Cyclopentadienyl Molybdenum(II) Compounds Bearing Ether and Thioether Functions in the Side Chain: Synthesis, Characterization, and Cytotoxic/Cytostatic Studies.

A series of molybdenum(II) compounds [(η5 -Cp')Mo(CO)2 (L2 )][BF4 ] (Cp'=C5 H4 (CH2 )2 SPh, C9 H6 (CH2 )2 OMe, L2= N,N-chelating ligand) have been synthesized and characterized by spectroscopic and analytical methods including X-ray crystallography. The in vitro assay on human leukemia cells MOLT-4 has shown that the substitution in the π-ligand in combination with suitable N,N-chelating ligand can lead to species with cytotoxicity considerably higher than reported to cisplatin. Unusually high activity was observed for compounds bearing phenanthroline ligands [{η5 -C9 H6 (CH2 )2 OMe}Mo(CO)2 (3,4,7,8-Me4 phen)][BF4 ] (IC50 =0.7±0.3 µM) and [{η5 -C9 H6 (CH2 )2 OMe}Mo(CO)2 (4,7-Ph2 phen)][BF4 ] (IC50 values 0.8±0.4 µM).

Enhanced cytotoxicity of indenyl molybdenum(ii) compounds bearing a thiophene function.

A series of six indenyl molybdenum compounds bearing a thiophenyl function in the side chain were prepared and characterized by analytical and spectroscopic methods. The structures of [(η5-C9H6CH2C4H3S)(η3-C3H5)Mo(CO)2] and [(η5-C9H6CH2C4H3S)Mo(CO)2(bpy)][BF4] were determined by single-crystal X-ray diffraction. The compounds bearing N,N-chelating ligands exhibit increased cytotoxic activity against human leukemia cell lines MOLT-4; up to two orders of magnitude lower IC50 values were observed compared to analogues with unsubstituted indenyl, which clearly demonstrates the strong effect of the indenyl ligand modification on the biological activity of the molybdenum(ii) compounds. The highest cytostatic potential was observed for the complex bearing 4,7-diphenyl-1,10-phenanthtoline [(η5-C9H6CH2C4H3S)Mo(CO)2(Ph2phen)][BF4] with IC50 (MOLT-4) = 0.19 ± 0.02 µM. Detailed regulation of the molecular and cellular mechanism by this derivative was investigated on the lung carcinoma cell line A549 and compared with the lung fibroblast cell line MRC-5. Rather unusual differences in the effects on tumor and non-tumor cell lines provide a unique insight into the cytostatic action of molybdenum(ii) complexes.

Chemical composition of essential oils from plantago lanceolata L. leaves extracted by hydrodistillation.

Extensive traditional use of medical plants leads to research dealing with chemical composition of essential oils. The aim of this work was evaluation of quality of the essential oil and extending of the knowledge about chemical composition of essential oil from ribwort (Plantago lanceolata L.) and proportional representation of compounds. Extractions of essential oils from samples of ribwort were performed by hydrodistillation. GC-MS and GC-FID techniques were used for investigation of the qualitative and semi-quantitative content of aromatic compounds in the essential oils, respectively. Major aroma constituents of ribwort leaves were groups of fatty acids 28.0-52.1 % (the most abundant palmitic acid 15.3-32.0 %), oxidated monoterpenes 4.3-13.2 % (linalool 2.7-3.5 %), aldehydes and ketones 6.9-10.0 % (pentyl vinyl ketone 2.0-3.4 %) and alcohols 3.8-9.2 % (1-octen-3-ol 2.4-8.2 %). In relative high amount were identified apocarotenoids (1.5-2.3 %) which are important constituents because of their intense fragrant. The importance is in potential manufacture control of feedstocks before producing of food supplements.

Using headspace solid-phase microextraction for comparison of volatile sulphur compounds of fresh plants belonging to families Alliaceae and Brassicaceae.

