Ciprofibrate-Loaded Nanoparticles Prepared by Nanoprecipitation: Synthesis, Characterization, and Drug Release.

Ciprofibrate (CIP) is a highly lipophilic and poorly water-soluble drug, typically used for dyslipidemia treatment. Although it is already commercialized in capsules, no previous studies report its solid-state structure; thus, information about the correlation with its physicochemical properties is lacking. In parallel, recent studies have led to the improvement of drug administration, including encapsulation in polymeric nanoparticles (NPs). Here, we present CIP's crystal structure determined by PXRD data. We also propose an encapsulation method for CIP in micelles produced from Pluronic P123/F127 and PEO-b-PCL, aiming to improve its solubility, hydrophilicity, and delivery. We determined the NPs' physicochemical properties by DLS, SLS, ELS, SAXS and the loaded drug amount by UV-Vis spectroscopy. Micelles showed sizes around 10-20 nm for Pluronic and 35-45 nm for the PEO-b-PCL NPs with slightly negative surface charge and successful CIP loading, especially for the latter; a substantial reduction in ζ-potential may be evidenced. For Pluronic nanoparticles, we scanned different conditions for the CIP loading, and its encapsulation efficiency was reduced while the drug content increased in the nanoprecipitation protocol. We also performed in vitro release experiments; results demonstrate that probe release is driven by Fickian diffusion for the Pluronic NPs and a zero-order model for PEO-b-PCL NPs.

Controlling the formation and alignment of low molecular weight gel 'noodles'.

We show how to control the formation and alignment of gel 'noodles'. Nanostructure alignment can be achieved reproducibly by extensional deformation as the filaments form. Using a spinning technique, very long and highly aligned filaments can be made. The Young's moduli of the gel noodles are similar to that of a bulk gel. By using two syringe pumps in a concentric flow setup, we show that a filament-in-filament morphology can be created.

Design of a multipurpose sample cell holder for the Diamond Light Source high-throughput SAXS beamline B21.

The design of a multipurpose sample cell holder for the high-throughput (HT) beamline B21 is presented. The device is compatible with the robot bioSAXS sample changer currently installed on BM29, ESRF, and P12 Petra IV synchrotrons. This work presents an approach that uses 3D-printing to make hardware alterations which can expand the versatility of HT beamlines at low cost.