Impact of periprosthetic femoral fracture fixation plating constructs on local stiffness, load transfer, and bone strains.

Secondary femoral fractures after the successful plate-screw fixation of a primary Vancouver type B1 periprosthetic femoral fracture (PFF) have been associated with the altered state of stress/strain in the femur as the result of plating. The laterally implanted condyle-spanning plate-screw constructs have shown promises clinically in avoiding secondary bone and implant failures as compared with shorter diaphyseal plates. Though the condyle-spanning plating has been hypothesized to avoid stress concentration in the femoral diaphysis through increasing the working length of the plate, biomechanical evidence is lacking on how plate length may impact the stress/strain state of the implanted femur. Through developing and experimentally validating finite element (FE) models of 3 cadaveric femurs, this study investigated the impact of plating on bone strains, load transfer and local stiffness, which were compared between FE models of 2 different plating systems that each had a diaphyseal configuration and a condyle-spanning configuration. Under simulated gait-loading, the condyle-spanning constructs of both plating systems were shown to lower the bone strains around the distal fixation screws (up to 24.8% reduction in maximum principal strain and 26.6% reduction in minimum principal strain) and in the distal metaphyseal shaft of the femur (up to 15.9% and 25.7% reductions in maximum and minimum principal strains, respectively), where secondary bone fractures have been typically reported. In the distal diaphyseal and metaphyseal shaft of femur, FE models of the condyle-spanning constructs were shown to increase the local compressive stiffness (up to 152.9% increases under simulated gait-loading) and decrease the transfer of compressive load (37.1% decreases under simulated gait-loading), which may be indicative of the lowered risks of bone damage.

Can urine dipstick predict an elevated serum creatinine?

OBJECTIVE: Chart review studies have suggested that point-of-care urine dipstick testing may accurately predict an elevation in serum creatinine (Cr). We aimed to prospectively evaluate the test characteristics of proteinuria/hematuria in predicting elevated serum Cr. METHODS: A prospective, observational study was conducted between March 2007 and June 2008 at 2 affiliated, urban hospitals with an annual emergency department census of 150,000. Patients undergoing laboratory urinalysis, point-of-care urine dipstick, and a serum chemistry panel were enrolled. Trained research assistants collected data on consecutive patients 18 hours per day using preformatted data forms and entry into an anonymized Access (Microsoft, Seattle, Wash) database. Demographic baseline variables including age, sex, chief complaint, vital signs, and source of sample (catheter vs "clean catch") were also collected. An elevated Cr level was defined as greater than 1.3 based on the laboratory reference range. Standard statistical methods were used to calculate diagnostic test operating characteristics of proteinuria or hematuria as a predictor of elevated serum Cr. RESULTS: Five thousand four hundred sixteen subjects were enrolled with 28.3% male and a mean age of 50.2 years. Elevated serum Cr greater than 1.3 mg/dL was found in 13.9% (755/5416) of subjects. The sensitivity of either proteinuria or hematuria for elevated Cr was 82.5% (95% confidence interval [CI], 80%-85%) and specificity was 34.4% (95% CI, 33%-36%). Positive predictive value was 16.9% (95% CI, 16%-18%) and negative predictive value was 92.4% (95% CI, 91-94%). The likelihood ratio for a positive test was 1.3 (95% CI, 1.1-1.5), and the likelihood ratio for a negative test was 0.5 (95% CI, 0.3-0.8). CONCLUSIONS: Although negative predictive value was high, the presence of proteinuria/hematuria was only moderately predictive of elevated serum Cr level.