In this study, an optimisation of extraction of sulphur volatile compounds (SVCs) has been performed using Central Composite Design. The conditions of the highest amount of eluated peaks and total peaks area have been treated. Factors such as coating of fiber for SPME (Solid Phase Microextraction), extraction temperature and extraction time have been optimised. The SVCs have shown the optimal extraction using a DVB/CAR/PDMS (divinylbenzene/carboxen/polydimethylsiloxane) fiber at 73 °C during 50 min. Furthermore, a pre-incubation step lasting 20 min at the extraction temperature has been used. In total, 12 samples have been investigated at the mentioned optimal conditions, eight from the Alliaceae and four from the Brassicaceae family. The highest number of SVCs (24) has been identified in the sample of chive. The most frequently identified compound found in 11 of 12 samples has been dimethyl trisulphide.

Solid-phase microextraction based method for determination of essential oils components in herbal beverages.

A method employing the direct immersion solid-phase microextraction followed by GC-MS analysis is presented for the determination of essential oils components in herbal tea infusions, i.e. their direct content in the liquid phase. The extraction performances were compared using five different microextraction fibres. Significant parameters affecting sorption process such as sample amount, sorption and desorption time and temperature, stirring speed, pH adjustment and effect of ionic strength were optimised and discussed. By optimising the key parameters, a detection limits (LOD = S/N × 3) for ten target marker compounds were obtained in the range from 5.3 to 48.2 ng/mL with recoveries ranged between 93.03 and 100.50%. Intra-day and inter-day repeatability at three concentration levels were found to be 1.1-15.3 and 7.2-15.5% RSD, respectively. Finally, the optimised procedure enabling a rapid and simple analysis of essential oils was applied for the direct determination of these compounds in ten herbal tea infusions.

Method validation for the determination of propellant components by Soxhlet extraction and gas chromatography/mass spectrometry.

A fast, sensitive, and accurate GC/MS method for the quantification of aliphatic nitroesters (ethylene glycol dinitrate, nitroglycerin, and triethylene glycol dinitrate) and aromatic amines (diphenylamine, 2-nitrodiphenylamine, and triphenylamine) in propellants was developed and validated. This method comprises a Soxhlet extraction step with dichloromethane, followed by separation on a capillary column MDN-5. Ionization of the analytes is carried out using electron ionization. The limit of quantification of the method was 1% w/w for aliphatic nitroesters and 0.1% w/w for aromatic amines (diphenylamine and triphenylamine). Values of repeatability and reproducibility for analyzed compounds were smaller than values of the maximum allowed tolerances of the Horwitz-equation RSD(max) and 2/3 RSD(max). Values of accuracy for selected compounds were below the acceptable threshold of 15% for all tested levels in the range of calibration curve excepting the lowest concentration of calibration curve for nitroglycerin and aromatic amines. During the validation of method, temperature instability in injection port of gas chromatograph and column was observed for 2-nitrodiphenylamine. Hence, it follows worse results of accuracy and linearity and 2-nitrodiphenylamine was not validated successfully.

Determination of 2-ethylhexyl nitrate in diesel fuel.

The aim of this study was to develop and validate fast and easily applicable GC/MS assay for the quantification of the substance that increases cetane number in diesel fuel (2-ethylhexylnitrate, 2-EHN). These requirements were fulfilled best by a headspace GC-MS assay with negative chemical ionization with methane (HS-GC/MS). Chromatographic separation is achieved using a DB5-MS capillary column after the addition of known amount of internal standard (o-nitrotoluene). The limit of detection was 0.009% v/v for 2-EHN and the limit of quantification was 0.03% v/v. The HS-GC/MS method was applied for the quantification of cetane improver in spiked diesel fuel and real diesel fuel. The method is linear over the studied range (0.03-0.3%, v/v), with satisfactory intra- and inter-assay precision, and the relative standard deviations are lower than 10%. Good accuracy is achieved with bias <10% at all levels tested.

Extraction of antioxidants from plants using ultrasonic methods and their antioxidant capacity.

