Advanced Evaluation of the Long-Term Stability of Oxygen Evolution Electrocatalysts.

Evaluation of the long-term stability of electrocatalysts is typically performed using galvanostatic polarization at a predefined current density. A stable or insignificant increase in the applied potential is usually interpreted as high long-term stability of the tested catalyst. However, effects such as (i) electrochemical degradation of a catalyst due to its oxidation, (ii) blocking of the catalyst surface by evolved gas bubbles, and (iii) detachment of the catalyst from the electrode surface may lead to a decrease of the catalyst's active surface area being exposed to the electrolyte. In order to separate these effects and to evaluate the true electrochemical degradation of electrocatalysts, an advanced evaluation protocol based on subsequently performed electrochemical impedance, double layer capacitance, cyclic voltammetry, and galvanostatic polarization measurements was developed and used to evaluate the degradation of IrO2 particles drop-coated on glassy carbon rotating disk electrode using Nafion as a binder. A flow-through electrochemical cell was developed enabling circulation of the electrolyte leading to an efficient removal of evolved oxygen bubbles even at high current densities of up to 250 mA/cm(2). The degradation rate of IrO2 was evaluated over 225 test cycles (0.733 ± 0.022 mV/h) with a total duration of galvanostatic polarization measurements of over 55 h.

CoOx thin film deposited by CVD as efficient water oxidation catalyst: change of oxidation state in XPS and its correlation to electrochemical activity.

To reduce energy losses in water electrolysers a fundamental understanding of the water oxidation reaction steps is necessary to design efficient oxygen evolution catalysts. Here we present CoOx/Ti electrocatalytic films deposited by thermal and plasma enhanced chemical vapor deposition (CVD) onto titanium substrates. We report electrochemical (EC), photoelectron spectroscopy (XPS) and scanning electron microscopy (SEM) measurements. The electrochemical behavior of the samples was correlated with the chemical and electronic structure by recording XPS spectra before and after each electrochemical treatment (conditioning and cyclovoltammetry). The results show that the electrochemical behavior of CoOx/Ti strongly depends on the resulting electronic structure and composition. The thermal deposition leads to the formation of a pure Co(II)Ox which transforms to a mixed Co(II)Co(III)Ox during the OER. This change in oxidation state is coupled with a decrease in overpotential from η = 0.57 V to η = 0.43 V at 5 mA cm(-2). Plasma deposition in oxygen leads to a Co(III)-dominated mixed CoOx, that has a lower onset potential as deposited due to a higher Co(III) content in the initial deposited material. After the OER XPS results of the CoOx/Ti indicate a partial formation of hydroxides and oxyhydroxides on the oxide surface. Finally the plasma deposition in air, results in a CoOxOH2 surface, that is able to completely oxidizes during OER to an oxyhydroxide Co(III)OOH. With the in situ formed CoOOH we present a highly active catalyst for the OER (η = 0.34 at 5 mA cm(-2); η = 0.37 V at 10 mA cm(-2)).

Solar hydrogen generation with wide-band-gap semiconductors: GaP(100) photoelectrodes and surface modification.

GaP, with its large band gap of 2.26 eV (indirect) and 2.78 eV (direct), is a very promising candidate for direct photoelectrochemical water splitting. Herein, p-GaP(100) is investigated as a photocathode for hydrogen generation. The samples are characterized after each preparation step regarding how their photoelectrochemical behavior is influenced by surface composition and structure using a combination of electrochemical and surface-science preparation and characterization techniques. The formation of an Ohmic back contact employing an annealed gold layer and the removal of the native oxides using various etchants are studied. It turns out that the latter has a pronounced effect on the surface composition and structure and therefore also on the electronic properties of the interface. The formation of a thin Ga(2)O(3) buffer layer on the p-GaP(100) surface does not lead to a clear improvement in the photoelectrochemical efficiency, neither do Pt nanocatalyst particles deposited on top of the buffer layer. This behavior can be understood by the electronic structure of these layers, which is not well suited for an efficient charge transfer from the absorber to the electrolyte. First experiments show that the efficiency can be considerably improved by employing a thin GaN layer as a buffer layer on top of the p-GaP(100) surface.

Synthesis and characterization of new iridium photosensitizers for catalytic hydrogen generation from water.

Novel phenylazole ligands were applied successfully in the synthesis of cyclometalated iridium(III) complexes of the general formula [Ir(phenylazole)(2)(bpy)]PF(6) (bpy=2,2'-bipyridine). All complexes were fully characterized by NMR, IR, and MS spectroscopic studies as well as by cyclic voltammetry. Three crystal structures obtained by X-ray analysis complemented the spectroscopic investigations. The excited-state lifetimes of the iridium complexes were determined and showed to be in the range of several hundred ns to multiple µs. All obtained iridium complexes were active as photosensitizers in catalytic hydrogen evolution from water in the presence of triethylamine as a sacrificial reducing agent. Applying an in situ formed iron-based water reduction catalyst derived from [HNEt(3)](+) [HFe(3)(CO)(11)](-) and tris[3,5-tris-(trifluoromethyl)-phenyl]phosphine as the ligand, [Ir(2-phenylbenz-oxazole)(2)-(bpy)]PF(6) proved to be the most efficient complex giving a quantum yield of 16% at 440 nm light irradiation.