The Emirates Mars Mission (EMM) Emirates Mars InfraRed Spectrometer (EMIRS) Instrument.

The Emirates Mars Mission Emirates Mars Infrared Spectrometer (EMIRS) will provide remote measurements of the martian surface and lower atmosphere in order to better characterize the geographic and diurnal variability of key constituents (water ice, water vapor, and dust) along with temperature profiles on sub-seasonal timescales. EMIRS is a FTIR spectrometer covering the range from 6.0-100+ µm (1666-100 cm-1) with a spectral sampling as high as 5 cm-1 and a 5.4-mrad IFOV and a 32.5×32.5 mrad FOV. The EMIRS optical path includes a flat 45° pointing mirror to enable one degree of freedom and has a +/- 60° clear aperture around the nadir position which is fed to a 17.78-cm diameter Cassegrain telescope. The collected light is then fed to a flat-plate based Michelson moving mirror mounted on a dual linear voice-coil motor assembly. An array of deuterated L-alanine doped triglycine sulfate (DLaTGS) pyroelectric detectors are used to sample the interferogram every 2 or 4 seconds (depending on the spectral sampling selected). A single 0.846 µm laser diode is used in a metrology interferometer to provide interferometer positional control, sampled at 40 kHz (controlled at 5 kHz) and infrared signal sampled at 625 Hz. The EMIRS beamsplitter is a 60-mm diameter, 1-mm thick 1-arcsecond wedged chemical vapor deposited diamond with an antireflection microstructure to minimize first surface reflection. EMIRS relies on an instrumented internal v-groove blackbody target for a full-aperture radiometric calibration. The radiometric precision of a single spectrum (in 5 cm-1 mode) is <3.0×10-8 W cm-2 sr-1/cm-1 between 300 and 1350 cm-1 over instrument operational temperatures (<∼0.5 K NE Δ T @ 250 K). The absolute integrated radiance error is < 2% for scene temperatures ranging from 200-340 K. The overall EMIRS envelope size is 52.9×37.5×34.6 cm and the mass is 14.72 kg including the interface adapter plate. The average operational power consumption is 22.2 W, and the standby power consumption is 18.6 W with a 5.7 W thermostatically limited, always-on operational heater. EMIRS was developed by Arizona State University and Northern Arizona University in collaboration with the Mohammed bin Rashid Space Centre with Arizona Space Technologies developing the electronics. EMIRS was integrated, tested and radiometrically calibrated at Arizona State University, Tempe, AZ.

Extraformational sediment recycling on Mars.

Extraformational sediment recycling (old sedimentary rock to new sedimentary rock) is a fundamental aspect of Earth's geological record; tectonism exposes sedimentary rock, whereupon it is weathered and eroded to form new sediment that later becomes lithified. On Mars, tectonism has been minor, but two decades of orbiter instrument-based studies show that some sedimentary rocks previously buried to depths of kilometers have been exposed, by erosion, at the surface. Four locations in Gale crater, explored using the National Aeronautics and Space Administration's Curiosity rover, exhibit sedimentary lithoclasts in sedimentary rock: At Marias Pass, they are mudstone fragments in sandstone derived from strata below an erosional unconformity; at Bimbe, they are pebble-sized sandstone and, possibly, laminated, intraclast-bearing, chemical (calcium sulfate) sediment fragments in conglomerates; at Cooperstown, they are pebble-sized fragments of sandstone within coarse sandstone; at Dingo Gap, they are cobble-sized, stratified sandstone fragments in conglomerate derived from an immediately underlying sandstone. Mars orbiter images show lithified sediment fans at the termini of canyons that incise sedimentary rock in Gale crater; these, too, consist of recycled, extraformational sediment. The recycled sediments in Gale crater are compositionally immature, indicating the dominance of physical weathering processes during the second known cycle. The observations at Marias Pass indicate that sediment eroded and removed from craters such as Gale crater during the Martian Hesperian Period could have been recycled to form new rock elsewhere. Our results permit prediction that lithified deltaic sediments at the Perseverance (landing in 2021) and Rosalind Franklin (landing in 2023) rover field sites could contain extraformational recycled sediment.

Spatially Consistent High-Resolution Land Surface Temperature Mosaics for Thermophysical Mapping of the Mojave Desert.

Daytime and nighttime thermal infrared observations acquired by the ASTER and MODIS instruments onboard the NASA Terra spacecraft have produced a dataset that can be used to map thermophysical properties across large regions, which have implications on surface processes, thermal environments and habitat suitability for desert species. ASTER scenes acquired between 2004 and 2012 are combined using new mosaicking and data-fusion techniques to produce a map of daytime and nighttime land surface temperature with coverage exclusive of the effects of clouds and weather. These data are combined with Landsat 7 visible imagery to generate a consistent map of apparent thermal inertia (ATI), which is related to the presence of exposed bedrock, rocks, fine-grained sediments and water on the surface. The resulting datasets are compared to known geomorphic units and surface types to generate an interpreted mechanical composition map of the entire Mojave Desert at 100 m per pixel that is most sensitive to large clast size distinctions in grain size distribution.

