Equilibrium and kinetic studies on the removal of Acid Red 114 from aqueous solutions using activated carbons prepared from seed shells.

The use of low-cost and ecofriendly adsorbents has been investigated as an ideal alternative to the current expensive methods of removing dyes from wastewater. This paper deals with the removal of Acid Red 114 (AR 114) from aqueous solutions using activated carbons prepared from agricultural waste materials such as gingelly (sesame) (Sp), cotton (Cp) and pongam (Pp) seed shells. Optimum conditions for AR 114 removal were found to be pH 3, adsorbent dosage=3g/L of solution and equilibrium time=4h. Higher removal percentages were observed at lower concentrations of AR 114. The adsorption isotherm data were fitted to Langmuir and Freundlich equation, and the adsorption capacity of the studied adsorbents was in the order Sp>Cp>Pp. Kinetic studies showed that the adsorption followed both pseudo-second-order and Elovich equation. The thermodynamics parameters such as DeltaG degrees, DeltaH degrees, DeltaS degrees were also evaluated. The activated carbons prepared were characterized by FT-IR, SEM and BET analysis.

Production of biogas from municipal solid waste with domestic sewage.

In this study, experiments were conducted to investigate the production of biogas from municipal solid waste (MSW) and domestic sewage by using anaerobic digestion process. The batch type of reactor was operated at room temperature varying from 26 to 36 degrees C with a fixed hydraulic retention time (HRT) of 25 days. The digester was operated at different organic feeding rates of 0.5, 1.0, 2.3, 2.9, 3.5 and 4.3kg of volatile solids (VS)/m(3) of digester slurry per day. Biogas generation was enhanced by the addition of domestic sewage to MSW. The maximum biogas production of 0.36m(3)/kg of VS added per day occurred at the optimum organic feeding rate of 2.9kg of VS/m(3)/day. The maximum reduction of total solids (TS) (87.6%), VS (88.1%) and chemical oxygen demand (COD) (89.3%) occurred at the optimum organic loading rate of 2.9kg of VS/m(3)/day. The quality of biogas produced during anaerobic digestion process was 68-72%.

Surface ozone measurements at urban coastal site Chennai, in India.

The present study was carried out to gain knowledge of current surface ozone concentrations and the effects of meteorological parameters in the highly populated urban area of Chennai, in South India. We have reported measurement results of surface ozone (O(3)) and meteorological parameters from 17th March to 10th October 2005. A photometric ozone analyzer continuously recorded the ozone concentrations at this site. The present study deals with the statistical characteristics of daily and monthly mean ozone levels under different meteorological conditions. The highest ozone concentrations were recorded in ESE-SE sectors. The monthly mean concentrations were higher in May (23+/-14 ppb) and lower in April at this site (10+/-8 ppb). The maximum hourly ozone concentration reached 69 ppb on 21st April.

Air quality monitoring in Chennai, India, in the summer of 2005.

During the summer of 2005, concentrations of surface ozone (O(3)), oxides of nitrogen (NO(x)), respirrable suspended particulate matter (RSPM) and total suspended particulate matter (TSPM), relative humidity (RH), wind speed (WS) and wind direction (WD) were collected over successive periods of about 24 h at five sites. UV photometric ozone analyzer was used to measure the concentration of surface O(3). The study deals with the characteristics of hourly and daily mean surface O(3) under different climatic conditions, such as temperature, relative humidity, wind speed and wind direction and other pollutant concentrations. The maximum hourly O(3) concentration reached 53 ppb on 17th May. The ground-level O(3) concentration in Chennai varied between 2 and 53 ppb. The concentration of NO(x) and O(3) were below the prescribed limits. The TSPM values were exceeded the National Ambient Air Quality Standards (NAAQS) at Koyambedu, Mandaveli, Taramani and Vallalar Nagar study area.

Adsorption of acid dye onto organobentonite.

Removal of Acid Red 151 from aqueous solution at different dye concentrations, adsorbent doses and pH has been studied. The bentonite clay has been modified using cationic surfactants, which has been confirmed using XRD and FT-IR analyses. Experimental result has shown that the acidic pH favours the adsorption. The adsorption isotherms are described by means of Langmuir and Freundlich isotherms. The adsorption capacity has been found to be 357.14 and 416.66 mg g(-1) for the cetyldimethylbenzylammonium chloride-bentonite (CDBA-bent) and cetylpyridinium chloride-bentonite (CP-bent), respectively. Kinetic studies show that the adsorption followed second-order kinetics.