High-Q Tuneable 10-GHz Bragg Resonator for Oscillator Applications.

This paper describes the design, simulation, and measurement of a tuneable 9.365-GHz aperiodic Bragg resonator. The resonator utilizes an aperiodic arrangement of non ( /4) low-loss alumina plates ( , loss tangent of to ) mounted in a cylindrical metal waveguide. Tuning is achieved by varying the length of the center section of the cavity. A multi-element bellows/probe assembly is presented. A tuning range of 130 MHz (1.39%) is demonstrated. The insertion loss varies from -2.84 to -12.03 dB while the unloaded Q varies from 43 788 to 122 550 over this tuning range. At 10 of the 13 measurement points, the unloaded Q exceeds 1 00 000, and the insertion loss is above -7 dB. Two modeling techniques are discussed; these include a simple ABCD circuit model for rapid simulation and optimization and a 2.5-D field solver, which is used to plot the field distribution inside the cavity.

High Q printed helical resonators for oscillators and filters.

High Q compact printed helical resonators which operate from around 1.8 to 2 GHz are described. These consist of a multilayer printed circuit board (PCB) incorporating a printed helical transmission line. Loss in the via hole is reduced by ensuring that the standing wave current at this point is near zero. This ensures a significant increase in Q. Further increased energy storage per unit volume is achieved due to the 3-D helical nature of the resonator. Unloaded Qs of 235 and 195 have been obtained on low loss PCBs with dielectric constants of 2.2 and 10.5, respectively. Two applications for these resonators are described in this paper. The first is the design of a compact low noise oscillator where the ratio of QL/Q0, and hence insertion loss, is adjusted for low noise. The 2-GHz oscillator demonstrates a phase noise of -120 dBc/Hz at 10 kHz which is predicted exactly by the theory. The second is a three-section filter designed to offer the response required by the front end filter of a modern GSM mobile telephone. In the filter design three helical resonators are coupled together to produce a completely printed triplate bandpass filter.

Reduced transposed flicker noise in microwave oscillators using gaas-based feedforward amplifiers.

Transposed flicker noise reduction and removal is demonstrated in 7.6 GHz microwave oscillators for offsets greater than 10 kHz. This is achieved by using a GaAs-based feedforward power amplifier as the oscillation-sustaining stage and incorporating a limiter and resonator elsewhere in the loop. 20 dB noise suppression is demonstrated at 12.5 kHz offset when the error correcting amplifier is switched on. Three oscillator pairs have been built. A transmission line feedback oscillator with a Qo of 180 and two sapphire-based, dielectric resonator oscillators (DROs) with a Qo of 44,500. The difference between the two DROs is a change in the limiter threshold power level of 10 dB. The phase noise rolls-off at (1/f)(2) for offsets greater than 10 kHz for the transmission line oscillator and is set by the thermal noise to within 0-1 dB of the theoretical minimum. The noise performance of the DROs is within 6-12 dB of the theory. Possible reasons for this discrepancy are presented.