High-resolution intracranial and cervical MRA at 3.0T: technical considerations and initial experience.

Initial experience with intracranial and cervical MRA at 3.0T is reported. Phantom measurements (corrected for relaxation effects) show S/N (3.0T) = 2.14 +/- 0.08 x S/N (1.5T) in identical-geometry head coils. A 3.0T 3DTOF intracranial imaging protocol with higher-order autoshimming was developed and compared to 1.5T 3DTOF in 12 patients with aneurysms. A comparison by two radiologists showed the 3.0T to be significantly better (P < 0.001) for visualization of the aneurysms. The feasibility of cervical and intracranial contrast enhanced MR angiography (CEMRA) at 3.0T is also examined. The relaxivity of the gadolinium contrast agent decreases by only about 4-7% when the field strength is increased from 1.5 to 3.0T. Cervical 3.0T CEMRA was obtained in eight patients, two of whom had 1.5T studies available for direct comparison. Image comparison suggests 3.0T to be a favorable field strength for cervical CEMRA. Voxel volumes of 0.62-0.73 mm(3) (not including zero-filling) were readily achieved at 3.0T with the use of a single-channel transmit-receive head or cervical coil, a 25 mL bolus of gadoteridol, and a 3D pulse sequence with a 66% sampling efficiency. This spatial resolution allowed visualization of intracranial aneurysms, carotid dissections, and atherosclerotic disease including ulcerations. Potential drawbacks of 3.0T MRA are increased SAR and T(*)(2) dephasing compared to 1.5T. Image comparison suggests signal loss due to T(*)(2) dephasing will not be substantially more problematic than at 1.5T. The dependence of RF power deposition on TR for CEMRA is calculated and discussed.

Magnetic resonance angiography at 3.0 Tesla: initial clinical experience.

Magnetic resonance (MR) angiography has undergone significant development over the past decade. It has gone from being a novelty application of MR with limited clinical use to replacing catheter angiography in some clinical applications. One of the principal limitations inherent to all MR angiographic techniques is that they remain signal limited when pushed to the limits of higher resolution and short acquisition time. Developments in magnetic gradient hardware, coil design, and pulse sequences now are well optimized for MR angiography obtained at 1.5-T main magnetic field (B-field) strength, with acquisition times and imaging matrix size near their optimal limits, respectively. Recently, the United States Food and Drug Administration (FDA) approved use of clinical magnetic resonance imaging with main magnetic field strengths of up to 4 T. Before FDA approval, use of MR with magnetic field strengths much greater than 1.5 T was essentially reserved for investigational or research applications. The main advantage of high B-field imaging is a significant improvement in the signal-to-noise ratio (SNR), which increases in an approximately linear fashion with field strength in the range of 1.5 to 3.0 T. This increased SNR is directly available when performing MR angiographic acquisitions at higher magnetic field strengths, allowing for better resolution and conspicuity of vessels with similar acquisition times. Little has been reported on the benefits of performing MR angiography at magnetic field strengths >1.5 T. The purpose of this article is to summarize our current experience with intracranial and cervical MR angiographic techniques at 3.0 T.