The analytical method based on the HPLC coupled with UV detection (HPLC-UV) for the determination of selected antioxidants (i.e. esculetin, scopoletin, 7-hydroxycoumarine, rutin, xanthotoxin, 5-methoxypsoralen and quercetin) in plant material was developed. Two ultrasonic extraction methods for the isolation of these compounds from the plants such as Mentha longifolia L., Mentha spicata L., Ruta graveolens L., Achyllea millefolium L., Plantago lanceolata L. and Coriandrum sativum L. were used. Both of these methods, i.e. ultrasonic probe and ultrasonic bath, were optimised and compared to each other. For the proposed HPLC-UV method LOQ values in the range from 22.7 (xanthotoxin) up to 97.2 ng/mL (rutin) were obtained. For all extracts the antioxidant capacity based on the reduction of free 2,2-diphenyl-1-picrylhydrazyl (DPPH) radical was also determined. Obtained results ranged from 10.11 up to 73.50% of DPPH radical inhibition.

Comparison of supercritical fluid and Soxhlet extractions for the isolation of nitro compounds from soils.

Supercritical fluid extraction (SFE) with CO(2), a clean and rapid alternative to conventional Soxhlet extraction, was investigated for the extraction of nitro compounds from soil samples. Quantitative extraction by SFE was accomplished at a pressure of 25 MPa and an extraction temperature of 60 degrees C, for 30 min in dynamic mode and using acetonitrile as modifier, and the results were comparable with those obtained by acetonitrile Soxhlet extraction (3 h) for all soil samples. Extracts from these two procedures were analyzed by gas chromatography coupled with mass spectrometry. Quantitative reproducibility for SFE extracts was acceptable (RSD 2-10%), and the quantity of solvent was reduced from 160 mL for Soxhlet extraction to 5 mL in the case of SFE.

Headspace single-drop microextraction of herbal essential oils.

A method employing the headspace single-drop microextraction (HS-SDME) is presented for the determination of essential oils in dried herbal leaves. By optimising the key experimental parameters, a linear response for the individual target compounds was obtained in the concentration range from LOQ to 4 mg/mL (r(2) = 0.9912-0.9998), with LODs from 3.3 up to 20.5 microg per 100 g of dried leaves, and the repeatability within the RSD of 2.1-8.9%. The HS-SDME-based procedure, enabling a rapid and simple analysis of essential oils in herbs, was applied to selected real samples (nine essential oils in four different samples) in combination with GC-FID identification and quantification of the target volatiles.

Determination of nitrate esters in water samples Comparison of efficiency of solid-phase extraction and solid-phase microextraction.

This paper deals with comparison of efficiency of extraction techniques (solid-phase extraction, SPE and solid-phase microextraction, SPME) used for extraction of nitrate esters (ethyleneglycoldinitrate, EGDN and nitroglycerin, NG), representing the first step of the method of quantitative determination of trace concentrations of nitrate esters in water samples. EGDN and NG are subsequently determined by means of high-performance liquid chromatography with ultraviolet detection (HPLC-UV). Optimization of SPE and SPME conditions was carried out using model water samples. Seven SPE cartridges were tested and the conditions were optimized (type of sorbent, type and volume of solvent to be used as eluent). For both nitrate esters the limit of detection (LOD) and the limit of quantification (LOQ) obtained using SPE/HPLC-UV were 0.23 microg mL(-1) and 0.70 microg mL(-1), respectively. Optimization of SPME conditions: type of SPME fibre (four fibres were tested), type and time of sorption/desorption, temperature of sorption. PDMS/DVB (polydimethylsiloxane/divinylbenzene) fibre coating proved to be suitable for extraction of EGDN and NG. For this fibre the LOD and the LOQ for both nitrate esters were 0.16 microg mL(-1) and 0.50 microg mL(-1), respectively. Optimized methods SPE/HPLC-UV and SPME/HPLC-UV were then used for quantitative determination of nitrate esters content in real water samples from the production of EGDN and NG.