Low-salinity water flooding by a novel hybrid of nano γ-Al2O3/SiO2 modified with a green surfactant for enhanced oil recovery.

This paper introduces a hybrid enhanced oil recovery (HEOR) method that combines a low-salinity water flooding (LSWF) and nanoparticles (NPs) stabilized with a green surfactant. We experimentally investigated the use of combinations of silica (SiO2) and gamma alumina (γ-Al2O3) nanohybrids stabilized with Gum Arabic (GA) at different water salinities. Nanofluids (NFs) were prepared by dispersing γ-Al2O3 and SiO2 NPs (0.1 wt%) in deionized water (DW), synthetic seawater (SSW), 2, 5, and 10 times diluted samples of synthetic seawater (in short 2-DSSW, 5-DSSW and 10-DSSW, respectively). The challenge is that NPs become unstable in the presence of cations in saline water. Moreover, an attempt was made to introduce NFs with high stability for a long period of time as the optimal NFs. The effects of temperature on the behaviour of optimal NFs in the presence of different base fluids, distinct mass ratios of γ-Al2O3/SiO2 and various concentrations of surfactant were analysed via interfacial tension (IFT) and viscosity measurements. The results of the viscosity measurement showed that with increasing temperature, the NPs dispersed in DW had lower viscosity than NPs dispersed in various salinities. However, the IFT measurement for NPs dispersed in different base-fluids revealed that with increasing temperature and presence of cations in saline water, IFT values decreases. Although, the minimum IFT for hybrid nanofluid (HNF) γ-Al2O3/SiO2 modified with GA and dispersed in 10-DSSW was reported 0.99 mN/m. Finally, according to the micromodel flooding results, in oil-wet conditions, the highest oil recovery for combination γ-Al2O3/SiO2 modified with GA and dispersed in 2-DSSW was reported 60.34%. It was concluded that NFs modified with GA could enhanced applicability of LSWF via delay in breakthrough time and improving sweep efficiency.

Investigation of Foam Flooding Assisted by Non-Newtonian and Novel Newtonian Viscosifying Agents for Enhanced Oil Recovery.

One of the main reasons for foam flooding enhanced oil recovery (EOR) is mobilizing oil left in the reservoir after primary recovery (depletion by pressure difference solely) and water flooding. However, expanding the infrastructure for certain foam EOR projects might be necessary as more wells are required, or a different well pattern is necessary. This study aims to study the effect of Newtonian and non-Newtonian viscosifying agents to assist foam flooding under the porous medium condition and to compare the results. Furthermore, this paper attempts to investigate the use of glycerol as a novel promising economic and ecological candidate instead of polymers. The shear rate inside the core was calculated based on the literature, which was combined with viscometric measurements in order to form four pairs of equal apparent viscosity. The differences and overlap within the core flooding experiments with foam generated by Newtonian and non-Newtonian fluids were observed by examining the mobility reduction factor under transient and steady-state conditions and by calculating the gas fraction present in the core. It was concluded that glycerol in core flood experiments could reach the same mobility reduction factor of about 1600 as polymer solutions with the same apparent viscosity, as long as the viscosity of the injected solution is reasonably low. Moreover, glycerol even reached the maximum mobility reduction factor faster than the foam generated by the polymer solution.