Pharmacokinetics and effects of alfaxalone after intravenous and intramuscular administration to cats.

AIMS: To determine the pharmacokinetics, and anaesthetic and sedative effects of alfaxalone after I/V and I/M administration to cats. METHODS: Six European shorthair cats, three males and three females, with a mean weight of 4.21 (SD 0.53) kg and aged 3.8 (SD 0.9) years were enrolled in this crossover, two-treatment, two-period study. Alfaxalone at a dose of 5 mg/kg was administered either I/V or I/M. Blood samples were collected between 2-480 minutes after drug administration and analysed for concentrations of alfaxalone by HPLC. The plasma concentration-time curves were analysed by non-compartmental analysis. Sedation scores were evaluated between 5-120 minutes after drug administration using a numerical rating scale (from 0-18). Intervals from drug administration to sit, sternal and lateral recumbency during the induction phase, and to head-lift, sternal recumbency and standing position during recovery were recorded. RESULTS: The mean half-life and mean residence time of alfaxalone were longer after I/M (1.28 (SD 0.21) and 2.09 (SD 0.36) hours, respectively) than after I/V (0.49 (SD 0.07) and 0.66 (SD 0.16) hours, respectively) administration (p<0.05). Bioavailability after I/M injection of alfaxalone was 94.7 (SD 19.8)%. The mean intervals to sternal and lateral recumbency were longer in the I/M (3.73 (SD 1.99) and 6.12 (SD 0.90) minutes, respectively) compared to I/V (0 minutes for all animals) treated cats (p<0.01). Sedation scores indicative of general anaesthesia (scores >15) were recorded from 5-15 minutes after I/V administration and deep sedation (scores 11-15) at 20 and 30 minutes. Deep sedation was observed from 10-45 minutes after I/M administration. One cat from each group showed hyperkinesia during recovery, and the remainder had an uneventful recovery. CONCLUSIONS AND CLINICAL RELEVANCE: Alfaxalone administered I/V in cats provides rapid and smooth induction of anaesthesia. After I/M administration, a longer exposure to the drug and an extended half life were obtained compared to I/V administration. Therefore I/M administration of alfaxalone could be a reliable, suitable and easy route in cats, taking into account that alfaxalone has a slower onset of sedation than when given I/V and achieves deep sedation rather than general anaesthesia.

Pharmacokinetics of norfloxacin after intravenous, intramuscular and subcutaneous administration to rabbits.

The disposition kinetics of norfloxacin, after intravenous, intramuscular and subcutaneous administration was determined in rabbits at a single dose of 10 mg/kg. Six New Zealand white rabbits of both sexes were treated with aqueous solution of norfloxacin (2%). A cross-over design was used in three phases (2 × 2 × 2), with two washout periods of 15 days. Plasma samples were collected up to 72 hr after treatment, snap-frozen at -45°C and analysed for norfloxacin concentrations using high-performance liquid chromatography. The terminal half-life for i.v., i.m. and s.c. routes was 3.18, 4.90 and 4.16 hr, respectively. Clearance value after i.v. dosing was 0.80 L/h·kg. After i.m. administration, the absolute bioavailability was (mean ± SD) 108.25 ± 12.98% and the Cmax was 3.68 mg/L. After s.c. administration, the absolute bioavailability was (mean ± SD) 84.08 ± 10.36% and the Cmax was 4.28 mg/L. As general adverse reactions were not observed in any rabbit and favourable pharmacokinetics were found, norfloxacin at 10 mg/kg after i.m. and s.c. dose could be effective in rabbits against micro-organisms with MIC ≤0.14 or 0.11 µg/mL, respectively.

Pharmacokinetics of marbofloxacin in rabbit after intravenous, intramuscular, and subcutaneous administration.

