Application of XANES in gamma dosimetry.

The thermoluminescence material, CaSO4:Dy, is widely used for the dosimetry of ionizing radiation due to its high sensitivity, low fading and wide dose range from µGy to few tens of gray. However, its application is limited at high doses due to non-linear and saturation effects. In this paper, X-ray Absorption Near Edge Structure (XANES) studies at the Dy L3-edge have been carried out on CaSO4:Dy discs exposed to gamma doses in the range 0-1000 Gy. The results show an increase in white line in XANES spectra with gamma dose. Structural change in CaSO4:Dy also has been studied using X-Ray Diffraction (XRD) and has found no structural change up to 1000 Gy. The study indicates that XANES can be used as an alternative dosimetry technique and is useful in the evaluation of absorbed dose in the case of accidental exposure to high radiation in a radiation facility or during a radiological accident.

Noninvasive assessment of cutaneous alterations in mice exposed to whole body gamma irradiation using optical imaging techniques.

We report the results of a study carried out to investigate the potential of optical techniques such as optical coherence tomography, Mueller matrix spectroscopy, and cross-polarization imaging for noninvasive monitoring of the ionizing radiation exposure-induced alterations in cutaneous tissue of mice. Radiation dose-dependent changes were observed in tissue microvasculature and tissue optical parameters like retardance and depolarization as early as 1 h post radiation exposure. Results suggest that these optical techniques may allow early detection of radiation dose-dependent alterations which could help in screening of population exposed to radiation.

Radiation safety aspects of the operation of first three synchrotron beam lines of Indus-2.

Five synchrotron radiation beam lines are commissioned and now under regular operation at the Synchrotron Radiation Source, Indus-2 at Raja Ramanna Centre For Advanced Technology (RRCAT), Indore, India. Nine beam lines are under trial operation, and six beam lines are in the installation stage. In the early phase of installation of beam lines on Indus-2, three bending magnet beam lines, Extended X-ray Absorption Fine Structure (EXAFS, BL-8), Energy Dispersive X-ray Diffraction (EDXRD, BL-11) and Angle Dispersive X-ray Diffraction (ADXRD, BL-12), were installed and commissioned, after approval from Atomic Energy Regulatory Board (AERB), India. These beam lines are pink (BL-8), white (BL-11) and monochromatic (BL-12), which are housed in specially designed shielded hutches. In order to ensure safety of users and other working personnel from ionizing radiations present in these beam lines, several safety systems are incorporated and safety procedures are followed. The paper describes the radiological safety aspects of the three beam lines during its initial commissioning trials and also the measurements on radiation levels carried out in and around the beam line hutches.

Estimation of bremsstrahlung photon energy in the environment of high-energy electron accelerator using CaSO4:Dy based TL dosemeter.

High-energy bremsstrahlung X rays constitute the major radiation hazard to working personnel around the high-energy electron accelerators. Thermoluminescent (TL) dosemeter system based on CaSO4:Dy Teflon disc used in the routine individual monitoring was used to estimate the bremsstruhlung photon energy at different locations of the experimental hall of 450-MeV synchrotron accelerator. The response of TL discs under different filter regions of the dosemeter system undergo change with photon energy due to the lack of build up and interaction of photon in the metal filters. This change in the response of the discs used to estimate the energy of the bremsstrauhlung photon in conjunction with suitable calibration curve generated using known photon energy from medical linear accelerator. The photon energies estimated were in the range 1-4 MeV, depending on the locations.

Determination of dose-build-up thickness for absorbed dose measurement in high energy electron-photon radiation at electron storage rings.

Radiation field during accidental electron beam loss near electron storage rings comprises of high-energy electrons and bremsstrahlung photons. Due to high-energy nature of the radiation, the absorbed dose is expected to build up with depth of the body of an exposed worker and hence absorbed dose measurements in 30 cm water/tissue equivalent phantom is essential. Carrying out the measurements with in such phantoms is not practically feasible for routine applications and hence the use of an equivalent solid material around the dosemeters would be convenient. Monte Carlo calculations have been carried out in order to determine the dose-build-up thickness required in copper and lead, corresponding to the maximum absorbed within 30 cm depth of water in such radiation fields. Equivalent build-up thickness calculated for a case was verified by measurement using an ion chamber detector. The results are found to be in agreement within +/-20%.

Dose build up correction for radiation monitors in high-energy bremsstrahlung photon radiation fields.

Conventional radiation monitors have been found to underestimate the personal dose equivalent in the high-energy bremsstrahlung photon radiation fields encountered near electron storage rings. Depth-dose measurements in a water phantom were carried out with a radiation survey meter in the bremsstrahlung photon radiation fields from a 450 MeV electron storage ring to find out the magnitude of the underestimation. Dose equivalent indicated by the survey meter was found to build up with increase in thickness of water placed in front of the meter up to certain depth and then reduce with further increase in thickness. A dose equivalent build up factor was estimated from the measurements. An absorbed dose build up factor in a water phantom was also estimated from calculations performed using the Monte Carlo codes, EGS-4 and EGSnrc. The calculations are found to be in very good agreement with the measurements. The studies indicate inadequacy of commercially available radiation monitors for radiation monitoring within shielded enclosures and in streaming high-energy photon radiation fields from electron storage rings, and the need for proper correction for use in such radiation fields.