Red Upconverter Nanocrystals Functionalized with Verteporfin for Photodynamic Therapy Triggered by Upconversion.

Upconversion (UC) nanoparticles characterized by red upconversion emission, particularly interesting for biological applications, have been prepared and subsequently modified by the covalent anchoring of Verteporfin (Ver), an FDA approved photosensitizer (PS) which usually exerts its photodynamic activity upon excitation with red light. ZrO2 was chosen as the platform where Yb3+ and Er3+ were inserted as the sensitizer and activator ions, respectively. Careful control of the doping ratio, along with a detailed physico-chemical characterization, was carried out. Upon functionalization with a silica shell to covalently anchor the photosensitizer, a theranostic nanoparticle was obtained whose architecture, thanks to a favorable energy level match and a uniform distribution of the PS, allowed us to trigger the photodynamic activity of Ver by upconversion, thus paving the way to the use of Photodynamic Therapy (PDT) in deep tissues, thanks to the higher penetrating power of NIR light.

Control of Membrane Fouling in Organics Filtration Using Ce-Doped Zirconia and Visible Light.

Membrane fouling has been a major issue in the development of more efficient water treatment processes. Specifically in surface waters filtration, organic matter, such as humic-like substances, can cause irreversible fouling. Therefore, this study evaluates the activity of a photocatalytic layer composed of Ce-doped zirconia nanoparticles in improving the fouling resistance during filtration of an aqueous solution of humic acid (HA). These nanoparticles were prepared by hydrothermal and sol-gel processes and then characterized. Before the filtration experiments, the photodegradation of HA catalyzed by Ce-doped zirconia nanoparticles in dispersion was studied. It was observed that the sol-gel prepared Ce-ZrO2 exhibited higher HA removal in practically neutral pH, achieving 93% efficiency in 180 min of adsorption in the dark followed by 180 min under visible-light irradiation using light-emitting diodes (LEDs). Changes in spectral properties and in total organic carbon confirmed HA degradation and contributed to the proposal of a mechanism for HA photodegradation. Finally, in HA filtration tests, Ce-ZrO2 photocatalytic membranes were able to recover the flux in a fouled membrane using visible-light by degrading HA. The present findings point to the further development of anti-fouling membranes, in which solar light can be used to degrade fouling compounds and possibly contaminants of emerging concern, which will have important environmental implications.

Insights Into the Sunlight-Driven Water Oxidation by Ce and Er-Doped ZrO 2.

In the present work, the activity of Ce and Er-doped ZrO2 nanopowders for sun-driven photocatalytic water oxidation has been investigated. ZrO2 powders with tunable amounts of tetragonal, monoclinic and cubic polymorphs have been synthesized by introducing Ce and Er (from 0.5 to 10 mol % on an oxide basis) through hydrothermal method. The aim of this work is to investigate the role of rare earth (RE) ions rich of electrons (Er3+) and with entirely empty levels (Ce4+) in the ZrO2 matrix for the sun-driven photocatalytic water oxidation reaction. The samples have been characterized by means of UV-Vis spectroscopy, X-Ray diffraction (XRD), N2 adsorption, X-ray photoelectron spectrophotometry (XPS) and transmission electronic microscopy (TEM) with energy dispersive spectroscopy (EDS). With respect to the bare ZrO2 mainly containing monoclinic (m-) phase, an increasing amount of rare-earth (RE) dopant was found to improve the specific BET surface area and to stabilize the tetragonal (t-) or cubic (c-) polymorphs of ZrO2 at room temperature. XRD data confirmed that dopants were mainly inserted in the t-ZrO2 phase. The photocatalytic O2 evolution from water under AM 1.5 G simulated sunlight illumination of the prepared samples have been correlated with their optical, structural and chemical properties. The effect of the dopant concentration on the chemical-physical and photocatalytic properties of the Er- and Ce-doped ZrO2 materials was elucidated. The samples with 5% of RE oxide were the most active, i.e., three times more than pure zirconia. Their superior photocatalytic activity was found to be mainly correlated to two factors: (i) an optimal surface concentration of RE ions of about 3.7%, which increased charge carriers separation in the photocatalysts surface due more superficial defects of the t-ZrO2 and a higher surface area, thus enhancing the reaction kinetics, (ii) a controlled amount of monoclinic vs. tetragonal (or cubic) polymorphs of zirconia with an optimum ratio of about 70/30 of t-ZrO2/m-ZrO2. Instead, the increased ability of the RE-doped ZrO2 to harvest visible light was found to have a secondary role on the photocatalytic activity of the Ce-doped ZrO2 material.

Photoactivity properties of ZnO doped with cerium ions: an EPR study.

In the present study, we investigated the effect of cerium doping in zinc oxide matrix, used as photoactive material. Cerium ions into the matrix of ZnO can act like a 'trap' for the electrons, lowering the e -/h + recombination rate and so increasing the photocatalytic efficiency of the ZnO. We synthesised doped samples using a simple precipitation route. The amount of dopant used was, 1 and 10% molar. The samples have been studied via x-ray diffraction measurements for the structural characterisation; UV-visible diffuse reflectance was used for the optical analysis; Branauer-Emmett-Teller (BET) model for the measurement of the surface area. Finally, the samples have been analysed via electron paramagnetic resonance (EPR) spectroscopy for the electronic characterisation and for testing their photoactivity. The spin trapping technique was also use to measure the amount of stable radical adducts formed via reaction of OH• radicals with molecules of the DMPO (5,5-dimethyl-1-pyrroline-N-oxide) spin probe.

The interaction of oxygen with the surface of CeO2-TiO2 mixed systems: an example of fully reversible surface-to-molecule electron transfer.

The interaction of oxygen with the surface of CeO2-TiO2 mixed oxides prepared via sol-gel was investigated by means of electron paramagnetic resonance (EPR). Upon admission of molecular oxygen onto the surface of the as prepared materials (which underwent final oxidative calcination) the formation of superoxide O2(-) ions is observed without the need for preliminary annealing in a vacuum and consequent oxygen depletion. The superoxide species is symmetrically adsorbed ("side-on" structure) on the top of a Ce(4+) ion. Surprisingly the electron transfer is fully reversible at room temperature having the typical behavior shown by molecular oxygen carriers, which, however, link to oxygen in a completely different manner ("end-on" structure). We suggest that the active sites are Ce(3+) ions present in the stoichiometric cerium titanate which forms during the synthesis. The features of these Ce(3+) ions must be different from those of the same ions formed in CeO2 by reductive treatments, which show a different reactivity to O2. The observation reported here opens up innovative perspectives in the field of heterogeneous catalysis and in that of sensors as the total reversibility of the electron transfer is observed in a significant range of oxygen pressure.

Cerium-Doped Zirconium Dioxide, a Visible-Light-Sensitive Photoactive Material of Third Generation.

The dispersion of small amounts of Ce(4+) ions in the bulk of ZrO2 leads to a photoactive material sensitive to visible light. This is shown by monitoring with EPR the formation and the reactivity of photogenerated (λ > 420 nm) charge carriers. The effect, as confirmed by DFT calculations, is due to the presence in the solid of empty 4f Ce states at the mid gap, which act as intermediate levels in a double excitation mechanism. This solid can be considered an example of a third-generation photoactive material.