The disposition kinetics of marbofloxacin, a fluoroquinolone antibiotic, after intravenous (i.v.), intramuscular (i.m.) and subcutaneous (s.c.) administration was determined in rabbits at a single dose of 2 mg/kg. Plasma concentrations of marbofloxacin were determined by high performance liquid chromatography with fluorescence detection. The concentration-time data were analysed by compartmental and non-compartmental pharmacokinetic methods. Steady-state volume of distribution (V(ss)) and clearance (Cl) of marbofloxacin after i.v. administration were 1.99±0.27 L/kg and 0.42±0.04 L/h kg, respectively. Following i.m. and s.c. administration marbofloxacin achieved maximum plasma concentrations of 2.04±0.32 and 1.64±0.15 mg/L at 0.33±0.16 and 0.50±0.18 h, respectively. The absolute bioavailabilities after i.m. and s.c. routes were 123.30±17.64% and 114.81±12.11%, respectively. From these data (kinetic parameters and absence of adverse reactions) marbofloxacin is likely to be effective in rabbits.

A system for the direct determination of the nonvolatile organic carbon, dissolved organic carbon, and inorganic carbon in water samples through inductively coupled plasma atomic emission spectrometry.

A new system has been developed for the determination of total organic carbon (TOC) and inorganic carbon (IC) or total inorganic carbon (TIC) in waters. Only nonvolatile organic compounds can be detected through the present method. The system presented in this work is based on the measurement of the carbon atomic emission intensity in inductively coupled plasma atomic emission spectrometry (ICP-AES). This way, the organic matter does not undergo any preoxidation step. A semiautomatic accessory connected to the spectrometer separates the different carbon fractions (i.e., organic and inorganic). Because most of the solutions used in the present work did not contain suspended solid particles, the actual parameter that was determined was the dissolved organic carbon (DOC). The present system exhibits good sensitivities compared to those provided by conventional TOC and IC determination methods. The limits of detection obtained in the present work have been 0.07 and 0.0007 mg/L C in terms of TOC and IC, respectively. Furthermore, the system is able to handle high-salt-content solutions. This fact suggests that it would be possible to analyze seawater samples, avoiding some of the problems encountered with conventional methods, such as system blocking or interferences. The TOC and IC values found for natural samples are very close to those measured using conventional methods. The ICP-AES method has been successfully used in two interesting applications: (i) monitoring the efficiency of a water treatment plant and (ii) determining the contents of dissolved carbon dioxide, on one hand, and that of carbonate and bicarbonate, on the other, in the same sample.

Determination of adipate plasticizers in poly(vinyl chloride) by microwave-assisted extraction.

A new method based on the application of microwave radiation to the extraction of adipate plasticizers from poly(vinyl chloride) PVC plastics is described. The experimental conditions for microwave-assisted extraction (i.e. extracting solvent, temperature, time and microwave power) were evaluated in terms of recovery. The optimisation was carried out with pastes of PVC plastified with di-2-ethylhexyl adipate, and extracts were measured by gas chromatography with flame ionization detection. Six different adipate plasticizers were studied, and microwave-assisted extraction was compared with supercritical fluid extraction for the extraction of adipates and phthalates from PVC matrices. It has been observed that the microwave-assisted extraction parameters evaluated are tightly interconnected. It has been shown that the efficiency of microwave-assisted extraction depends on the kind of solvent, the temperature achieved and the heating time. Moreover, the final temperature reached depends on the microwave power, the number of vessels and the irradiation time. On the other hand, microwave-assisted extraction provides higher recovery values than supercritical fluid extraction for both phthalate and adipate plasticizers.

Comparison of several spray chambers operating at very low liquid flow rates in inductively coupled plasma atomic emission spectrometry.

Four different spray chambers were evaluated in ICP-AES at very low liquid flow rates: a double-pass (Scott type), a conventional cyclonic, and two low-volume cyclonic-type spray chambers (i.e., Cinnabar and Genie). A glass concentric pneumatic micro nebulizer (Atom Mist) was used in conjunction with all four chambers. The liquid flow rate was varied from 10 to 160 microL min(-1). The conventional cyclonic spray chamber gave rise to coarser tertiary aerosols, higher analyte and solvent transport rates, higher sensitivity and lower limits of detection than the remaining ones. The low-volume spray chambers afforded analytical figures of merit similar to the double-pass one, despite their very different designs. However, these spray chambers exhibited shorter wash-out times. The matrix effects were significant only for the double-pass. This fact allowed the analysis of reference samples by employing aqueous standards at a minimum level of sample consumption. The recoveries obtained for the cyclonic spray chambers and several certified samples were close to 100%, being always lower in the case of the double-pass spray chamber.

