Compositional analysis of copper and iron-based alloys using LIBS coupled with chemometric method.

The present manuscript deals with the utility of the calibration-free LIBS and calibration curve methods for the compositional study of different alloys using laser-induced breakdown spectroscopy (LIBS). In the process of alloying in the smelting industry, metal concentration in different alloys affects the physical and chemical properties of the final products. Therefore, LIBS can be used as an efficient quantitative analysis tool for online monitoring of the quality of the products. This is because LIBS can be performed online, in situ, without any pre-processing, and need no sample preparation for the compositional analysis of any type of materials present in any phase (solid, liquid, gas or even molten alloys in the industries). In the present study, four alloys (three copper and one iron-based alloy) consisting of Cu, Al, Zn, Ni, Fe, Cr and Mn as major and Sn and Si as minor elements were selected for the study using calibration-free laser-induced breakdown spectroscopy (CF-LIBS) and calibration curve method i.e. partial least square regression (PLSR). For the CF-LIBS method, the temporal delay has been optimized in order to satisfy the optically thin and local thermal equilibrium (LTE) condition of the plasma. For the PLSR method, different regions of the strongest emission lines of constituents have been selected for quantitative analysis. The study of time-resolved LIBS spectra and the variation of plasma parameters with respect to the delay time is also discussed. The utility of the combined technique of CF-LIBS with the PLSR method for rapid monitoring and quality assessment of desired material/products without any sample pretreatment, thus reducing the cost of the analysis, is presented in this paper.

Evaluation of intrahepatic and extrahepatic biliary tree anatomy and its variation by magnetic resonance cholangiopancreatography in Odisha population: a retrospective study.

Intrahepatic and extrahepatic anatomical knowledge is essential for pre procedural planning of liver transplantation, liver resection, complex biliary reconstruction and radiological biliary tree intervention. Indian data of biliary anatomy and its variation is scant in literature. The aim of our study is to find out the prevalence of common and uncommon pattern of biliary tree anatomy in magnetic resonance cholangiopancreatography (MRCP) in our population. A total of 1,038 cases of MRCP of population of Odisha were obtained from Picture Archiving and Communication System of the department and were reviewed by two senior radiologists for anatomical pattern and variations. The typical and most common pattern of right hepatic duct (RHD) branching was seen in 72.8% cases. The most common variant of RHD was trifurcation pattern of insertion of right anterior sectoral duct (RASD), right posterior sectoral duct and left hepatic duct (LHD) forming common hepatic duct (CHD) in 11.3% of cases. The common trunk of segment (SEG) II and III ducts joining the SEG IV duct was the most common LHD branching pattern in 90.3% of cases. The most common pattern of cystic duct was posterior insertion to middle third of CHD (42.8%). MRCP is the non-invasive imaging modality for demonstration of biliary duct morphology to prevent iatrogenic injury during hepatobiliary intervention and surgery.