Effect of Ultrafine Fly Ash and Water Glass Content on the Performance of Phosphorus Slag-Based Geopolymer.

Phosphorus slag (PS), an industrial waste slag, has been used in geopolymers because it is rich in silicon and calcium. The poor performance of phosphorus slag-based geopolymer is due to its aluminum deficiency. In this work, low-calcium fly ash, treated by a wet-grinding process, named wet-grinding ultrafine fly ash (WUFA) was used as an Al supplement to replace some of the phosphorus slag, and the wet-grinding, ultrafine fly ash-phosphorus slag (WUFA-PS)-based geopolymer was prepared. The effects of the substitution amount of WUFA and the activator dosage on the hydration properties, mechanical properties, pore structure and SEM of the WUFA-PS geopolymer were discussed in detail. The results indicate that WUFA and more activators contribute to the Al and high alkalinity environment, which positively induces the production of more geopolymer gels, thus releasing more heat and optimizing the pore structure of the matrix. The compressive strength increased by up to 28.1%. The enhanced performance of the WUFA-PS-based geopolymer may also arise from the filling effect and activity improvement of WUFA. This study has proved the feasibility of preparing a geopolymer by blending wet-grinding ultrafine fly ash and phosphorus slag and has provided references for the ratio and performance evaluation of WUFA-PS-based geopolymer concrete.

Study of a Mode Separation Due to Polarization Existing in a Cavity-Enhanced Absorption Spectroscopy.

A special phenomenon of resonance mode separation is observed during the study of a high sensitivity folded-cavity enhanced absorption spectroscopy for the measurement of trace gases. The phenomenon affects the measurement of gas absorption spectrum in the cavity. This resonant mode separation phenomenon of the resonant cavity is different from the resonant modes previously observed in linear-cavity enhanced absorption spectroscopy systems. To explore the mechanism of this phenomenon, a series of hypotheses are proposed. The most likely reason among these hypotheses is based on the different reflectance properties of the plane mirror at the fold of the cavity for S-polarized light and P-polarized light. Based on the matrix calculation method, the different reflectance and phase shift of the plane mirror for S-polarized light and P-polarized light are analyzed theoretically, and the results are in better agreement with the phenomena observed in the experiment. Finally, in order to eliminate the resonant mode separation phenomenon, line polarizers were added. By improving the system, the cavity enhanced absorption spectrum of residual water vapor in the cavity was successfully measured, and a minimum detectable absorption coefficient of αmin = 7.6 × 10-9 cm-1 can be obtained in a single laser scan of 10 s.

Development of new hepatitis E vaccines.

Hepatitis E virus (HEV) infection is an emerging zoonotic disease posing a severe threat to public health in the world, especially to pregnant women. Currently, no specific treatments are available for HEV infection. Therefore, it is crucial to develop vaccine to prevent this infection. Although several potential candidate vaccines against HEV have been studied for their immunogenicity and efficacy, only Hecolin® which is developed by Xiamen Innovax Biotech Co., Ltd. and approved by China Food and Drug Administration (CFDA) in 2012, is the licensed HEV vaccine in the world so far. Extensive studies on safety, immunogenicity and efficacy in phase III clinical trials have shown that Hecolin® is a promising vaccine for HEV prevention and control. In this article, the advances on HEV vaccine development and research are briefly reviewed.