Anisotropic polyvinyl alcohol-Bacterial cellulose nanocomposite for biomedical applications.

Compliance mismatch between the synthetic graft and the surrounding native tissue has been reported as a major factor in ultimate failure of the currently used cardiovascular graft replacements. Thus, developing biomaterials that display close mechanical properties as the tissue it is replacing is an important objective in biomedical devices design. Polyvinyl alcohol (PVA) is a biocompatible hydrogel with characteristics desired for biomedical applications. It can be crosslinked by a low temperature thermal cycling process. By using a novel thermal processing method under an applied strain and with the addition of a small amount of bacterial cellulose (BC) nanofibers, an anisotropic PVA-BC nanocomposite was created. The stress-strain tensile properties of porcine aorta were closely matched in both the circumferential and the axial directions by one type of anisotropic PVA-BC nanocomposite (10% PVA with 0.3% BC at 75% initial strain and cycle 2) within physiological range, with improved resistance to further stretch beyond physiological strains. The PVA-BC nanocomposite gives a broad range of mechanical properties, including anisotropy, by controlling material and processing parameters. PVA-BC nanocomposites with controlled degree of anisotropy that closely match the mechanical properties of the soft tissue it might replace, ranging from cardiovascular to other connective tissues, can be created.

Measurement of the elastic modulus of single bacterial cellulose fibers using atomic force microscopy.

The ability of the atomic force microscope to measure forces with subnanonewton sensitivity at nanometer-scale lateral resolutions has led to its use in the mechanical characterization of nanomaterials. Recent studies have shown that the atomic force microscope can be used to measure the elastic moduli of suspended fibers by performing a nanoscale three-point bending test, in which the center of the fiber is deflected by a known force. We extend this technique by modeling the deflection measured at several points along a suspended fiber, allowing us to obtain more accurate data, as well as to justify the mechanical model used. As a demonstration, we have measured a value of 78 +/- 17 GPa for Young's modulus of bacterial cellulose fibers with diameters ranging from 35 to 90 nm. This value is considerably higher than previous estimates, obtained by less direct means, of the mechanical strength of individual cellulose fibers.