Parallel endodontic education via social media: An exploratory survey study.

There is insufficient research to evaluate social media's influence on endodontic education. Therefore, this study assessed the percentage of students utilising Facebook in their education and the factors influencing their engagement. A survey was conducted on dental students, interns and dentists undertaking specialist programmes. Categorical data were analysed using Fisher's Exact test and multiple pairwise comparisons. The significance level was set at p < 0.05. Responses were received from 801 participants, with 98.4% using Facebook for endodontic knowledge. Although most students knew that scientific evidence is not always provided, they still deemed such information valuable as it was a practical demonstration of clinical cases. Most students turn to Facebook for endodontic education to compensate for the gap between their academic education and clinical practice. The utilisation of social media for education can be a concerning phenomenon and should not be ignored by academic institutes.

Optimum Shaping Parameters of the Middle Mesial Canal in Mandibular First Molars: A Finite Element Analysis Study.

INTRODUCTION: This study investigated the effect of shaping parameters of 2 different configurations of middle mesial canals (MMCs) on the biomechanical behavior and life span of a mandibular first molar using finite element analysis (FEA). METHODS: A mandibular molar with an independent MMC and another with a confluent MMC were scanned via micro-computed tomography, and FEA models were produced. For each tooth, an intact model and 5 experimental models were produced that differed by parameters of how the MMC was shaped: unshaped MMC, 25/.04, 25/.06, 30/.04, and 30/.06. Cyclic loading of 50 N was applied on the occlusal surface in vertical and oblique scenarios, and the number of cycles until failure (NCF) was compared with the intact models. In addition, mathematical analyses evaluated the stress distribution patterns and calculated maximum von Mises and maximum principal stresses. RESULTS: For both the independent and confluent MMC models, shaping the MMC reduced the NCF. The lifelog percentage of models was inversely proportional with radicular shaping parameters during the vertical and oblique loading scenarios. The shaping size of 30/.06 resulted in lower lifelog percentage than the cases with shaping size of 25/.04 in both of the independent and confluent MMC models. For all models, oblique loading reduced NCF more than vertical loading. CONCLUSION: Shaping the MMC should be kept as conservative as 25/.04. Also, whether the MMC is independent or confluent is a deciding factor in whether to increase the apical diameter or the root canal taper when larger shaping parameters are needed.

Impact of Canal Taper and Access Cavity Design on the Life Span of an Endodontically Treated Mandibular Molar: A Finite Element Analysis.

INTRODUCTION: This study investigated the impact of different canal tapers and access cavity designs on the life span of endodontically treated mandibular first molars using the finite element method. METHODS: Finite element analysis was performed on simulated models with 3 access cavity designs (traditional, conservative, and truss). The mesial canals were prepared to either constant tapers of 25/.04 and 25/.06 or a variable taper corresponding to the cumulative canal preparation shapes of TruNatomy Prime (Dentsply Sirona, Charlotte, NC) and ProTaper Gold F2 (Dentsply Sirona). The distal canals in all models had a 40/.04 preparation. Using occlusal fingerprint analysis, all models were subjected to cyclic occlusal loading until model failure. The number of cycles until failure, the location of failure, stress distribution patterns, and the maximum von Mises stresses were assessed. RESULTS: The traditional access models showed a lower life span than the conservative and truss models regardless of the canal taper, whereas there was not a notable difference in the conservative and truss models. The stresses migrated apically along the root surface and remarkably on the mesial aspect of the mesial root and the furcation area's outer surface. After root canal preparation with different tapers, there were no evident changes in the pattern and magnitude of the stresses distributed along the root surface. CONCLUSIONS: The life span of the tooth is affected more significantly by the access cavity design than the root canal preparation taper. Because stress patterns migrate apically rather than concentrate in the pericervical area, crack initiation and propagation might occur anywhere on the root surface.

An Arithmetic Crown-down Dynamic Tactile Instrumentation Technique: A Case Report of an S-shaped Root Canal.

The preparation of severely curved S-shaped double-curved root canals can be technically challenging. A novel root canal instrumentation technique is proposed, which modifies 2 techniques: the McSpadden crown-down technique and the tactile controlled activation technique. In the McSpadden crown-down technique, the root canal is divided into 2 portions: the coronal zone and the apical zone. However, rather than focusing on the length of file engagement, a formula is proposed to calculate the maximum insertion depths of higher tapered instruments to prevent overflaring of the canal and preserve pericervical dentin. Tactile-controlled activation involves activating martensitic nickel-titanium rotary files upon engagement and then immediately withdrawing the files. The proposed technique recommends 3 apical strokes after the initial engagement before withdrawal to minimize instrumentation time. This novel technique is described in a case report involving the management of an S-shaped double-curved maxillary lateral incisor. The technique presents a new method of crown-down instrumentation that prevents overflaring and avoids instrument separation.

Brain responses to auditory oddball task in children with benign childhood epilepsy with centrotemporal spikes: Quantitative analysis and correlation with neuropsychological assessment scores.

OBJECTIVE: Variable degrees of cognitive dysfunction have been reported in children with benign childhood epilepsy with centrotemporal spikes (BCECTS). Our aim was to perform quantitative analyses of the brain responses to cognitive tasks using event-related desynchronization (ERD) and event-related synchronization (ERS) and correlating the results with the scores of neuropsychological tests in patients with BCECTS. METHODS: This case control study included 30 patients with BCECTS and 20 controls. Clinical assessment, neuropsychological tests, the Positive wave at 300 msec (P300) parameters recording, and quantitative electroencephalography (EEG) analysis were carried out for both groups. Alpha power ERD and ERS were measured in six different brain regions during an auditory oddball paradigm. RESULTS: Children with epilepsy showed a statistically significant poorer performance in verbal intelligence quotient (IQ), performance IQ, and total scale IQ and lower number of correct responses. Moreover, both groups showed diffuse alpha power attenuation in response to the target tones. After summation of the alpha power ERD over all brain regions to get the net diffuse ERD, the patients' group showed a statistically significant smaller net alpha ERD compared with that of the control group (P=0.001). No significant correlations between the alpha ERD percentage, recorded P300 parameters, and neuropsychological tests scores were found. CONCLUSIONS: Children with BCECTS have subtle cognitive dysfunction proved by significantly lower scores of verbal IQ and performance IQ subtests. The significantly smaller net diffuse alpha power ERD detected in children with epilepsy may be an electrophysiological indicator of disruptive brain activation in relation to cognitive attentional tasks; however, its correlation with neuropsychological tests was insignificant.