Anisotropy of the ΔE Effect in Ni-Based Magnetoelectric Cantilevers: A Finite Element Method Analysis.

In recent investigations of magnetoelectric sensors based on microelectromechanical cantilevers made of TiN/AlN/Ni, a complex eigenfrequency behavior arising from the anisotropic ΔE effect was demonstrated. Within this work, a FEM simulation model based on this material system is presented to allow an investigation of the vibrational properties of cantilever-based sensors derived from magnetocrystalline anisotropy while avoiding other anisotropic contributions. Using the magnetocrystalline ΔE effect, a magnetic hardening of Nickel is demonstrated for the (110) as well as the (111) orientation. The sensitivity is extracted from the field-dependent eigenfrequency curves. It is found, that the transitions of the individual magnetic domain states in the magnetization process are the dominant influencing factor on the sensitivity for all crystal orientations. It is shown, that Nickel layers in the sensor aligned along the medium or hard axis yield a higher sensitivity than layers along the easy axis. The peak sensitivity was determined to 41.3 T-1 for (110) in-plane-oriented Nickel at a magnetic bias flux of 1.78 mT. The results achieved by FEM simulations are compared to the results calculated by the Euler-Bernoulli theory.

Automated Parameter Extraction Of ScAlN MEMS Devices Using An Extended Euler-Bernoulli Beam Theory.

Magnetoelectric sensors provide the ability to measure magnetic fields down to the pico tesla range and are currently the subject of intense research. Such sensors usually combine a piezoelectric and a magnetostrictive material, so that magnetically induced stresses can be measured electrically. Scandium aluminium nitride gained a lot of attraction in the last few years due to its enhanced piezoelectric properties. Its usage as resonantly driven microelectromechanical system (MEMS) in such sensors is accompanied by a manifold of influences from crystal growth leading to impacts on the electrical and mechanical parameters. Usual investigations via nanoindentation allow a fast determination of mechanical properties with the disadvantage of lacking the access to the anisotropy of specific properties. Such anisotropy effects are investigated in this work in terms of the Young's modulus and the strain on basis of a MEMS structures through a newly developed fully automated procedure of eigenfrequency fitting based on a new non-Lorentzian fit function and subsequent analysis using an extended Euler-Bernoulli theory. The introduced procedure is able to increase the resolution of the derived parameters compared to the common nanoindentation technique and hence allows detailed investigations of the behavior of magnetoelectric sensors, especially of the magnetic field dependent Young's modulus of the magnetostrictive layer.

Radiative Pumping and Propagation of Plexcitons in Diffractive Plasmonic Crystals.

Strong coupling between plasmons and excitons leads to the formation of plexcitons: quasiparticles that combine nanoscale energy confinement and pronounced optical nonlinearities. In addition to these localized modes, the enhanced control over the dispersion relation of propagating plexcitons may enable coherent and collective coupling of distant emitters. Here, we experimentally demonstrate strong coupling between carbon nanotube excitons and spatially extended plasmonic modes formed via diffractive coupling of periodically arranged gold nanoparticles (nanodisks, nanorods). Depending on the light-matter composition, the rather long-lived plexcitons (>100 fs) undergo highly directional propagation over 20 µm. Near-field energy distributions calculated with the finite-difference time-domain method fully corroborate our experimental results. The previously demonstrated compatibility of this plexcitonic system with electrical excitation opens the path to the realization of a variety of ultrafast active plasmonic devices, cavity-assisted energy transport and low-power optoelectronic components.

Multispectral electroluminescence enhancement of single-walled carbon nanotubes coupled to periodic nanodisk arrays.

The integration of periodic nanodisk arrays into the channel of a light-emitting field-effect transistor leads to enhanced and directional electroluminescence from thin films of purified semiconducting single-walled carbon nanotubes. The maximum enhancement wavelength is tunable across the near-infrared and is directly linked to the periodicity of the arrays. Numerical calculations confirm the role of increased local electric fields in the observed emission modification. Large current densities are easily achieved due to the high charge carrier mobilities of carbon nanotubes and will facilitate new electrically driven plasmonic devices.

Broadband Tunable, Polarization-Selective and Directional Emission of (6,5) Carbon Nanotubes Coupled to Plasmonic Crystals.

We demonstrate broadband tunability of light emission from dense (6,5) single-walled carbon nanotube thin films via efficient coupling to periodic arrays of gold nanodisks that support surface lattice resonances (SLRs). We thus eliminate the need to select single-walled carbon nanotubes (SWNTs) with different chiralities to obtain narrow linewidth emission at specific near-infrared wavelengths. Emission from these hybrid films is spectrally narrow (20-40 meV) yet broadly tunable (∼1000-1500 nm) and highly directional (divergence <1.5°). In addition, SLR scattering renders the emission highly polarized, even though the SWNTs are randomly distributed. Numerical simulations are applied to correlate the increased local electric fields around the nanodisks with the observed enhancement of directional emission. The ability to control the emission properties of a single type of near-infrared emitting SWNTs over a wide range of wavelengths will enable application of carbon nanotubes in multifunctional photonic devices.

Surface Lattice Resonances for Enhanced and Directional Electroluminescence at High Current Densities.

Hybrid photonic-plasmonic modes in periodic arrays of metallic nanostructures offer a promising trade-off between high-quality cavities and subdiffraction mode confinement. However, their application in electrically driven light-emitting devices is hindered by their sensitivity to the surrounding environment and to charge injecting metallic electrodes in particular. Here, we demonstrate that the planar structure of light-emitting field-effect transistor (LEFET) ensures undisturbed operation of the characteristic modes. We incorporate a square array of gold nanodisks into the charge transporting and emissive layer of a polymer LEFET in order to tailor directionality and emission efficiency via the Purcell effect and variation of the fractional local density of states in particular. Angle- and polarization-resolved spectra confirm that the enhanced electroluminescence correlates with the dispersion curves of the surface lattice resonances supported by these structures. These LEFETs reach current densities on the order of 10 kA/cm2, which may pave the way toward practical optoelectronic devices with tailored emission patterns and potentially electrically pumped plasmonic lasers.