Combining an Electrochemical Continuous Glucose Sensor With an Insulin Delivery Cannula: A Feasibility Study.

BACKGROUND: Combining a continuous glucose monitor with an insulin delivery cannula (CGM-IS) could benefit clinical outcomes. We evaluated the feasibility of a single-needle insertion electrochemical investigational CGM-IS (Pacific Diabetes Technologies, Portland, Oregon) in type 1 diabetes adults. METHODS: Following 48 hours run-in using a Medtronic 780G in manual mode with a commercial insulin set, 12 participants commenced insulin delivery using the CGM-IS. A standardized test meal was eaten on the mornings of days 1 and 4. Venous samples were collected every 10 minutes one hour prior to and 15 minutes post-meal for four hours. CGM-IS glucose measurements were post-processed with a single capillary blood calibration during warm-up and benchmarked against YSI. A Dexcom G6 sensor was worn post-consent to study end. RESULTS: Mean absolute relative difference (MARD) for the CGM-IS glucose measurements was 9.2% (484 paired data points). Consensus error grid revealed 88.6% within zone A and 100% in A + B. Mean (SD) % bias was -3.5 (11.7) %. There were 35 paired YSI readings <100 mg/dL cutoff and 449 ≥100 mg/dL with 81.4% within ±15 mg/dL or ±15%, and 89.9% within ±20 mg/dL or ±20%. Two cannula occlusions required discontinuation of insulin delivery: one at 70 hours post insertion and another during the day 4 meal test. Mean (SD) Dexcom glucose measurements during run-in and between meal tests was respectively 161.3 ± 27.3 mg/dL versus 158.0 ± 25.6 mg/dL; P = .39 and corresponding mean total daily insulin delivered by the pump was 58.0 ± 25.4 Units versus 57.1 ± 28.8 Units; P = .47. CONCLUSIONS: Insulin delivery and glucose sensing with the investigational CGM-IS was feasible. Longer duration studies are needed.

A Prospective Multicenter Clinical Performance Evaluation of the C-CGM System.

BACKGROUND: Continuous glucose monitors (CGMs) have had a significant impact on the management of diabetes mellitus. We present the results of a multinational evaluation of the Cascade CGM ("C-CGM") over 14 days of in-clinic and home use. METHOD: Each of the 57 enrolled type 1 diabetes mellitus and type 2 diabetes mellitus subjects wore 2 C-CGMs on the abdomen for 14 days. One part of the evaluation was the performance versus reference glucose values generated for 12 -hour in-clinic sessions on days 1, 4, 7, 10, and 14. Glucose blood samples were drawn every 15 minutes and analyzed with the Yellow Spring Instruments (YSI) 2300 glucose analyzer. The performance assessment on in-clinic days was based on paired YSI/CGM data points and on home-use days was based on paired fingerstick BGM (blood glucose monitoring)/CGM data points. RESULTS: A total of 17 823 CGM/YSI data points during in-clinic use was analyzed. The mean absolute relative difference for glucose values between 100 and 400 mg/dL (MARD) and mean absolute difference for values between 40 and 100 mg/dL (MAD) were 11.5% and 15.1 mg/dL, respectively. The system accuracy during home use was 12.7% and 15 mg/dL for MARD and MAD, respectively. There were no serious adverse events or infectious complications reported. A modified algorithm "Hybrid Algorithm" was used in a prospective analysis of the in-clinic data, resulting in a MARD of 9.9% and MAD of 14.5 mg/dL. CONCLUSIONS: The performance of the C-CGM device over 14 days meets the safety and efficacy standards of CGM systems for managing blood glucose levels in people with diabetes. This was further confirmed when the C-CGM system was given approval for CE Mark in October 2019.

A label-free fiber-optic Turbidity Affinity Sensor (TAS) for continuous glucose monitoring.

In this paper, we describe the concept of a novel implantable fiber-optic Turbidity Affinity Sensor (TAS) and report on the findings of its in-vitro performance for continuous glucose monitoring. The sensing mechanism of the TAS is based on glucose-specific changes in light scattering (turbidity) of a hydrogel suspension consisting of small particles made of crosslinked dextran (Sephadex G100), and a glucose- and mannose-specific binding protein - Concanavalin A (ConA). The binding of ConA to Sephadex particles results in a significant turbidity increase that is much greater than the turbidity contribution by the individual components. The turbidity of the TAS was measured by determining the intensity of light passing through the suspension enclosed within a small semi-permeable hollow fiber (OD: 220 µm, membrane thickness: 20 µm, molecular weight cut-off: 10 kDa) using fiber optics. The intensity of measured light of the TAS was proportional to the glucose concentration over the concentration range from 50mg/dL to 400mg/dL in PBS and whole blood at 37°C (R>0.96). The response time was approximately 4 min. The stability of the glucose response of the TAS decreased only slightly (by 20%) over an 8-day study period at 37°C. In conclusion, this study demonstrated proof-of-concept of the TAS for interstitial glucose monitoring. Due to the large signal amplitude of the turbidity change, and the lack of need for wavelength-specific emission and excitation filters, a very small, robust and compact TAS device with an extremely short optical pathlength could be feasibly designed and implemented for in-vivo glucose monitoring in people with diabetes.

Acute in vivo performance evaluation of the fluorescence affinity sensor in the intravascular and interstitial space in Swine.

