The influence of fluid shear on the structure and material properties of sulphate-reducing bacterial biofilms.

Biofilms of sulphate-reducing Desulfovibrio sp. EX265 were grown in square section glass capillary flow cells under a range of fluid flow velocities from 0.01 to 0.4 m/s (wall shear stress, tau(w), from 0.027 to 1.0 N/m(2)). In situ image analysis and confocal scanning laser microscopy revealed biofilm characteristics similar to those reported for aerobic biofilms. Biofilms in both flow cells were patchy and consisted of cell clusters separated by voids. Length-to-width ratio measurements (l(c):w(c)) of biofilm clusters demonstrated the formation of more "streamlined" biofilm clusters (l(c):w(c)=3.03) at high-flow velocity (Reynolds number, Re, 1200), whereas at low-flow velocity (Re 120), the l(c):w(c) of the clusters was approximately 1 (l(c):w(c) of 1 indicates no elongation in the flow direction). Cell clusters grown under high flow were more rigid and had a higher yield point (the point at which the biofilm began to flow like a fluid) than those established at low flow and some biofilm cell aggregates were able to relocate within a cluster, by travelling in the direction of flow, before attaching more firmly downstream.

The influence of fluid shear and AICI3 on the material properties of Pseudomonas aeruginosa PAO1 and Desulfovibrio sp. EX265 biofilms.

An understanding of the material properties of biofilms is important when describing how biofilms physically interact with their environment. In this study, aerobic biofilms of Pseudomonas aeruginosa PAO1 and anaerobic sulfate-reducing bacteria (SRB) biofilms of Desulfovibrio sp. EX265 were grown under different fluid shear stresses (tau g) in a chemostat recycle loop. Individual biofilm microcolonies were deformed by varying the fluid wall shear stress (tau w). The deformation was quantified in terms of strain (epsilon), and the relative strength of the biofilms was assessed using an apparent elastic coefficient (Eapp) and residual strain (epsilon r) after three cycles of deformation. Aluminium chloride (AlCl3) was then added to both sets of biofilm and the tests repeated. Biofilms grown under higher shear were more rigid and had a greater yield shear stress than those grown under lower shear. The addition of AlCl3 resulted in a significant increase in Eapp and also increased the yield point. We conclude that the strength of the biofilm is in part dependent on the shear under which the biofilm was grown and that the material properties of the biofilm may be manipulated through cation cross-linking of the extracellular polysaccharide (EPS) slime matrix.