RESUMO
Background The primary objective of this study was to test interobserver reliability when classifying fractures by consensus by AO types and groups among a large international group of surgeons. Secondarily, we assessed the difference in inter- and intraobserver agreement of the AO classification in relation to geographical location, level of training, and subspecialty. Methods A randomized set of radiographic and computed tomographic images from a consecutive series of 96 distal radius fractures (DRFs), treated between October 2010 and April 2013, was classified using an electronic web-based portal by an invited group of participants on two occasions. Results Interobserver reliability was substantial when classifying AO type A fractures but fair and moderate for type B and C fractures, respectively. No difference was observed by location, except for an apparent difference between participants from India and Australia classifying type B fractures. No statistically significant associations were observed comparing interobserver agreement by level of training and no differences were shown comparing subspecialties. Intra-rater reproducibility was "substantial" for fracture types and "fair" for fracture groups with no difference accounting for location, training level, or specialty. Conclusion Improved definition of reliability and reproducibility of this classification may be achieved using large international groups of raters, empowering decision making on which system to utilize. Level of Evidence Level III.
RESUMO
INTRODUCTION: The gradual aging of the population results in increased incidence of osteoporotic bone fractures. In a good quality bone, the fixation with the usual methods is adequate, but not in osteoporotic bone, in which consolidation delays and other complications are common, with failure rates for screws up to 25%. OBJECTIVE: To test fibronectin loaded hydroxyapatite as a complementary treatment for osteoporotic fractures. MATERIAL AND METHODS: This study was performed in a vivo model; 42 female osteoporotic adult rabbits 4-5kg (White New Zealand) were used. Two groups (hydroxyapatite and fibronectin loaded hydroxyapatite) and a control group were tested. 3 time points 24h, 48h and 5days were studied. Defects were created in both femurs, in one of them, a cannulated screw (4mm) and a biocompatible material were placed; in the other femur a screw was inserted without supplemented material forming the control group. Osteoporosis was induced from models already known throughout administration of steroids. Samples were analyzed histologically and through imaging (micro Ct). RESULTS: Basal levels of BMD are observed below to normal when compared to other studies (0.25/0.3 instead of 0.4). Global and dependent of time analysis of samples, show no significant differences for samples analyzed. However, an important trend was noted for variables that define the trabecular bone microarchitecture. Indices that define trabecular microarchitecture in the comparative analysis found to have statistical differences (p<0.01). DISCUSSION: Osteosynthesis in an osteoporotic bone is a challenge for the surgeon, due to a reduced bone mineral density and different bone architecture. The main finding was the verification of the hypothesis that the trabecular bone parameters increases with our augmentation material in weak rabbit bone quality. Also, the histological analyses of samples show an increase of non inflammatory cells in protein samples (OHAp-Fn) from the first 24hours. CONCLUSION: An early response of rabbit osteroporotic bone to a complementary treatment with fibronectin loaded hydroxyapatite has been observed. This response is reflected in greater values for indices that define the trabecular bone microarchitecture, thickness and separation, a greater non-inflammatory cellularity after only 24hours and an increased amount of connective tissue observed at 48hours.
