Deconfinement leads to changes in the nanoscale plasticity of silicon.

Silicon crystals have an important role in the electronics industry, and silicon nanoparticles have applications in areas such as nanoelectromechanical systems, photonics and biotechnology. However, the elastic-plastic transition observed in silicon is not fully understood; in particular, it is not known if the plasticity of silicon is determined by dislocations or by transformations between phases. Here, based on compression experiments and molecular dynamics simulations, we show that the mechanical properties of bulk silicon and silicon nanoparticles are significantly different. We find that bulk silicon exists in a state of relative constraint, with its plasticity dominated by phase transformations, whereas silicon nanoparticles are less constrained and display dislocation-driven plasticity. This transition, which we call deconfinement, can also explain the absence of phase transformations in deformed silicon nanowedges. Furthermore, the phenomenon is in agreement with effects observed in shape-memory alloy nanopillars, and provides insight into the origin of incipient plasticity.

A criterion for dewetting initiation from surface disturbances on ultrathin polymer films.

Nanoindentation-induced defects on ultrathin (h = 17 nm) polystyrene (PS) films that are spin cast on silicon (Si) substrates, with residual depths of penetration lower than the film thickness (<17 nm), can either grow to initiate dewetting or level, which results in a flat polymer surface, upon heating above the glass-transition temperature (T(g)). The excess surface energy (DeltaF(gamma)) of the system, which is added to the initially flat coating with the formation of an indent, provides a critical value, DeltaF(gamma,crit) = 6.1 x 10(-16) J, which determines indent evolution upon annealing. An indent grows when DeltaF(gamma) > DeltaF(gamma,crit) and levels when DeltaF(gamma) < DeltaF(gamma,crit). This conclusion is in agreement with previous reports, which used DeltaF(gamma) to distinguish the two (dewetting/leveling) opposing processes (1) in the case of indents deeper than the film thickness and (2) in the case of built-in ordered surface disturbances by capillary force lithography.

Aqueous latex/ceramic nanoparticle dispersions: colloidal stability and coating properties.

The effect of pH on the colloidal stability of aqueous dispersions containing antimony-doped tin oxide (ATO) or indium tin oxide (ITO) nanoparticles and poly(vinyl acetate-acrylic) copolymer (PVAc-co-acrylic) latex particles was investigated using experimental observations and Derjiaguin, Landau, Verwey and Overbeek (DLVO) theory. The microstructure, electrical properties and optical properties of composite coatings prepared from various dispersions were also studied. Zeta potential measurements revealed that the isoelectric point (IEP) of ATO nanoparticles was below pH 2.0, that of ITO nanoparticles was at pH approximately 6.0 and that of PVAc-co-acrylic latex was at pH approximately 2.0. ATO/PVAc-co-acrylic dispersions prepared at pH 3 were stable, but those prepared at pH 1.5 formed aggregates, which settled quickly with time. DLVO theory predictions are in accord with these results. Stable ITO/PVAc-co-acrylic dispersions are obtained at a pH of 3.0 and 11.0, but dispersions are not stable at a pH of 6.0, the IEP of ITO. At a pH of 3.0, DLVO results predict attraction between ITO particles and latex particles. Dispersion pH affected the microstructures and properties of ATO (or ITO)/PVAc-co-acrylic coatings. Suspensions that formed aggregates produced coatings with lower percolation thresholds and lower transparencies than those produced from stable suspensions.