Electroreduction of Carbon Dioxide to Hydrocarbons Using Bimetallic Cu-Pd Catalysts with Different Mixing Patterns.

Electrochemical conversion of CO2 holds promise for utilization of CO2 as a carbon feedstock and for storage of intermittent renewable energy. Presently Cu is the only metallic electrocatalyst known to reduce CO2 to appreciable amounts of hydrocarbons, but often a wide range of products such as CO, HCOO-, and H2 are formed as well. Better catalysts that exhibit high activity and especially high selectivity for specific products are needed. Here a range of bimetallic Cu-Pd catalysts with ordered, disordered, and phase-separated atomic arrangements (Cuat:Pdat = 1:1), as well as two additional disordered arrangements (Cu3Pd and CuPd3 with Cuat:Pdat = 3:1 and 1:3), are studied to determine key factors needed to achieve high selectivity for C1 or C2 chemicals in CO2 reduction. When compared with the disordered and phase-separated CuPd catalysts, the ordered CuPd catalyst exhibits the highest selectivity for C1 products (>80%). The phase-separated CuPd and Cu3Pd achieve higher selectivity (>60%) for C2 chemicals than CuPd3 and ordered CuPd, which suggests that the probability of dimerization of C1 intermediates is higher on surfaces with neighboring Cu atoms. Based on surface valence band spectra, geometric effects rather than electronic effects seem to be key in determining the selectivity of bimetallic Cu-Pd catalysts. These results imply that selectivities to different products can be tuned by geometric arrangements. This insight may benefit the design of catalytic surfaces that further improve activity and selectivity for CO2 reduction.

Preparation of solid-solution type Fe-Co nanoalloys by synchronous deposition of Fe and Co using dual arc plasma guns.

We succeeded in the efficient preparation of well-dispersed Fe-Co nanoalloys (NAs) using the arc plasma deposition method. Synchronous shots of dual arc plasma guns were applied to a carbon support to prepare the solid-solution type Fe-Co NAs having an approximately 1 : 1 atomic ratio. The alloy structures with and without a reductive thermal treatment under a hydrogen atmosphere were examined using X-ray powder diffraction, scanning transmission electron microscopy (STEM) combined with energy-dispersive X-ray analysis, high resolution STEM, and magnetic measurements, suggesting that highly crystalline spherical particles of ordered B2-type Fe-Co NAs form by the thermal treatment of the deposited grains.

Flow-based ammonia gas analyzer with an open channel scrubber for indoor environments.

A robust and fully automated indoor ammonia gas monitoring system with an open channel scrubber (OCS) was developed. The sample gas channel dimensions, hydrophilic surface treatment to produce a thin absorbing solution layer, and solution flow rate of the OCS were optimized to connect the OCS as in-line gas collector and avoid sample humidity effects. The OCS effluent containing absorbed ammonia in sample gas was injected into a derivatization solution flow. Derivatization was achieved with o-phthalaldehyde and sulfite in pH 11 buffer solution. The product, 1-sulfonateisoindole, is detected with a home-made fluorescence detector. The limit of detection of the analyzer based on three times the standard deviation of baseline noise was 0.9 ppbv. Sample gas could be analyzed 40 times per hour. Furthermore, relative humidity of up to 90% did not interfere considerably with the analyzer. Interference from amines was not observed. The developed gas analysis system was calibrated using a solution-based method. The system was used to analyze ammonia in an indoor environment along with an off-site method, traditional impinger gas collection followed by ion chromatographic analysis, for comparison. The results obtained using both methods agreed well. Therefore, the developed system can perform on-site monitoring of ammonia in indoor environments with improved time resolution compared with that of other methods.