Determination of metals in lubricating oils by flame atomic absorption spectrometry using a single-bore high-pressure pneumatic nebulizer.

The behaviour of a single-bore high-pressure pneumatic nebulizer (SBHPPN) as a tool for the analysis of lubricating oils by flame atomic absorption spectrometry (FAAS) was investigated. The effects of the sample oil content [from 10% to 100% (w/w) oil in 4-methylpentan-2-one, IBMK] and the carrier nature (IBMK and methanol) on the characteristics of the aerosols generated, on the analyte transport efficiency and on the analytical figures of merit in FAAS were studied. A pneumatic concentric nebulizer (PCN) was used for comparison. Increasing the oil content increases the viscosity of the sample. With the PCN this gives rise to coarser aerosols, making it impossible to nebulize samples with an oil content higher than 70% (w/w). Using the SBHPPN, the viscosity of the sample scarcely affects the characteristics of the primary aerosols. Hence, the SBHPPN is able, by using the appropriate carrier, to nebulize pure lubricating oils. Among the carriers tested, IBMK is the most advisable because it is fully miscible with all the oil samples. The SBHPPN provides higher sensitivities and lower limits of detection than the PCN. Compared with a method based on organic dilution, the use of the SBHPPN for the direct analysis of lubricating oils by FAAS makes it possible, in addition to increasing the analysis throughput, to detect elements at lower concentrations. Moreover, the SBHPPN provides similar results to those obtained using a previous acid digestion step.

A microwave-powered thermospray nebulizer for liquid sample introduction in inductively coupled plasma atomic emission spectrometry.

A new thermospray nebulizer based on the absorption of microwave radiation (MWTN) by aqueous solutions of strong acids is presented for the first time. To this end, a given length of the sample capillary is placed inside the cavity of a focused microwave system. A small piece of a narrower capillary tubing is connected at the tip of the sample capillary, outside the microwave cavity, to build up pressure. Drop size distributions of primary aerosols are exhaustively measured in order to evaluate the influence of several experimental variables (microwave power, liquid flow, irradiation length, inner diameter of the outlet capillary, nature and concentration of the acid) on the characteristics of the primary aerosol that are related to the emission signal. These experiments have been performed mainly to increase our understanding of the microscopic process of this new type of aerosol generation. A standard Meinhard nebulizer was employed for comparison. Under the best conditions the entire aerosol volume is contained in droplets smaller than 20 µm compared with 45% of the volume of the aerosol generated by the Meinhard. Hence, higher analyte and aerosol transport rates are to be expected for the MWTN compared with the Meinhard nebulizer. As any highly efficient nebulizer, MWTN requires a desolvation unit. For solutions 0.75 M in strong acid, the new nebulizer improves sensitivity (1.0-2.8 times), limits of detection (1.2-3.0 times), and background equivalent concentration (0.9-2.0 times) as compared to the standard Meinhard nebulizer, features many of the advantages of the conventional thermospray nebulizer, and overcomes some of its drawbacks (MWTN does not show corrosion problems and works at lower pressure, the aerosol characteristics are not modified when the PTFE capillary is replaced).

Automatic flow-injection system for the determination of heavy metals in sewage sludge by microwave digestion and detection by inductively coupled plasma-atomic emission spectrometry (MW-ICP/AES).

Results are shown obtained in the optimization of an automatic flow injection system that combines microwave digestion with atomic spectrometric detection (FAAS, ICP/AES) for the determination of heavy metals in sewage sludge. Digestion is performed by preparing a suspension of the sample in 1.5 mol/l HNO(3) and making it flow through a PTFE capillary tube placed inside a conventional microwave oven. The effects of the length and inner diameter of the capillary tube, as well as that of the pumping rate, have been studied in order to find the experimental conditions that allow a quantitative elemental recovery in the shortest period of time possible. The optimization study was carried out on a certified sample (BCR No. 146), and the elements determined were Zn, Cu, Pb, Cd, Ni and Cr. The experimental data (percent recovery vs. digestion time) have been fitted to a mathematical model in order to quantify the influence of each of the variables studied. The optimized procedure (MW-ICP/AES) has been applied to one ordinary and one certified sewage sludge sample. In comparison with the conventional methods of sewage sludge analysis, the one proposed is less time consuming, while being equally precise and accurate.