Evaluation of the Oil Recovery Potential and Cost Implication Analysis of Alternative ASP Formulations for Sandstone and Carbonate Reservoirs.

This study explores alternative chemical agents to enhance oil recovery in sandstone and carbonate reservoirs, aiming to address limitations in alkali-surfactant-polymer (ASP) flooding. Existing ASP methods face technical and environmental challenges, prompting research into alternative chemical agents. However, there are limited field deployments of these alternative chemical agents due to high costs, and ternary combinations of these agents remain unexplored. The study investigates a combination of organic alkali, amino acid-based surfactant/surface-active ionic liquid, and biopolymer. Comparative analysis with conventional ASP formulations reveals promising results. Organic alkali and biopolymer combination mitigates the adverse effects of inorganic alkalis on partially hydrolyzed polyacrylamide, enhancing the oil recovery potential. A unit technical cost (UTC) calculation showed that despite higher chemical costs per incremental barrel of oil, the alternative ASP formulations demonstrate comparable costs due to reduced facility cost. Cost-effectiveness will improve with incorporation of factors such as environmental friendliness and reduced preflush requirements. Mass production of these agents could further enhance the economic feasibility. Therefore, this study reveals that careful cost-benefit analysis, the development of low-concentration formulations, and mass production of these chemical agents could facilitate the implementation of these alternatives, ensuring compliance with environmental regulations and enabling ASP flooding in challenging reservoir conditions.

Stability, Rheological Behavior, and pH Responsiveness of CTAB/HCl Acidic Emulsion: Experimental Investigation.

Cetyltrimethylammonium bromide (CTAB) surfactant was proven to be a reliable emulsifier for creating stable emulsions used for drilling, well stimulation, and EOR. The presence of acids like HCl during such operations may lead to the formation of acidic emulsions. No previous comprehensive investigations have been done to study the performance of CTAB-based acidic emulsions. This paper, therefore, presents experimental investigations of the stability, rheological behavior, and pH responsiveness of a CTAB/HCl-based acidic emulsion. The effects of temperature, pH, and CTAB concentration on the emulsion stability and rheology have been investigated using a bottle test and a TA Instrument DHR1 rheometer. Viscosity and flow sweep were analyzed for the steady state at a shear range of 2.5-250 s-1. For the dynamic tests, the storage modulus (G') and loss modulus (G″) were observed by applying the oscillation test at the range of shear frequency from 0.1 to 100 rad/s. The results revealed that the emulsion exhibits steady rheological behaviors ranging from Newtonian to shear-dependent (psedosteady), depending on the temperature and CTAB concentration. The tendency of the emulsion to exhibit a solid-like behavior is also dependent on CTAB concentration, temperature, and pH. However, the pH responsiveness of the emulsion is more significantly observed within the acidic range of the pH.

A Novel ZnO Nanoparticles Enhanced Surfactant Based Viscoelastic Fluid Systems for Fracturing under High Temperature and High Shear Rate Conditions: Synthesis, Rheometric Analysis, and Fluid Model Derivation.

Surfactant-based viscoelastic (SBVE) fluids are innovative nonpolymeric non-newtonian fluid compositions that have recently gained much attention from the oil industry. SBVE can replace traditional polymeric fracturing fluid composition by mitigating problems arising during and after hydraulic fracturing operations are performed. In this study, SBVE fluid systems which are entangled with worm-like micellar solutions of cationic surfactant: cetrimonium bromide or CTAB and counterion inorganic sodium nitrate salt are synthesized. The salt reagent concentration is optimized by comparing the rheological characteristics of different concentration fluids at 25 °C. The study aims to mitigate the primary issue concerning these SBVE fluids: significant drop in viscosity at high temperature and high shear rate (HTHS) conditions. Hence, the authors synthesized a modified viscoelastic fluid system using ZnO nanoparticle (NPs) additives with a hypothesis of getting fluids with improved rheology. The rheology of optimum fluids of both categories: with (0.6 M NaNO3 concentration fluid) and without (0.8 M NaNO3 concentration fluid) ZnO NPs additives were compared for a range of shear rates from 1 to 500 Sec-1 at different temperatures from 25 °C to 75 °C to visualize modifications in viscosity values after the addition of NPs additives. The rheology in terms of viscosity was higher for the fluid with 1% dispersed ZnO NPs additives at all temperatures for the entire range of shear rate values. Additionally, rheological correlation function models were derived for the synthesized fluids using statistical analysis methods. Subsequently, Herschel-Bulkley models were developed for optimum fluids depending on rheological correlation models. In the last section of the study, the pressure-drop estimation method is described using given group equations for laminar flow in a pipe depending on Herschel-Bulkley-model parameters have been identified for optimum fluids are consistency, flow index and yield stress values.