A fabric denuder for sampling semi-volatile species.

A new style of diffusion denuder has been evaluated specifically for sampling HNO3. A coated fabric is used as the denuder substrate, which can be loaded directly into a standard filter holder. This approach allows direct denuder sampling with no additional capital costs over filter sampling and simplifies the coating and extraction process. Potential denuder materials and coatings were evaluated in the laboratory to test the removal efficiency. NaCl coatings were used to assess more than 20 materials for HNO3 collection efficiency. Particle retention, which would cause a denuder to have a positive bias for gas concentration measurements, was evaluated by ambient air sampling using particulate sulfate as the reference aerosol. Particle retention varied from 0 to 15%, depending on the denuder material tested. The best performing material showed an average particle retention of less than 3%. Denuder efficiency of four fabric materials was tested under ambient conditions to determine removal efficiency. The fabric denuder method was compared with a long path-length Fourier transform infrared (FTIR) spectrometer, a tunable diode laser absorption spectrometer (TDLAS), and a denuder difference sampler to independently measure HNO3. HNO3 collection efficiency was typically 90% for the denuders, whether coated with NaCl or not. For 10-L/min sampling rates with the fabric denuder, the square of the correlation coefficient with the FTIR spectrometer was 0.73, compared to 0.24 with the TDLAS.

Evaluation of watering to control dust in high winds.

A field study was conducted to determine the effectiveness of watering in controlling PM10 emissions under high wind conditions. The focus of the study was the pickup of soil by a belly scraper at a landfill. Four low-volume PM10 samplers were positioned downwind of the storage pile (at two distances, 80 and 110 m, and two elevations, 1 and 3 m) and one was located upwind at 3 m elevation. Integrating nephelometers, which measure the particulate light scattering coefficient, bsp, were also set up at locations 80 and 110 m downwind of the storage pile. Wind speed and direction were measured on-site. Samples were collected for two periods, one with and one without water being applied. Watering was effective at reducing PM10 emissions at wind speeds up to the maximum 18 m sec-1 observed at the landfill soil pickup operation. Measurement of bsp provided an indication of PM10 concentrations with better time resolution than samplers, but not with sufficient resolution, under the instrumental conditions used, to correlate with wind gusts.

Determination of PM10 emission rates from street sweepers.

The use of street sweepers to clean paved roads, particularly after high-wind events, has been proposed as a PM10 control method. Using an artificial tunnel, the emission rates for several street sweepers were quantified under actual operating conditions. The tunnel was a tent enclosure, 6.1 x 4.3 x 73 m, open on both ends. PM10 concentrations were measured at the inlet and outlet while a sweeper removed sand deposited along the length. Measurements were made using a specialized low-volume filter sampler and an integrating nephelometer. The volume of air passing through the tunnel was measured by releasing an inert tracer, sulfur hexafluoride, at the inlet and measuring its concentration at the outlet. A large difference in emission rates between vacuum-type sweepers was observed, with rates varying from 5 to 100 mg m-1 swept. For the cleanest sweepers, the background rates (collected by sweeping clean pavement) were about half of the total PM10 emission rate. These background emission rates likely were from diesel exhaust; background rates for the single gasoline-powered sweeper were below detection. Particle light scattering data confirmed the filter collection results. The artificial tunnel approach would be useful in measuring total emissions from other mobile and stationary sources.

Atmospheric reactions of polycyclic aromatic hydrocarbons: facile formation of mutagenic nitro derivatives.

Directly active mutagens are formed on exposure of the promutagen benzo[a]pyrene to gaseous pollutants in smog. In simulated atmospheres containing 1 part per million nitrogen dioxide and traces of nitric acid, directly mutagenic nitro derivatives are readily formed from both benzo[a]pyrene and perylene, a non-mutagen in the Ames reversion assay. Possible formation of direct mutagens by such reactions on sample collection filters, in exhaust effluents, and in the atmosphere should be recognized.

Enhancement of photochemical smog by n,n'-diethylhydroxylamine in polluted ambient air.

A recent proposal for controlling photochemical smog by the addition to ambient air of 0.03 to 0.05 part per million of diethylhydroxylamine (DEHA) is shown to be invalid. The addition of DEHA in the range of 0.05 to 0.5 part per million to ambient air irradiated with sunlight in a dual outdoor environmental chamber caused marked increases in the rates of formation and concentrations of ozone, peroxyacetyl nitrate, and light-scattering particles.