbon nanotubes (f-MWCNTs) with chitosan was performed on pieces of a stainless steel mainspring. Under moderate conditions, composite coatings with controllable thickness from a few hundred nanometers to tens of micrometers can be achieved. After coating an 8 microm composite layer on a piece of mainspring 120 microm thick (i.e. 6.7% increase in thickness), the Young's modulus of the mainspring was found to have increased by more than approximately 25%. Moreover, the coated mainsprings possess much stronger mechanical strength as demonstrated by fatigue tests. The significant enhancement of Young's modulus and intrinsic strength are mostly attributed to the effect exerted by the subtle combination of chitosan and MWCNT. In the current study, the intensive cross-linkages formed between the -COOH groups in f-MWCNTs and the hydroxyl (-OH) and amino (-NH2) groups in chitosan were exploited. The chitosan molecular chains and f-MWCNTs both chemically react and physically knot with each other, leading to a three-dimensional interlaced f-MWCNT/chitosan composite coating. The reported co-electrodeposition provides a simple approach to form a stable, reproducible and rigid f-MWCNTs composite coating, which leads to the realization of a high-performance mainspring with reinforced mechanical strength.