A novel surgical technique for revision anterior cruciate ligament reconstruction using an isolated rectus femoris tendon autograft.

INTRODUCTION: Only a few anatomic studies have described an isolated rectus femoris tendon autograft for anterior cruciate ligament (ACL) reconstruction. This study aims to demonstrate a new surgical technique utilising the rectus femoris tendon for ACL reconstruction. This study hypothesises that the rectus tendon autograft will yield satisfying postoperative outcomes in terms of stability, with minimal complications at the harvest site. METHODS: This retrospective study investigated the outcomes of 28 revision ACL reconstructions using a rectus tendon autograft with a mean follow-up of 41.7 (range, 24.0-64.8) months. A 3 cm longitudinal incision was used to harvest the rectus tendon with an open tendon stripper. Intraoperative collected data included the length of the tendon and thickness of a 4-fold graft. Further outcome parameters include anterior cruciate ligament stability and range of motion. Additionally, postoperative complications, especially donor site morbidity, were documented in type and frequency. RESULTS: The mean tendon length measured 32.4 cm (range, 30-35 cm). After preparing a 4-fold graft, the mean diameter was 9.2 mm (range, 8.0-10 mm) at the tibial and 9.0 mm (range, 7.5-10 mm) at the femoral end. Stability evaluated by the Lachman test improved significantly from 2 (Interquartile range (IQR), 2-3) preoperatively to 0 (IQR, 0-1) postoperatively (p < .001). Rerupture of the anterior cruciate ligament graft was observed in 2 patients (7.1%). Four patients showed a persistent extension deficit of about 5 degrees postoperatively. Two of them underwent revision surgery due to a Cyclops lesion. Only one patient complained of prolonged pain at the harvest site (3.6%). CONCLUSION: The 4-fold rectus tendon represents a novel autograft technique in revision ACL reconstruction. This study provides evidence of appropriate graft dimensions and satisfying postoperative outcomes regarding stability. The technique is associated with a low complication rate at the harvest site. STUDY DESIGN: Case series; Level of evidence, IV.

Retrograde Drilling, Ossoscopy, and Autologous Bone Grafting: An Alternative Technique for Treatment of Osteochondral Lesion of the Talus Stage 2 and 3 in Adults.

BACKGROUND: Symptomatic osteochondral lesions of the talus (OLTs) often require surgical intervention. There are various surgical methods. A generally valid, stage-dependent therapeutic algorithm does not exist. The aim of our study is to show long- term results of an alternative technique that combines retrograde drilling, debridement performed under arthroscopic visualization, and autologous bone grafting. METHODS: The surgical technique was performed in 24 patients with medial or lateral OLTs, and the data were analyzed retrospectively. In our technique, the affected subchondral bone was overdrilled retrogradely and resected under arthroscopic visualization (ossoscopy) without violating the cartilage. The resulting defect was filled with autologous bone from the medial tibia metaphysis. Outcome parameters were the numeric rating scale (NRS), the American Orthopaedic Foot & Ankle Society (AOFAS) ankle-hindfoot score, and range of motion (ROM). The Magnetic Resonance Observation of Cartilage Repair Tissue (MOCART) score was assessed and a possible correlation with the clinical outcome scores was calculated. Data concerning complication rates were also collected. RESULTS: The mean surface size of the OLTs was 0.9 ± 0.3 cm2. The mean follow-up was 89 months. The AOFAS score improved significantly from 57.7 points preoperatively to 88.8 points at the final follow-up (P < .0001). The pain value measured by the NRS decreased significantly from 8 to a pain level of 2. ROM improved in 37.5% of the patients for dorsiflexion and 29.2% for plantarflexion. There were no significant correlations between the MOCART score and the AOFAS score or the pain value on NRS. CONCLUSION: Retrograde drilling, ossoscopy, and autologous bone grafting for OLTs is a promising technique with good long-term results. The patients' satisfaction rate, especially in OLT stages 2 and 3, was excellent. LEVEL OF EVIDENCE: Level IV, case series.

The Application of an Allogenic Bone Screw for Stabilization of a Modified Chevron Osteotomy: A Prospective Analysis.

Background: Distal first metatarsal osteotomies are commonly performed operative procedures for hallux valgus deformity, and usually involve fixation with a metal screw. However, various bioabsorbable osteosynthesis materials have been in use for a number of years. One recent innovation is the Shark Screw®, a human cortical bone allograft. This study aimed to evaluate the efficacy and safety of this allogeneic screw in the stabilization of Reversed L-Shaped osteotomy, a modified Chevron osteotomy. Methods: In a prospective study, 15 patients underwent a Reversed L-Shaped osteotomy stabilized with the allogenic bone screw Radiological data on osteointegration of the screw and correction of the intermetatarsal angle were recorded. Furthermore, each follow-up examination included the collection of clinical data, the American Orthopedic Foot and Ankle Society (AOFAS) score, evaluation of pain level, and patient's overall satisfaction. Results: Full osseous fusion of the osteotomy was seen in all patients. The bone screws were radiographically integrated after approximately 6.5 (±2.6) months. Neither nonunion nor failure occurred in any of our cases. Furthermore, we did not find any potential graft reaction. The AOFAS score improved significantly from 51.6 (±15.2) points to 90.9 (±10.3) (p < 0.001). The preoperative hallux valgus angle and intermetatarsal angle decreased significantly from 24.8 (±4.9) degrees to 7.2 (±4.4) degrees (p < 0.001) and 12.6 (±3.2) degrees to 4.8 (±1.3) degrees (p < 0.001), respectively. Conclusions: With this study, we demonstrated the efficiency of the allogenic bone screw (Shark Screw®) in regard to clinical and radiological short-term outcomes.