RESUMO
Imidazoline is a five-membered heterocycle derived by the partial reduction of one double bond of the imidazole ring. This work prepared new anion exchange membranes (AEMs) based on imidazoline quaternized polystyrene copolymers bearing N-b-hydroxyethyl oleyl imidazolinium pendent groups to evaluate the application potential for anion exchange membrane fuel cells (AEMFCs). For comparison, an imidazole quaternized polystyrene copolymer was also synthesized. The polymer chemical structure was confirmed by FTIR, NMR, and TGA. In addition, the essential properties of membranes, including ion exchange capacity (IEC), water uptake, and hydroxide conductivity, were measured. The alkaline stabilities of imidazolium-based and imidazolinium-based AEMs were compared by means of the changes in the TGA thermograms, FTIR spectra, and hydroxide conductivity during the alkaline treatment in 1 M KOH at 60 °C for 144 h. The results showed that the imidazolinium-based AEMs exhibited relatively lower hydroxide conductivity (5.77 mS/cm at 70 °C) but much better alkaline stability compared with the imidazolium-based AEM. The imidazolinium-based AEM (PSVBImn-50) retained 92% of its hydroxide conductivity after the alkaline treatment. Besides, the fuel cell performance of the imidazolium-based and imidazolinium-based AEMs was examined by single-cell tests.
RESUMO
A quaternized polybenzimidazole (PBI) membrane was synthesized by grafting a dimethylimidazolium end-capped side chain onto PBI. The organic-inorganic hybrid membrane of the quaternized PBI was prepared via a silane-induced crosslinking process with triethoxysilylpropyl dimethylimidazolium chloride. The chemical structure and membrane morphology were characterized using NMR, FTIR, TGA, SEM, EDX, AFM, SAXS, and XPS techniques. Compared with the pristine membrane of dimethylimidazolium-functionalized PBI, its hybrid membrane exhibited a lower swelling ratio, higher mechanical strength, and better oxidative stability. However, the morphology of hydrophilic/hydrophobic phase separation, which facilitates the ion transport along hydrophilic channels, only successfully developed in the pristine membrane. As a result, the hydroxide conductivity of the pristine membrane (5.02 × 10-2 S cm-1 at 80 °C) was measured higher than that of the hybrid membrane (2.22 × 10-2 S cm-1 at 80 °C). The hydroxide conductivity and tensile results suggested that both membranes had good alkaline stability in 2M KOH solution at 80 °C. Furthermore, the maximum power densities of the pristine and hybrid membranes of dimethylimidazolium-functionalized PBI reached 241 mW cm-2 and 152 mW cm-2 at 60 °C, respectively. The fuel cell performance result demonstrates that these two membranes are promising as AEMs for fuel cell applications.