Laser frequency stabilization and spectroscopy at 2051 nm using a compact CO2-filled Kagome hollow core fiber gas-cell system.

We describe a compact, all fiber, frequency stabilized diode laser system at 2051 nm using CO2 gas-filled Kagome Hollow Core Fiber (HCF), capable of tuning continuously over four transitions in 12C16O2: R(24), R(26), R(28), and R(30). This laser system has been designed for use in future space-based atmospheric monitoring using differential absorption lidar (DIAL). The fully spliced Kagome HCF gas cell is filled to 2 kPa CO2 partial pressure and we compare the observed CO2 lineshape features with those calculated using HITRAN, to quantify the properties of the CO2-filled fiber cell. In this first demonstration of Kagome HCF used in a fully sealed gas cell configuration for spectroscopy at 2 µm, we characterize the frequency stability of the locked system by beat frequency comparison against a reference laser. Results are presented for the laser locked to the center of the 12C16O2 R(30) transition, with frequency stability of ∼40 kHz or better at 1 s, and a frequency reproducibility at the 0.4-MHz level over a period of > 1 month. For DIAL applications, we also demonstrate two methods of stabilizing the laser frequency ~3 GHz from this line. Furthermore, no pressure degradation was observed during the ~15-month period in which frequency stability measurements were acquired.

A Complex Fluviolacustrine Environment on Early Mars and Its Astrobiological Potentials.

Chloride-bearing deposits and phyllosilicates-bearing units are widely distributed in the southern highlands of Mars, but these phases are rarely found together in fluviolacustrine environments. The study of the coexistence of these minerals can provide important insights into geochemistry, water activity, and ultimately the climate and habitability of early Mars. Here we use high-resolution compositional and morphological orbiter data to identify and characterize the context of diverse minerals in a Noachian fluviolacustrine environment west of Knobel crater (6.7°S, 226.8°W). The chlorides in this region are likely formed through the evaporation of brines in a closed topographic basin. The formation age of chlorides is older than 3.7 Ga, based on stratigraphic relationships identified and previously obtained crater retention ages. The timing of the alteration of basaltic materials to iron-magnesium smectites in relation to the chloride formation in this location is enigmatic and is unable to be resolved with currently available remote sensing data. Importantly, we find that this close relationship between these key minerals revealed by the currently available data details a complex and intimate history of aqueous activity in the region. Of critical importance are the evaporitic deposits as analogous terrestrial deposits have been shown to preserve ancient biosignatures and possibly even sustain microbial communities for hundreds of millions of years. These salts could have protected organic matter from ultraviolet radiation, or even allow modern habitable microenvironments in the shallow subsurface through periodic deliquescence. The high astrobiology potential of this site makes it a good candidate for future landed and sample return missions (e.g., the Chinese 2020 Mars mission).

Widespread distribution of OH/H2O on the lunar surface inferred from spectral data.

Remote sensing data from lunar orbiters have revealed spectral features consistent with the presence of OH or H2O on the lunar surface. Analyses of data from the Moon Mineralogy Mapper spectrometer onboard the Chandryaan-1 spacecraft have suggested that OH/H2O is recycled on diurnal timescales and persists only at high latitudes. However, the spatial distribution and temporal variability of the OH/H2O, as well as its source, remain uncertain. Here we incorporate a physics-based thermal correction into analysis of reflectance spectra from the Moon Mineralogy Mapper and find that prominent absorption features consistent with OH/H2O can be present at all latitudes, local times, and surface types examined. This suggests the widespread presence of OH/H2O on the lunar surface without significant diurnal migration. We suggest that the spectra are consistent with the production of OH in space weathered materials by the solar wind implantation of H+ and formation of OH at crystal defect sites, as opposed to H2O sourced from the lunar interior. Regardless of the specific composition or formation mechanism, we conclude that OH/H2O can be present on the Moon under thermal conditions more wide-ranging than previously recognized.

Absolute frequency measurement of a 1.5-microm acetylene standard by use of a combined frequency chain and femtosecond comb.

We have developed and characterized a pair of Doppler-free acetylene-stabilized diode laser frequency standards as optical communications references. The Allan deviation sigma/f of an individual system reaches a minimum of 4 x 10(-14) at a sampling time of 5000 s, and the long-term lock-point repeatability is found to be 0.4 kHz (one standard uncertainty), corresponding to a fractional uncertainty of 2 x 10(-12). Using a combination of a frequency chain and a self-referenced femtosecond comb, we have measured the frequency of line P(16) of the v1 + v3 overtone band of 13C2H2 to be 194,369,569,385.9 (3.0) kHz. The uncertainty of this number is limited solely by the reproducibility of the standards.