OBJECTIVE: We assessed and compared the performance levels of a fiber-coupled fluorescence affinity sensor (FAS) for glucose detection in the intradermal tissue and intravascular bed during glucose clamping and insulin administration in a large animal model. RESEARCH DESIGN AND METHODS: The FAS (BioTex Inc., Houston, TX) was implanted in interstitial tissue and in the intravenous space in nondiabetic, anesthetized pigs over 6-7 h. For intradermal assessment, a needle-type FAS was implanted in the upper back using a hypodermic needle. For intravenous assessment, the FAS was inserted through a catheter into the femoral artery and vein. Blood glucose changes were induced by infusion of dextrose and insulin through a catheterized ear or jugular vein. RESULTS: Based on retrospective analysis, the mean absolute relative error (MARE) of the sensor in blood and interstitial tissue was 11.9% [standard deviation (SD) = ± 9.6%] and 23.8% (SD = ± 19.4%), respectively. When excluding data sets from sensors that were affected by exogenous insulin, the MARE for those sensors tested in interstitial tissue was reduced to 16.3% (SD = ± 12.5%). CONCLUSIONS: The study demonstrated that the performance level of the FAS device implanted in interstitial tissue and blood can be very high. However, under certain circumstances, exogenous insulin caused the glucose concentration in interstitial tissue to be lower than in blood, which resulted in an overall lower level of accuracy of the FAS device. How significant this physiological effect is in insulin-treated persons with diabetes remains to be seen. In contrast, the level of accuracy of the FAS device in blood was very high because of high mass transfer conditions in blood. While the use of the FAS in both body sites will need further validation, its application in critically ill patients looks particularly promising.

A human pilot study of the fluorescence affinity sensor for continuous glucose monitoring in diabetes.

OBJECTIVE: We report results of a pilot clinical study of a subcutaneous fluorescence affinity sensor (FAS) for continuous glucose monitoring conducted in people with type 1 and type 2 diabetes. The device was assessed based on performance, safety, and comfort level under acute conditions (4 h). RESEARCH DESIGN AND METHODS: A second-generation FAS (BioTex Inc., Houston, TX) was subcutaneously implanted in the abdomens of 12 people with diabetes, and its acute performance to excursions in blood glucose was monitored over 4 h. After 30-60 min the subjects, who all had fasting blood glucose levels of less than 200 mg/dl, received a glucose bolus of 75 g/liter dextrose by oral administration. Capillary blood glucose samples were obtained from the finger tip. The FAS data were retrospectively evaluated by linear least squares regression analysis and by the Clarke error grid method. Comfort levels during insertion, operation, and sensor removal were scored by the subjects using an analog pain scale. RESULTS: After retrospective calibration of 17 sensors implanted in 12 subjects, error grid analysis showed 97% of the paired values in zones A and B and 1.5% in zones C and D, respectively. The mean absolute relative error between sensor signal and capillary blood glucose was 13% [±15% standard deviation (SD), 100-350 mg/dl] with an average correlation coefficient of 0.84 (±0.24 SD). The actual average "warm-up" time for the FAS readings, at which highest correlation with glucose readings was determined, was 65 (±32 SD) min. Mean time lag was 4 (±5 SD) min during the initial operational hours. Pain levels during insertion and operation were modest. CONCLUSIONS: The in vivo performance of the FAS demonstrates feasibility of the fluorescence affinity technology to determine blood glucose excursions accurately and safely under acute dynamic conditions in humans with type 1 and type 2 diabetes. Specific engineering challenges to sensor and instrumentation robustness remain. Further studies will be required to validate its promising performance over longer implantation duration (5-7 days) in people with diabetes.

Preclinical in vivo study of a fluorescence affinity sensor for short-term continuous glucose monitoring in a small and large animal model.

BACKGROUND: The performance of a fiber-coupled fluorescence affinity sensor (FAS) was studied in vivo in small and large animal models, in order to assess its feasibility and safety for short-term glucose monitoring in humans. METHODS: Determination of interstitial glucose concentrations in skin tissue of hairless rats and small pigs was facilitated by measuring the fluorescence response of the implanted FAS over several hours and multiple days. Blood sugar changes in animals were induced by injections of insulin and dextrose. The Medtronic Minimed CGMS (Medtronic Diabetes, Northridge, CA) was used for comparison. RESULTS: The acute in vivo performance study of the fiber-coupled FAS showed that more than 96% of the paired FAS/venous blood glucose readings were in the clinically acceptable A and B regions of the Clarke Error Grid. Mean absolute relative difference (MARD) and root mean squared error (RMSE) values for small and large animal models were 18.5% and 19.8 mg/dL and 15.9% and 16.3 mg/dL, respectively. In comparison, MARD and RMSE for the Medtronic Minimed CGMS in small and large animal models were similar (in rats, 25.4% and 19.8 mg/dL, respectively; in pigs, 18.4% and 16.2 mg/dL, respectively). No instance of irritation or infection was observed at any implantation site. The in vivo performance of FAS over a 3-day period was successfully demonstrated in both animal models. CONCLUSIONS: Overall, the fiber-coupled FAS was safe, and its performance during 4-h and 3-day testing compared favorably to the commercially available Medtronic Minimed CGMS, indicating its potential value for diabetes management.