The application of rapid prototyping to improve bone reconstruction in immediate dentoalveolar restoration: a case report.

PURPOSE: This article describes the use of rapid prototyping (RP) for diagnosis, planning, and execution of the reconstruction of hard and soft tissue in socket defects using immediate dentoalveolar restoration (IDR). SUMMARY: In cases of tissue loss in anterior dental areas, esthetic rehabilitation poses a major challenge with respect to treatment planning with the goal of long-term tissue maintenance. The IDR technique consists of immediate reconstruction in a single procedure of bone and soft tissue around implants placed immediately after extraction, and prosthetic rehabilitation. As this procedure is immediate and flapless, the correct diagnosis of tissue loss and correct graft adaptation are mandatory. RP can increase the precision of the procedure, as demonstrated using a clinical case characterized by total loss of the buccal bone wall and gingival recession. The results were evaluated by clinical assessment, photography, radiography, cone beam computed tomography (CBCT), and prototyping. CONCLUSION: The application of RP facilitated the execution of IDR as it enabled more accurate diagnosis of the socket defect and more precise adaptation of the tissue graft. A clinical study should be conducted to evaluate the effects of RP on the clinical results of the IDR technique.

Effect of Steam Autoclaving on the Tensile Strength of Resin Cements Used for Bonding Two-Piece Zirconia Abutments.

The purpose of this study was to evaluate the effects of steam autoclave sterilization on the tensile strength of two types of resin cements used to bond customized CAD/CAM zirconia abutments onto titanium bases. Forty sets of zirconia abutments cemented to screwed titanium bases of implants analogs were divided into 4 groups (n = 10). Two groups were treated with a conventional chemically activated resin cement (ML, Multilink Ivoclar Vivadent) and the other two groups with a self-adhesive dual resin cement (RelyX U200, 3M ESPE). One group from each cement was submitted to steam autoclaving. The autoclave sterilization cycle was performed after 72 hours of cementation for 15 minutes at 121°C and 2.1 Kgf/cm2. The samples were subjected to tensile strength testing in a universal testing machine (200 Kgf, 0.5 mm/min), from which the means and standard deviations were obtained in Newtons. Results showed (via ANOVA and Tukey's test; α = 0.05) that in the absence of steam autoclaving, no difference was observed in tensile strength between the cements tested: ML: 344.87 (93.79) and U200: 280 (92.42) (P = .314). Steam autoclaving, however, significantly increased tensile strength for the ML: 465.42 (87.87) compared to U200: 289.10 (49.02) (P < .001). Despite the significant increase in the ML samples (P = .013), autoclaving did not affect the tensile strength of the U200 samples (P > 0.05). The authors concluded that steam autoclaving increases the mean tensile strength of the chemically activated cement compared to the dual-cure self-adhesive cement. The performance of both cements evaluated was similar if the sterilization step was disconsidered.

Immediate implant placement, reconstruction of compromised sockets, and repair of gingival recession with a triple graft from the maxillary tuberosity: a variation of the immediate dentoalveolar restoration technique.

Immediate implant placement into compromised sockets is challenging for clinicians. The 3-dimensional implant position, status of the buccal bone wall, and regeneration of the soft tissue contours all affect adequate esthetic and functional results. This clinical report presents a treatment protocol (a variation of the immediate dentoalveolar restoration concept) consisting of immediate implantation and the reconstruction of the buccal bone wall and gingival recession in a single procedure with a triple graft (cancellous and cortical bone and soft tissue graft).